SAFETY INSTRUCTIONS
Carefully read this manual before using this product. Make sure that you know how the wireless
speaker system functions and how to operate it. Maintain the wireless speaker system in accordance
with the instructions to ensure that it functions properly. Keep this manual with the equipment. If the
equipment is to be used by a third party, this instruction manual must be supplied with it. The safety
instructions, by themselves, do not eliminate danger completely, and proper accident prevention
measures must always be used.
BEFORE INITIAL USE
Remove all packaging. Carefully wipe the outer case with a soft damp cloth and dry it afterwards
with a dry towel. For safety do not immerse the wireless speaker system in water or any other liquid.
Check for any damage that may have occurred during transit. Do not use if the wireless speaker
system is damaged in any way. Immediately return to supplier for replacement or repair.
OPERATION
This wireless stereo speaker system has been designed for general home use only. It is not designed
for commercial or industrial use.
Initial Set up
Place the transmitter near a suitable audio supply, such as a TV, Stereo, or Portable CD Player etc.
Assemble the transmitter antenna on the transmitter. Feed the transmitter wire into the antenna
sleeve provided and secure the antenna into place on the by inserting it firmly into the aerial wire
hole.
Unwind the 12VDC 200mA AC power pack lead fully and plug the AC power pack into a suitable
mains supply socket, 230-240V. Plug this AC power pack supply plug into the DC input socket at
the rear of the transmitter unit and ensure that when power is supplied that the power LED indicator
on the front of the transmitter is illuminated.
2
Place the Wireless Speakers in the desired location. Plug the 12VDC 500mA AC power packs supplied for each
into a suitable mains supply socket, 230-240V. Plug the AC power pack supply plug into the DC input socket at
the rear of each speaker. Alternatively you may use 6 x 1.5V batteries in each speaker if desired.
Connect the transmitter audio input lead into a suitable audio output jack (use one of the supplied adaptors if
required). Set the volume level on the audio source to a low level at first and begin to play music from the audio
source. (EG: CD player, Radio and TV etc…).
Turn on the speakers one at a time and adjust the tune control until a clear signal is received. Turn the first
speaker off temporarily if required in order to hear the second speaker more clearly.
Set the individual volume of the speakers to the desired levels and then use the audio source as the master
volume controller to raise or lower the volume levels as desired.
Turn off the audio source, transmitter and speakers after use. Disconnect from power supply when not in use.
ELECTRICAL SAFETY
When using electric equipment always observe safety regulations where applicable to reduce the risk of fire,
electric shock and personal injury.
Always check that the power supply corresponds to the voltage on the rating plate.
Supply cord and plug.
Always fully unwind any cord to avoid overheating. Never allow any supply cord to come in contact with hot
objects. Do not carry the equipment by the cord. Disconnect by first switching off the mains outlet, grasping the
adaptor and pulling it out gently.
If the adaptor or adaptor supply cord is damaged, it must be replaced by the manufacturer, its service agent or a
similarly qualified person in order to avoid a hazard. Only use authorised replacement parts.
Children.
Caution. Keep out of reach of children.
This wireless speaker system is not intended for use by young children or infirm persons without supervision.
Young children must be supervised to ensure that they do not play with the equipment..
3
