2503W Image Projection MANUAL
Thank you for having chosen our company’s products. For your own safety, please read this user manual
carefully before installing the device.
SAFETY INTRODUCTION
If the device has been exposed to temperature changes due to environmental changes, do not
switch it on immediately. The arising condensation could damage the device. Leave the device
switched off until it has reached room temperature.
This device falls under protection-class I. Therefore it is essential that the device be earthed. A
qualified person must carry out the electric connection.
Make sure that the available voltage is not higher than stated at the end of this manual.
Make sure the power cord is never crimped or damaged by sharp edges.
Always disconnect from the mains, when the device is not in use or before cleaning it. Only
handle the power cord by plug. Never pull out the plug by tugging the power cord.
During initial start-up, some smoke or smell may arise. This is normal and should decrease
gradually.
CAUTION:
1. Be very careful during installation. Since you will be working with a dangerous voltage you
can suffer a life-threatening electric shock when touching live wires.
2. Never touch the device during operation, because the housing heats up.
3. Never look directly into the light source, as sensitive persons may suffer an epileptic shock.
4. Please be aware that damages caused by manual modifications to the device are not subject
to warranty. Keep away from children and non-professionals.
GENERAL GUIDELINES
This device is a lighting effect for professional use on stages, in discotheques, theatres, etc. This
fixture is only allowed to be operated with and alternating current of max.
240VAC/50Hz(125VAC/60Hz) and was designed for indoor use only.
Lighting effects are not designed for permanent operation. Consistent operation breaks will
ensure that the device will serve you for a long time without defects. Do not shake the device.
Avoid brute force when installing or operating the device.
When choosing the installation spot, please make sure that the device is not exposed to extreme
heat, moisture or dust. The minimum distance between light-output from the projector and the
illuminated surface must be more than 0.5 meter.
Always fix the fixture with an appropriate safety cable.
Make sure never to install the device in a place that exceeds the ambient temperature Ta(see
technical specifications at the end of this user manual).
Operate the device only after having familiarized with its functions. Do not permit operation by
person not qualified for operating the device. Most damages are the result of unprofessional
operation.
Please use the original packaging if the device is to be transported.
For safety reasons, please be aware that all modifications on the device are forbidden.
Furthermore, any other operation may lead to short-circuit, burns, electric shock, lamp explosion,
crash, etc. If this device will be operated in any way different to the one described in this manual,
the product may suffer damages and the guarantee becomes void.
INSTALLATION INSTRUCTIONS
a) Installing or replacing the lamps
Before replacing the lamps let the lamps cool down, because during operation, the lamps can
reach temperatures of up to 700℃.
During the installation of halogen lamps do not touch the glass bulbs bare handed. Always use a
cloth to handle the lamps during insertion and removal.
Do not install lamps with a higher wattage. They generate higher temperatures than for which the
device was designed for. For the installation, you need ELC 24v/250w Lamp.
Procedure:
1) Unscrew the screw
2) Gently open the lid
3) Remove the old lamp from the socket and insert a new lamp
4) Carefully replace the lid
5) Fix the screw
