Toa SR-F3 Bedienungsanleitung

Please follow the instructions in this manual to obtain the optimum results from this unit.

We also recommend that you keep this manual handy for future reference.

SR-F3/SR-L3

SPEAKER SYSTEM

INSTRUCTION MANUAL

1. SAFETY PRECAUTIONS

• Be sure to read the instructions in this section carefully

before use.

• Make sure to observe the instructions in this manual as

the conventions of safety symbols and messages

regarded as very important precautions are included.

• We also recommend you keep this instruction manual

handy for future reference.

Safety Symbol and Message Conventions

Safety symbols and messages described below are used

in this manual to prevent bodily injury and property

damage which could result from mishandling. Before

operating your product, read this manual first so you are

thoroughly aware of the potential safety hazards as well as

understand the safety symbols and messages.

WARNING Indicates a potentially hazardous

situation which, if mishandled, could result in death or

serious personal injury.

CAUTION Indicates a potentially hazardous

situation which, if mishandled, could result in moderate

or minor personal injury, and/or property damage.

When Installing the Unit

• Install the unit only in a location that can structurally

support the weight of the unit and the mounting bracket.

Doing otherwise may result in the speaker falling down

and causing personal injury and/or property damage.

• Flying Precautions (SR-F3 only)

Be sure to follow the instructions below. The suspension

wires or belts may be off or snap and the speaker may

fall, causing personal injuries.

·Check to confirm that the suspension wires and belts

are strong enough to withstand the speaker load.

·The connectors of the suspension wires and belts must

be securely linked with those of the speaker.

·All parts and components (such as enclosures, metal

pieces, and screws) must be free from any

deformation, crack, and corrosion.

WARNING

167 149

354

5151

533

990

652

542

1082

20°

652

The side as viewed from

the direction of arrow A

[SR-F3][SR-L3]

Unit: mm

When Installing the Unit

•Install a speaker only in stable locations, and make

appropriate arrangements to prevent it from falling down

or rolling cross the floor. If it falls down or moves, this

may cause personal injury and/or property damage.

•When unpacking or moving a heavy speaker, be sure to

handle the unit with two or more persons. Falling or

dropping the speaker may cause personal injury and/or

property damage.

When the Unit is in Use

•Do not stand or sit on, nor hang down from the speaker

as this may cause it to fall down or drop, resulting in

personal injury and/or property damage.

•Do not operate the speaker for an extended period of

time with the sound distorting. This is an indication of a

malfunction, which in turn can cause heat to generate

and result in a fire.

2. FEATURES

•The SR-F3 is a two-way full-range dual-amp-driven speaker system, and the SR-L3 is a sub-woofer system. Both

systems feature a high power handling capacity, high sound quality, and heavy-duty construction suited to both mobile

and permanent installation applications.

•Both speaker systems are designed to be used in conjunction with the dedicated controller.

•The SR-F3 houses a constant directivity (CD) horn that assures a uniform sound dispersion pattern of 60°horizontal by

30°vertical.

•The SR-F3 is equipped with a front-loaded horn with two 30 cm woofers.

•The SR-L3 employs two 46 cm woofers with a long voice coil.

•The SR-F3 has flying hardware (Aeroquip's ring/stud pan fitting) on both the top and the bottom, and an M16 nut on the

sides for attachment of an eye bolt.

•A light-weight, strong coniferous plywood enclosure is finished with extremely-durable epoxy paint.

•Input connectors are Nuetrik's NL4MPR and screw terminals. The SR-F3 is equipped with two Nuetrik connectors to

facilitate parallel connection.

•A woofer baffle is designed to permit easy woofer replacement without having to lay the speaker.

3. INPUT CONNECTORS

Each speaker's input connectors are as follows. Connections can be made from any connector because all connectors are

internally connected in parallel to each other.

Screw terminal

Neutrik NL4MPR

connector

HIGH LOW

Right

Left

[SR-F3][SR-L3]

•Contacts of the Neutrik connector are connected as shown

in the table at right.

•The usable connector (on the cable end) for the NL4MPR

connector is Neutrik's NL4FC.

Contact No. SR-F3 SR-L3

1 + LOW + Left +

LOW

Left

2 + HIGH + Right +

HIGH

Right

* The left and the right are the directions as

shown from the front.

CAUTION

4. WIRING DIAGRAM

(+)

(–)(–)

(–)

(–)(–)

(+)

NL4MPR

LEFT

RIGHT

NL4MPRNL4MPR

2–

1–

2–

1–

2–

1–

LOW

HIGH

Screw terminal 4P Screw terminal 4P

[SR-F3][SR-L3]

5. FLYING

Be sure to consult an installer as to the following uses:

5.1 When using the flying hardware on the top or the bottom of the speaker.

Shown below are the general flying methods:

[Precautions]

•Provide at least two suspension points on each speaker.

•The maximum number of speakers that can be suspended

vertically is three.

Do not suspend as illustrated below:

•Flying through only one

suspension point.

•Flying through handles.

•Vertical suspension of

more than 3 speakers.

5.2 When using the nuts on the sides.

For an M16 nut provided on the sides, use an eye bolt with

the threaded section of 35-50 mm in length.

6. CONNECTIONS

6.1 Combined system of the SR-F3 and SR-L3

7. SPECIFICATIONS

6.2 System using only the SR-F3

Power amplifier

Mixer or pre-amplifier

INPUT 2

OUTPUT 3

OUTPUT 2

Dedicated

controller

OUTPUT 1

SR-F3

SR-L3

Power amplifier

Dedicated

controller

Note : The design and specifications are subject to change without notice for improvement.

SR-F3 SR-L3

Enclosure Type Front-loaded horn , sealed type Bass reflex type

Speakers Low frequency : 2 cone speakers with 2 cone speakers with diameter of 46 cm

diameter of 30 cm

High frequency : CD horn 60°(horizontal)

x 30°(vertical) + compression driver

Nominal Impedance Low frequency : 8 Ω8 Ωx 2

High frequency : 16 Ω

Output Sound Pressure Low frequency : 105 dB (1 W/1 m) 98 dB ( 0.5 W + 0.5 W / 1 m )

Level High frequency : 111 dB (1 W/1 m)

Power Handling Capacity Low frequency : Continuous pink noise 240 W x 2 *3

Continuous pink noise 240 W *1Continuous program 720 W x 2

Continuous program 720 W

High frequency :

Continuous pink noise 80 W *2

Continuous program 240 W

Frequency Response 60 –20,000 Hz (when using the dedicated 30 –500 Hz

controller)

Crossover Frequency 800 Hz (when using the dedicated contrller) 125 Hz (when using the dedicated contrller)

Input Connector Neutrik NL4MPR x 2 Neutrik NL4MPR

and 4P M5 screw terminal and 4P M5 screw terminal

Enclosure Material Coniferous plywood (15 mm in thickness) Coniferous plywood (15 mm in thickness)

Finish Enclosure : Epoxy paint, dark gray Enclosure : Epoxy paint, dark gray

Punched Net : Acryl paint, black Punched Net : Acryl paint, black

Dimensions 542 (W) x 990 (H) x 533 (D) mm 1082 (W) x 652 (H) x 652 (D) mm

Weight Approximately 75 kg Approximately 86 kg

*1 24 hours pink noise input (50-1,000 Hz)

*2 24 hours pink noise input (800-20,000 Hz)

*3 24 hours pink noise input (40-1,000 Hz)

Printed in Japan

133-01-392-80

HIGH

LOW

Beliebte Lautsprechersystem Handbücher anderer Marken

JVC

JVC CA-MXK5R Bedienungsanleitung

LG NB4532B Bedienungsanleitung

JVC

JVC CA-FSH100 Bedienungsanleitung

5Core

5Core Pro Series Bedienungsanleitung

EAW

EAW MQV1394e Bedienungsanleitung

Lynx

Lynx GXR-LA10A Bedienungsanleitung

iLive

iLive ITB066B Bedienungsanleitung

RDX

RDX QuickStation 4 Bedienungsanleitung

Electro-Voice

Electro-Voice S-122 Bedienungsanleitung

Sven

Sven SPS-619 GOLD Bedienungsanleitung

Pioneer

Pioneer CS-7070 Bedienungsanleitung

EAW

EAW UB82e Bedienungsanleitung

Sondpex

Sondpex Active Speaker System and Digital Music... Bedienungsanleitung

JVC

JVC NX-PN7 Bedienungsanleitung

Yamaha

Yamaha NX-A01 - Speaker Sys Bedienungsanleitung

SE Audiotechnik

SE Audiotechnik I-LINE Bedienungsanleitung

Gemini

Gemini WRX-843 Series Bedienungsanleitung

TCL

TCL 6100 Series Bedienungsanleitung