2
MAINTENANCE
After use, service the hoist before storing it.
Servicing and repairs should only be carried out by qualified, competent ,
and responsible people.
(a) Clean the hoist thoroughly.
(b) Keep the hoist well-lubricated. Oil the load chain and hook shank.
(c) Store the hoist correctly against rain and moisture.
hen the hoist is installed outdoors, exceptional care should be taken regarding
maintenance.
3
INSPECTION
Frequent Inspections:
Visual Inspection by operator or other authorized person, and listening (while hoist
operates) for unusual sounds which may indicate trouble.
Exception:
Brakes require more than audio-visual
inspection. Check
frequently
by
operating
hoist, with and without load, stopping at various positions to test holding power and
observe amount of drift, if any.
To Adjust Brake:(See Fig.1)
A. Fully-tightened position.
B. Slack off slightly form Position A, and insert the cutter pin.
※Replace brake disc if thickness is less than 0.08 inch.
FIGURE 1
4
ALIGNMENT OF GEARS URING REASSEMBLY
●
Model No.: CB-10
Notice the marks " 0 " on the gears, place " 0 " mark face
to sheave on horizontal centerline on right side , place the
other" 0 " mark face to up direction on vertical centerline
on left side as shown. (Figure 2)
FIGURE 2
