
3
3. 注意 3. Do's And Don'ts
● 最大トルク以上で使用しない。
破損による事故やけがの原因になります。
●トルクドライバにピンの抜けや目盛板が
無い等、欠品があるものは使用しない。
お買い求めの販売店、又は弊社に問い
合わせ必ず点検や修理を受けて下さい。
●トルクドライバの改造はしない。
改造による強度不足や精度異常が生
じ、事故やけがの原因になります。
●トルクドライバを落下させたり、強い
衝撃を与えたりしない。
破損や変形が生じ、精度の劣化や耐久
性が低下し、事故やけがの原因になり
ます。
●トルクドライバの修理部品は東日指定
部品以外使用しない。
トルクドライバの修理をする場合は、
お買い求めの販売店、又は弊社に問い
合わせ、必ず東日指定部品を使用して
下さい。
●雨ざらしにしたり、高温・高湿では使
用しない。
サビ等により作動不良となります。
●多量にホコリやゴミ・切り粉の発生す
る場所では使用しない。
●RTDZ の目盛は目盛線の赤線より下げ
ないで下さい。(図1)
赤線より下げると、精度不良の原因と
なります。
●作業時には絶縁手袋を装着する。
トルクドライバは絶縁処理されていま
すが、安全のために、必ず絶縁手袋を
装着してください。
●
Do use uid and steady motion. Jerking
or unsteady movement may damage
the driver.
● Do inspect the driver before each use,
and ask a Tohnichi-authorized repair
center to inspect or repair it if any parts
are missing or damaged.
● Don't modify the driver, or use a driver
that has any modifications except
those approved by Tohnichi. Other
modifications will weaken the driver,
or cause inaccuracy, as well as causing
damage or possible injury.
● Do take care to avoid shocks or jolts,
including dropping the driver. Damage
or deformation may result, and
accuracy and durability will be reduced.
● Do use only parts approved by
Tohnichi for repair and maintenance
of the torque driver. Ask your place of
purchase, an authorized repair center,
or contact Tohnichi for assistance in
obtaining parts or repairs.
● Do not use the torque driver in the rain,
high temperature or high humidity, this
may result in malfunction due to the
rust.
● Do not use the torque driver where
there are high levels of dirt or dust.
● Do not turn the inner tube counter-
clockwise above red line.
● Do use with an insulated glove at the
time of work.
赤線以下にトルク目盛を下げないでください。
Do not turn the inner tube counter-clockwise above red line.
図 1 Fig.1