INSTALLATION
1. Remove any excess packing from the fixture.
2. This fixture is designed to be mounted directly to the junction boxes (supplied by customer).
3. Open the housing assembly by loosening the two screws on the right of the fixture.
4. Take off LED mounting plate (item 1) in Figure 1 by removing 4 screws circled in red in Figure 1. Screws
are Located on the center of the LED mounting plate.
5. Knock out appropriate knock outs to mount to junction box. Knock outs (item 1) are circled in Figure 2.
6. Line up the back of the housing in desired location, completely covering junction box and mount securely to
the wall with the wall anchors. Attach fixture with two supplied screws.
7. Complete the wiring to the power source and ground. The Black as Line; White as Common; Bare/Green as
Ground. Wire connections to be made inside of housing.
8. Reassemble the housing by reattaching LED mounting plate and close the fixture back up.
9. Outdoor wall fixtures must be caulked with a suitable waterproof sealant across the top, and at least "half
way" down each side of the fixture to properly seal it to the mounting surface. A small space should be open
at the bottom for excess moisture runoff.
MAINTENANCE
DO NOT use cleansers containing bleach.
The metal portion of the fixture can be wiped clean as needed using a mild soap solution.
ATTENTION: Avoid moving any exposed wires. If any wires are accidentally disconnected, call a
professional to repair.
NOTE: Verify the mounting hole dimensions before installing the fixture.
NOTE: Consult 76167 for Emergency Battery Caddy Square.
NOTICE:
Failure to properly caulk around perimeter of the mounting plate or pan on an
outdoor fixture when mounted to a wall or ceiling, could lead to water and /or
electrical damage and is not covered under the warranty.
