Topp Music Gear MXi.3BT Bedienungsanleitung

MXi.3BT

Safety Related Symbols

Table of Contents

1. INTRODUCTION

2. FEATURES

3. INSTRUCTION

4. CONTROL ELEMENTS

5. CONNECTING DIAGRAMS

6. WIRING CONNECTION

7. BLOCK DIAGRAM

8. TECHNICAL SPECIFICATIONS

9. GUARANTEE

10. NOTES

Introduction

Thank you for purchasing the TOPP PRO MXi.3BT compact portable mixer.

MXi.3BT mixer features super mini size but equipped with powerful functions.

Please carefully read this manual before installation and operation.

Thank you again for choosing TOPP PRO MUSIC GEAR products.

- 1 mic input channels with XLR and balanced line input.

- 1 stereo input channels with RCA jack.

- Ultra-low noise discrete Mic Preamps with +20V Phantom Power.

- 2-band EQ (Warm, natural) in mono and stereo channels.

- 1 Gain control in mono channel.

- Peak LED in mono channel & master.

- 2RCA-Track inputs & 2RCA-Track outputs

- 2RCA-Track inputs assign to Main Mix & Monitor outputs.

- Main Mix & Monitor outputs use 3.5mm stereo jack.

- Built-in stereo USB/Audio interface

- Either USB bus-powered or external adaptor

- Bluetooth player function

Make sure MXi.3BT mixer is used in the area of ventilation. Do not install or use this

product near any direct hear source(such as amplifier or heater).

Computer USB power or external voltage converter can also supply power to MXi.3BT

mixer.

Note: when using computer USB as power supply, please make sure the USB port of the

computer must comply with the standards of USB 2.0(5V 500mA)

Control Elements

4Control Elements

1- USB PORT

This Type B USB port can be used to connect the computer via Type B to A connector.

2- POWER SWITCH

To turn on/off the unit.

3- POWER LED

This LED will light up when the unit is powered on.

4- MIC/LINE IN JACK

This combined jack can be used to connect mono signal, such as XLR microphone or

1/4" line level.

*Note: Please choose balanced cable and MIC to connect. Do not use the unbalanced

ones. When the unit is powered on, remember not to connect the high level signal to

XLR MIC IN, which may damage the unit.

5- LINE IN JACK

This RCA jack is used for connecting stereo line in signal source.

6- 2TK IN JACK

This RCA jack is used for connecting stereo line in signal source.

7- 2TK OUT JACK

This RCA jack is used for connecting stereo tape recorder.

8- MAIN OUT JACK

This 3.5mm stereo jack is used to connect the active stereo speaker.

9- MONITOR OUT JACK

This 3.5mm stereo jack is used to connect the stereo headphone.

10- GAIN CONTROL

It is used for adjust the level of mono input.

11- HIGH

This treble control can be used to reduce the HF noise or boost the sound of percussion.

12- LOW

This bass control can be used to boost male or effect of drum & bass.

Control Elements

13- PAN/BAL

This is the panorama control or balanced control. This control is used for stereo effect

field of the signal. Set this control in middle position, signal levels of Channel L & R will

be same. When the control is set to top stop, only Channel L receives the signal,

Channel R can not. Vice versa.

14- PEAK LED

This is clip LED indicator of mono level. When this LED illuminates, it means that PFL

mono level is clipped.

15- LEVEL CONTROL

This is channel level control, which is used for adjusting the level of corresponding

channels.

16- LINE IN/USB PLAY

This is path control of the stereo sound source. When this control is engaged, the signal

of channel 2/3 comes from USB PLAY(computer); when the control is disengaged, the

signal will be from RCA jacks of channel 2/3.

17- 2TK/BT TO MAIN

This the assignment control of 2TK input and Bluetooth input.

When this control is engaged ,the signal of 2TK/BT will be assigned to MAIN MIX OUT.

When the control Is disengaged, the assignment will be disconnected.

18- 2TK TO MONITOR

This is the assignment control of 2TK iuput. When this control is engaged ,the signal of

2TK input will be assigned to MONITOR OUT(The signal of BT input will not be assigned

to MONITOR OUT).

When the control is disengaged, the signal of MAIN MAX OUT will be assigned to

MONITOR OUT.

5Control Elements

19- PAIR AND DISPLAY LED

The buttom is used to control the Bluetooth player, and the LED is to display the

working status of the Bluetooth player.

A. After power on the mixer ,Bluetooth player enters standby mode, LED display: flashes

twice every two seconds.

B. Press and hold the PAIR button for 3 seconds the Bluetooth player into the Search

mode and the LED continuous flashing. In this mode, you can connect Bluetooth

devices with your Bluetooth mobile phone or computer (Note: connect Bluetooth

devices below BT2.1 version, you need to enter a matching password "0000").

C. when connected Bluetooth device, the LED is lit.

1) if the connected Bluetooth devices too far of distance and disconnected, the

Bluetooth player will automatically find it and connected the devices in 60

seconds, or enter standby mode;

2) if the connected Bluetooth devices Active disconnected, the Bluetooth player

automatically enters standby mode;

3) Press and hold the PAIR button for 3 seconds, Bluetooth player will clears the

connected Bluetooth device, and enter the search mode.

20- MONITOR

This is monitor control used for adjusting the monitor output level.

21- MAIN MIX

This is main mix control used for adjusting the main mix output level.

22- CLIP LED(L&R)

This is main mix level clip LED. When this LED lights up, main mix level will be clipped.

Connecting Diagram

Wiring Connection

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Topp Music Gear DJ-Equipment Handbücher

Topp Music Gear

Topp Music Gear Soho FLX series Bedienungsanleitung

Beliebte DJ-Equipment Handbücher anderer Marken

ALPHA LITE

ALPHA LITE ALPHA 1500 Betriebsanleitung

Chauvet

Chauvet OVATION E-930VW Bedienungsanleitung

Snow Masters

Snow Masters Zig Oscillator Bedienungsanleitung

EuroLite

EuroLite 50530554 Bedienungsanleitung

Beamz

Beamz BUV243 Bedienungsanleitung

thomann

thomann Stairville DJ Lase 40-G MK-III Bedienungsanleitung

Eagletone

Eagletone 6 Eyes Flower Bedienungsanleitung

EuroLite

EuroLite FLD-1508 Bedienungsanleitung

Technical Pro

Technical Pro LG8xSEA Bedienungsanleitung

JB Systems

JB Systems Lounge Laser DMX Bedienungsanleitung

Lightmaxx

Lightmaxx Vega Halo 90 Bedienungsanleitung

Elation

Elation FUZE WASH Z350 Bedienungsanleitung

Maverick

Maverick MK3 WASH Bedienungsanleitung

Infinity

Infinity TF-260C7 Fresnel Bedienungsanleitung

Chauvet

Chauvet EVE E-50Z Bedienungsanleitung

Eliminator Lighting

Eliminator Lighting E 138 Bedienungsanleitung

EuroLite

EuroLite Mini Multicolor LED Flashing Light SC Bedienungsanleitung

KAM

KAM DMX Laser80 FScan Bedienungsanleitung