08. Service and cleaning
Maintenance of the boiler is easy fast.At the bottom of the boiler there is a
special drawer for the export of the ash. The amount of ash generated by the
use of the boiler and the type of wood used. It’s type of wood leaves different
residue during the combustion for this reason there is an exclusion in the
calculation of the ash.
Steel solid fuel BM needs cleaning about once in 25 days :
Page 07
1.First check for any fume leak that may exist in the installation of the boiler. This is
very important so it is good to be really careful.
2.Check boiler's door to be very well closed in case of fume leak.
3.Clean very well the oil that can be found outside the oil tank
4.Be sure that you close really well the top of the oil tank before the operation of the
boiler.
5.Check if the spark and the combustion are right (from the flame checkpoint) only
for oil use.
6. Check regularly for oil leaks in the oil tank or in the pipes
6.1Often clearing out the water from the oil tank, this helps for the right
operation of the boiler (avoiding unpleasant complications)
Cleaning of the oil filter
6.2In case, the oil filter needs to get clear, you should close the oil supply from
the provider valve.
6.3Clean very good the oil filter and the inside part where the filter lay with light
oil or oil.
Cleaning the oil tank
6.4 It is possible to gather some quantity of water in the oil tank or in the oil
supply pipe, especially after a long time without clearing them. In this situation
open the clear up valve of the tank and let the water to run out of it until oil
start to run out.
ΨRegular check
1.Take away the flammable materials from the boiler's room.
2.Keep the boiler and the parts around it, clean.
3.Often check for gas or oil leaking.
4.Check the connections of the chimney pipe and look if they are fixed correct
and if there is any fume's leaking.
5.Check if there is any water leaking in the boiler or in the pipes.
07. Necessary check
Steel boiler series BM oil-gas
09. BM boiler operates with oil-oil use
