OFR1K10 1000W Oil Filled Radiator User Manual OFR1K10 1000W Oil Filled Radiator User Manual OFR1K10 1000W Oil Filled Radiator User Manual
SAFETY GUIDE - PLEASE READ CAREFULLY
Please follow all the safety precautions listed•
below for safety and to reduce the risk of
injury or electrical shock.
Read all the instructions carefully before•
using this appliance and keep them for future
reference.
Retain the manual. If you pass the product•
on to a third party, make sure to include this
manual.
Unplug the appliance from the mains supply•
when not in use, or before cleaning any part
of the appliance.
This appliance is for household use only.•
Do not use outdoors or in damp or wet•
conditions.
Do not immerse the appliance or the electrical•
cord or plug in liquids.
Do not use the appliance near a re, oven or•
other source of heat.
Place the appliance on a stable and at•
surface where there is no risk of it tipping over
or being knocked over.
Ensure that there is enough space for the•
heater while operating. There should be at
least 20 cm clearance around the heater and
1 m above the heater.
DO NOT place the appliance immediately•
below an electrical socket or other appliance.
Do not use the heater in front of or close to an•
open window. Rain may create an electrical
hazard.
Keep ammable and explosive objects away•
from the heater.
DO NOT hang the appliance on a wall,•
furniture, etc.
DO NOT use the heater in the immediate•
surroundings of a bath, a shower or a
swimming pool.
DO NOT place the appliance close to children•
or pets. Never let children operate this
appliance. Close supervision is necessary
when this appliance is used near children.
This appliance is not intended for use by•
persons (including children) with reduced
physical, sensory or mental capabilities,
or lack of experience and knowledge,
unless they have been given supervision or
instruction concerning use of the appliance
by a person responsible for their safety.
Children should be supervised to ensure•
that they do not play with the appliance.
When unplugging the power cord, hold the•
plug top, not the power cord.
Store the appliance away from direct•
sunlight and out of the reach of children.
Do not cover the heater or use it to dry•
laundry or towels.
Never insert any objects into the spaces•
between the heater bars.
Do not place soft objects or fabrics over or•
in close proximity to the heater or otherwise
obstruct the inlet or outlet.
There are no user serviceable parts in your•
appliance. Unauthorised dismantling or
servicing will void the product warranty.
Do not operate the appliance with a•
damaged cord or plug or after the appliance
or any component has been damaged.
Send the heater to a suitably qualied or
appointed service agent for inspection and
repair.
Do not use the appliance for any purpose•
not expressly specied in this manual.
THIS APPLIANCE MUST BE ATTENDED AT ALL•
TIMES WHEN IT IS SWITCHED ON
SPECIAL INSTRUCTIONS
This heater is lled with a precise quantity of
special oil.
Repairs requiring opening of the oil container
are only to be made by the manufacturer or
an appointed service agent who should be
contacted if there is an oil leak.
Regulations concerning the disposal of oil when
scrapping the appliance have to be followed.
PREPARATIONS FOR USE
Remove all exterior packaging from the heater.
If you dispose of any packaging please do so
according to any recycling regulations.
FITTING THE CASTERS
The casters are mounted on a plate, each with a
xing kit of a U-bolt and a wing nut.
CAUTION: It is essential that the casters
are tted before using the heater to
ensure that the appliance is stable and
that adequate clearance is available for
air to ow over the radiator bars.
Prepare a work surface by placing a blanket or1.
similar protection on a table at a convenient
working height.
Lay the radiator on its side so that the base of2.
the radiator hangs over the table end.
Slide the U-bolt through the slot between the3.
end two radiator bars. Position the hooked
end as shown below, ready to engage in the
hole in the caster plate.
CONTROLS AND FEATURES
Handle1.
Temperature control2.
Power selector switches3.
Mains lead storage4.
Mains lead5.
Radiator heated bars6.
Casters7.
Engage the hooked end of the U-bolt through4.
the caster plate.
Rotate the U-bolt so that the threaded end5.
passes through the other hole in the caster
plate.
Lock the caster plate to the radiator with a6.
wing nut.
c
d
e
f
g
Fit the second caster plate in the same way.7.
Your heater is now ready to use. Carefully lift the
heater down to stand on the casters.
Caster plate x 2
U-bolt x 2
Wing nut x 2
CASTER FIXINGS
TILT SWITCH
This appliance includes a tilt switch as a safety
feature. If the appliance is not placed on a at,
level surface, the tilt switch will switch o the
appliance.
ELECTRICAL INFORMATION
Before using this appliance ensure that the voltage
of your electricity supply is the same as that
indicated on the rating plate of the appliance.
