EDOC00006 - Compact NA RFID Freezer User Manual, rev 8 10
Installation
Inspection
With packaging in place, inspect the freezer for any damage that may have
occurred during transit. If any damage is present, please contact Terso
Technical Support at +1 (888) 376-0257 in the US or +49 621 8501 233 in
Europe.
Unpacking
Cut the banding and remove all packaging. Gently position the freezer in
place on the ground. Check for any rocking and adjust feet as necessary.
Once level, ensure all feet are in solid contact with the ground.
Remove accessories from inside the freezer. Items included are a
Power Cable and Ethernet Cable. Other items may also be included
such as an Ethernet Hub or other freezer specific items.
Proper Handling
Move the freezer to the installation site. There are two rollers on the back of
the freezer to aid in positioning. Roll the freezer by firmly pushing on the upper
section of the body. Always move the freezer with the door facing you.
Carefully roll the freezer into position leaving at least a 3”/76mm gap between
the freezer and the wall.
Connecting AC Power
Plug the square end of the power cord into rear panel of the device; plug the
other end into a grounded wall outlet with a minimum of a 10-amp rating.
The power outlet must be within 3m / 6ft of the freezer and must be easily
accessible.
Outlets on the back of the device as well as the power cord supplied are
installed specifically for each country of deployment. See the Specifications
section of this document for supported countries.
Connecting Communications
Plug the Ethernet cable into the rear panel and then into the appropriate wall
data jack.
Access Verification
Present a pass below the LCD screen on the front panel. The LCD text should
indicate that the door is now unlocked. The door can be closed at any time and
will be locked upon doing so. This can be verified by gently pulling on the door
handle.
