Tiger Lily Products TLP, Blinder, Bel, Escort, Valentine
PO Box 549 Tel303-678-9101 Cel: 720-635-3931
Niwot, CO, USA 80544 Fax 303-678-9103 Cel: 720-298-0557
Email F.John.Turner@TigerLilyProducts.com
WEB www.1stRadarDetectors.com
Rated #1, 360 Degree, High Performance, PRS1-STi-360™Prowler Remote™System
PROWLER Remote, PRS1-STi-360, PRS1-V-360, PRS2-V, PRS2-STi, PRS3-V, PRS3-STi, PRS4-V, PRS4-STi, Got Performance are trademarks of Tiger Lily Products. All rights reserved. Copyright 1999-2008.
Got Performance™
High Performance
Radar, Laser & Photo
Countermeasures
5) Ensure cables are routed with existing cable bundles and tie wrap the Blinder cables in position. Ensure no contact across hot
surfaces. Connect red lead, to a spare 12Vdc connection in Ignition fuse box. Connect Fuse and Master Power On/off as shown
using hardware provided in box. Connect ground black lead of interface module to vehicle ground inside the cab.
6) The BlueWire is a radio mute wire and should only be installed by a professional installer or you could damage your radio.
7) Plug Buzzer and LED Alert into appropriate Alert phone plug of the interface module and connect the Buzzer/LED at a location
that suits your driving habits (perhaps above the windshield visor, or in the dash, or in the center console).
8) Once proper install & electrical hookup is completed, turn Blinder power on. The Blinder™will go through selftest, &beep once
for 1 second to indicate it is in testmode, and beep a 2nd timeafter about 60 seconds. During the 1st and 2nd beep, you can use your
TV Remote to test the laser modules by aimingthe TV Remote at the detector of the module (may be on left or right side of each
laser module, depending how installed) and select channel up or down. This can only be done during the 1st 15- 60 seconds, at
which time the 2nd beep occurs, the Blinder goes into normal search and jam, active mode. The LED will be green with power on,
and when jamming, will turn red. Turn Blinder power off, then on again, if more time to self test is required.
CUSTOMER MAINTENANCE: The Blinder™M25 & M45 lens should be cleaned with a clean, soft cotton fabric as often as required
to remove dust, mud, etc. Do not scratch the lens in your effort to clean it. Performance is degraded if the lens is muddy or covered by
heavy dust. Rock damage, dust and mud can decrease performance.
OPERATION: When the Blinder™M25 & M45 is turned on, it will go through a self test cycle (see #8 above) and beep once for about 2
seconds to let the driver know it is fully functional and in active mode of operation. When the Blinder™detects laser, it immediately
analyzes the laser gun signal and jams it before the laser guncan display your speed. The Blinder provides anaudio alert to the buzzer and
the LED changes from green to red. When alerted, the driver should safely check their speed over a period of 2-3 seconds, then shut
jamming power off after your speed has been safely adjusted. This allows the laser gun to detect your speed after you have adjusted your
speed. After driving through the laser trap, turn the Blinder™back on, continue your journeysafely. Drive alert! Drive smart! Drive safe!
DISCLAIMER: The customer is 100% responsible for his/her drivinghabits under any/all situations when using the Blinder™. Damage
to property or person due to negligence of any person(s) using theBlinder™is not the responsibility of Tiger Lily Products or its certified
Distributors. Tiger Lily Products, nor any of its Distributors condone speeding or unsafe driving.
Warranty: The Blinder™M25 Dual & M45 Quad Laser Jammer is warranted against defects in material/workmanship for 12 months
from purchase date, but does not include road damage caused by rock damage, improper install, incorrect wiring, misuse, wear, etc.
Plug and Play Cables included in both products
