STORE IDLE EQUIPMENT
When not in use, the machine should be stored in a dry location with no access to direct sunlight. Keep the
machine away from children and others not qualified to use it.
PREPARATION
▪
Thoroughly inspect the area where the equipment is to be used and remove all objects which can be
thrown by the machine.
▪
Before using, always visually inspect to see that the blades, blade bolts and cutter assembly are not
worn or damaged. Replace worn or damaged blades and bolts in sets to preserve balance.
▪
Only use accessories approved by the manufacturer (if applicable).
▪
Do not operate the machine while under the influence of alcohol or drugs.
▪
Never operate the machine in wet grass or conditions. This could cause you to slip while using.
ELECTRICAL SAFETY
▪
Power plugs must match the outlet. Never modify the plug in any way. Do not use any adapter plugs
with earthed (grounded) power tools. Unmodified plugs and matching outlets will reduce risk of
electric shock.
▪
Avoid unintentional starting. Always check that the switch is in the Off position before plugging in the
product to the power supply. Do not carry a plugged-in product with your finger on the switch.
▪
Avoid body contact with earthed or grounded surfaces, such as pipes, radiators, ranges and
refrigerators. There is an increased risk of electric shock if your body is earthed or grounded.
▪
Do not expose the product to rain or wet conditions.
▪
Water entering an appliance will increase the risk of electric shock.
▪
Electrical power should be supplied via a residual current device (RCD) with a tripping current of not
more than 30 mA.
▪
Before use, check the supply and power cable for signs of damage or aging. If the power cable
becomes damaged during use, disconnect it from the supply immediately. Do not touch the power
cable before disconnecting the supply. Do not use the product if the power cable is damaged or worn.
▪
If you need to use an extension cable, ensure it is suitable for outdoor use and has a current capacity
rating, sufficient to supply your product. Check it before every use for damage, always uncoil it
completely during use because coiled cables can overheat. Damaged extension cables should not be
repaired; they should be replaced with an equivalent type.
▪
Make sure the power cable is positioned so that it cannot be damaged by the cutting blade & will not
be stepped on, tripped over or otherwise subjected to damage or stress.
▪
Never pick up or carry the product by the power cable.
▪
Never pull by the power cable to disconnect from the power supply.
▪
Keep the power cable away from heat, oil and sharp edges.
▪
Make sure voltage is correct for your product. A nameplate on the product indicates the product’s
voltage. Never connect the product to an AC voltage that differs from this voltage.
▪
Always ensure the power cable from the handlebar to the body is never trapped, pinched or otherwise
damaged during assembly or operation. Never apply power to the machine if this power cable is
damaged. Return to authorised service centre for professional repair.
OPERATION
▪
Only operate the machine in daylight or in good artificial light.
▪
Avoid operating the equipment in wet grass.
▪
Always be sure of your footing on slopes. Exercise extreme caution when changing direction on slopes.
Do not mow excessively steep slopes, which exceed 15°.
▪
Never run while using the machine, always walk.
▪
Use extreme caution when reversing or pulling the product towards you.
▪
Stop the blade(s) if the machine must be transported to & from the area to be machined.
▪
Never operate the product with defective guards, or without safety devices, for example deflectors in
place.
