Tiger SF-2200 Bedienungsanleitung
Brake Winch Operating Instructions
Model: SF-2200
WARNING: BEFORE USING THE WINCH, READ CAREFULLY
THIS MANUAL AND KEEP IT FOR FUTURE NEEDS.
(A) SPECIFICATIONS
Capacity
(lbs / kg)
Hand force
required(kg)
Gear ratio
Hub Diameter
(mm)
Handle length
(mm)
Unit weight
(kg)
Cable diameter
(mm/inch)
Cable storage
cap (m)
2200 / 1000
10 22 2 : 1
Ø
80 300 16
Ø
8 0 /
Ø
5/16
25
(B) FEATURES
A high quality, multi-purpose winch SF-2200 adopt ratchet-type handle design The ratchet
handle permits reciprocating handle movement in both directions for lifting and lowering
loads and accommodates installation in cramped locations such as wall and floor
Automatic brake the ensures suspension of the load
(C) USE
Lifting of the load must happen by set cha
nge lever in UP position then rotating the handle
clock-
wise or operate handle back and forth to move load in up direction When releasing
the handle, the load remains suspended The descent of the load must happen by set change
lever in DOWN position then rotating the handle counterclock-
wise or operate handle back
and forth to move load in down direction
(D) IMPORTANT SAFETY INFORMATION
●
This winch is not used to transport people or for loads over areas where people could
be present
●
Never apply load on winch with cable fully extended Keep at least three full turns of
cable on the reel
●
Operate with hand power and with crank included in the equipment only This winch
should not be operated with a motor of any kind If the winch cannot be cranked easily
with one hand, it is probably over-loaded
(E) NOTE
The winch finish can be protected and will provide longer service if it is periodically washed
with water and then wiped with light oil or wax
(F) LUBRICATION
The gear box of this winch has been fully lubricated and sealed with gear cover at the factory
It is not necessary to grease gears after use
(G) CAUTION
Do not oil or grease brake mechanism
(H) FIXING OF THE ROPE TO THE DRUM
(I) EXPLODED IEW & PARTS LIST
REF NO
PART NO
PART NAME Q'TY
REF NO
PART NO
PART NAME Q'TY
1 S-1 Handle Assembly 1 13 S-13 Nut 2
2 S-2 Grip Assembly 1 14 S-14 Washer 2
3 S-3 Screw 4 15 S-15 Strength Bolt 1
4 S-4 Brake Cover 1 16 S-16 Brake Back-up Plate 1
5 S-5 Pawl 1 17 S-17 Friction Disc 2
6 S-6 Pawl Spring 1 18 S-18 Ratchet Gear 1
7 S-7 Screw 1 19 S-19 Pressure Washer 1
8 S-8 Gear Cover 1 20 S-20 Pinion Shaft 1
9 S-9 Load Gear 1 21 S-21 Pinion Gear 1
10 S-10 Side Plate I Assembly 1 22 S-22 Winch Base 1
11 S-11 Reel Cover 2 23 S-23 Side Plate II Assembly 1
12 S-12 Winch Reel 1 24 S-24 Wire Anchoring Device 1
P S When ordering replacement parts, please specify Model No , Part No & Quantity
Andere Tiger Winde Handbücher
