www.topaz-usa.com • 925 Waverly Ave • Holtsville, NY 11742 • 800-666-2852 • Fax: 631-758-8026
Back Mounting (see Diagram 1)
1. Drill ¼” holes into oblong knock outs on back plate (3) to
correspond with junction box (10) holes to be used
2. Feed the transformer input leads through center hole on
housing and make proper connections; for 120VAC, connect
black and white leads to line voltage. For 277VAC, connect
self-powered, be sure to snap battery connector together
3. Feed excess wire into J-Box and secure with back plate
4. Snap in arrows (5) on EXIT panel (2) as required.
5. Connect EXIT face panel (2) to housing; slide top of panel in,
then snap in on the bottom
Side Mounting (see Diagram 2)
1. Attach crossbar(11) to junction box(10). Set the crossbar so
the longer blade is touching the junction box.
2. Open the EXIT housing. Feed the transformer input leads
through side hole, being sure to secure wire into wire guides
molded at the edges of the sign.
3. Attach sign to canopy(7) by inserting canopy into sign
at an angle, then twist to secure.
4. Make the proper supply lead connections. If using 120VAC,
connect the black and white leads to line voltage. If using
wire. If the unit is self-powered, be sure to snap battery
connector together.
5. Push excess wire into junction box and align holes in canopy(7)
with those in crossbar(11). Using screws supplied, tighten
canopy to crossbar so that canopy is securely fastened and
flush against wall.
6. Snap in arrows(5) to EXIT panel(2) as required. Then snap
EXIT panel(2) to housing, top first and then bottom.
Ceiling Mounting (see Diagram 3)
1. Attach crossbar(11) to junction box(10). Set the crossbar so that
the longer blade is touching the junction box.
2. Open the EXIT housing. Feed the transformer input leads
through top hole, being sure to secure wire into wire guides
molded at the edges of the sign.
3. Attach sign to canopy by inserting canopy into sign at an angle,
then twist to secure.
4. Make the proper supply lead connections. If using 120VAC,
connect the black and white leads to the building utility. If using
277VAC, connect the orange and white leads to the building
to snap battery connector together.
5. Push excess wire into junction box and align holes in canopy(7)
with those in crossbar(11). Using screws supplied, tighten
canopy to crossbar so that canopy is securely fastened and
tight against ceiling.
6. Snap in arrows(5) to EXIT panel(2) as required. Then snap EXIT
panel to housing, top first and then bottom.
GREEN GROUND
WIRE
Items:
ES/LED/RW/B and ES/LED/GW/B
LED EXIT
INSTALLATION INSTRUCTIONS
