ThePondguy MagFlo Mini 210 Bedienungsanleitung

MagFlo Mini

210 Pump

Product Manual

Important Information........................2

Technical Specs ...............................2

Package Contents.............................3

Installing Your MagFlo Mini Pump ............ 4-5

Maintaining Your MagFlo Mini Pump.......... 5-6

Troubleshooting..............................6

Warranty Information.........................8

Table of Contents:

For Model:

THANK YOU FOR CHOOSING:

• MagFlo Mini 210

(Item #120820)

IMPORTANT INFORMATION:

Please read these instructions thoroughly before use. Failure to follow instructions may result in

equipment damage or failure, losses, injury or death.

DANGER:

To avoid possible electric shock:

• If the power cord has been damaged, DO NOT operate, the MagFlo Mini Pump should be replaced.

• Close supervision is necessary when the unit is used by or near children.

WARNING:

To reduce the risk of electric shock:

• Connect only to a properly grounded receptacle, which is serviced by a Ground Fault Circuit

Interrupter and never remove the ground pin from the plug.

• Provide a “drip loop” for the power cord. This is a loop in the cord below

the level of the receptacle or plug that prevents water from traveling

along the cord in the direction of the receptacle.

• ALWAYS unplug the MagFlo Mini Pump from power source when it is

not in use, and before installing, removing or servicing the MagFlo Mini

Pump components.

• If an extension cord is necessary, a cord 14 gauge up to 100 ft. must be

used. A cord may overheat if the cord is rated for less amperes or watts

than the unit rating.

• DO NOT immerse the MagFlo Mini Pump plug in water or attempt to

use a wet plug.

• The MagFlo Mini Pump is NOT suitable for use in swimming pools, swimming ponds, or other

situations where bodily contact is made with the water.

CAUTION:

To reduce the risk of equipment damage or failure:

• This pump has been evaluated for use with fresh water only.

• DO NOT place MagFlo Mini Pump near ammable or other dangerous materials or objects.

• ALWAYS unplug the unit if there is no water running through it to prevent over heating.

• ALWAYS operate the pump completely submerged for proper cooling.

• DO NOT operate during freezing conditions. Drain MagFlo Mini Pump and store in a protected

location.

IMPORTANT:

The Pond Guy is not responsible for equipment damage or failure, losses, injury or death resulting from

failure to follow safety precautions, misuse or abuse of equipment.

Power Cord

Drip Loop

TECHNICALSPECS :

MODEL VOLTAGE WATTAGE CORD GPH @ 3’ HEAD MAX HEAD INLET FITTING

MagFlo Mini 120V / 60 Hz 14 Watts 6’ 197 GPH 5’ 1” ⁄”& ½”Slip

thepondguy.com | 866-POND-HELP (766-3435)

Package Contents

MAGFLO MINI PUMP:

MagFlo Mini Pump

A½”Slip Adaptor

BMagFlo Mini 210 Pump

C⁄”Slip Adaptor

15425 Chets Way | Armada, MI 48005 3

For Best Results

• MagFlo Mini Pump should be placed on a

at surface away from sludge or

algae mats.

• Keep MagFlo Mini Pump pre-lter free of

debris.

• DO NOT operate during freezing

conditions. Drain the MagFlo Mini Pump

and store in a protected area.

INSTALLING YOUR MAGFLO MINI PUMP:

Step 1

Connect Plumbing

Connect plumbing to Mago Mini. A hose clamp (not

included) may be used but is not required when using

appropriate vinyl tubing.

Step 2

Submerge Pump

Submerge the MagFlo Mini Pump in a at area in your

pond. For ideal water circulation, place at the opposite

end of the pond from where the water will discharge.

Step 3

Connect Feature

Connect opposite end of tubing to your spitter/feature.

Step 4

Plug in Pump

Plug the power cord into a standard 120-volt GFCI

protected outlet.

thepondguy.com | 866-POND-HELP (766-3435)

INSTALLING YOUR MAGFLO MINI PUMP:

MAINTAINING YOUR MAGFLO MINI PUMP:

WARNING:

Before performing any maintenance, always unplug the MagFlo Mini Pump

from the power source.

CLEANINGTHEPUMP

Tools Required: • Damp Cloth or Small Brush

• Descaler such as Airmax©D-Scale™

Step 1

Unplug and Remove

Unplug the pump and move to a dry area.

Perform maintenance anytime there is a reduction in water ow or

before being stored for the winter.

Step 5

Adjust Flow

Water ow may be adjusted using the dial on the front

of the MagFlo Mini Pump.

Step 2

Remove Pre-Filter

Pull rmly to remove the pump pre-lter from the

pump motor.

15425 Chets Way | Armada, MI 48005 5

MAINTAINING YOUR MAGFLO MINI PUMP:

Step 3

Remove Impeller

Remove the impeller cover by turning counter-

clockwise and then pull to separate. Then remove the

impeller.

Step 4

Clean Impeller

Clean impeller and impeller chamber with water. A

small brush and descaler may be helpful.

Step 5

Reassemble Pump

Reassemble impeller, impeller cover and pump pre-

lter.

TROUBLESHOOTING :

Pump does not turn on:

• Check that the power cord is connected.

• Check to see if the circuit breaker is tripped.

• GFCI may be faulty.

• Check power cord for damage.

Pump turns on and then shuts o:

• Verify pump is completely submerged for proper cooling.

• Check for debris clogging the pump intake.

• If using an extension cord, verify that it is of the proper rating for the pump’s electrical

requirements.

Reduced water ow:

• Check for debris clogging the pump pre-lter.

• Perform maintenance cleaning of the pump.

• Verify that water level is not low.

• Check plumbing for clogs.

• Verify the water ow dial on the front of the pump is set correctly.

thepondguy.com | 866-POND-HELP (766-3435)

NOTES:

15425 Chets Way | Armada, MI 48005 7

View other great products on-line at www.thepondguy.com

PRODUCT WARRANTY:

The MagFlo Mini 210 Pump carries a 1-year warranty.

The Pond Guy will repair or replace any unit found to be

defective. This limited warranty is extended exclusively

to the original purchaser and begins from the date of

original purchase receipt. Abuse or misuse of this product

or power cord alterations void all warranty. Impellers are

wear items and are not covered under warranty. Please

call for a RMA number prior to returning product by

calling our Customer Care Department at 866-766-3435.

Failure to request an RMA number may result in delay or

dismissal of your warranty claim.

THANK YOU FOR CHOOSING:

The Pond Guy®Inc.

We Know Ponds™

15425 Chets Way

Armada, MI 48005

866-POND-HELP (766-3435)

thepondguy.com

0065_12 V2

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere ThePondguy Teichpumpe Handbücher

ThePondguy

ThePondguy MagFlo Series Bedienungsanleitung

Beliebte Teichpumpe Handbücher anderer Marken

Oase

Oase PondJet Eco Bedienungsanleitung

Profi-pumpe

Profi-pumpe Rügen Bedienungsanleitung

HEISSNER

HEISSNER F540-00 Bedienungsanleitung

1A Profi Handels

1A Profi Handels OASIS 501R-1 Bedienungsanleitung

Biotop Garden

Biotop Garden D0060 Bedienungsanleitung

Profi-pumpe

Profi-pumpe JR-800LV Bedienungsanleitung

Sealey

Sealey WPP1100 Bedienungsanleitung

Pontec

Pontec PondoMax Eco 1500 Bedienungsanleitung

TIP

TIP WP 500-10 R Bedienungsanleitung

esotec

esotec Siena LED Bedienungsanleitung

Danner

Danner Pondmaster 1250 Bedienungsanleitung

Pond Boss

Pond Boss 52354 Bedienungsanleitung

TeichTip

TeichTip Sunsun Bio Pond Filter Set Bedienungsanleitung

Hozelock Cyprio

Hozelock Cyprio Cascade 5500 Bedienungsanleitung

Hozelock Cyprio

Hozelock Cyprio Aquaforce Series Bedienungsanleitung

HEISSNER

HEISSNER SPF 150-00 Bedienungsanleitung

AquaScape

AquaScape AQUAFORCE 4000-8000 Gebrauchsanweisung

Messner

Messner system-X 1501 Bedienungsanleitung