Topp Music Gear XCS 12A Bedienungsanleitung

XCS 12A / XCS 15A

2 15

* XCS 12A, XCS 15A are Active Speakers for professional use , they can be used in following

electromagnetic environment: residential, commercial and light industrial, urban outdoors.

They are the apparatusNot intended for rack mounting.

* For , the peak inrush current is 0.9A

*This device complies with part 15 of the FCC Rules. Operation is subject to the following

two conditions: (1)this device may not cause harmful interference , and (2)this device

must accept any interference received , including interference that may cause undesired

operation . Changes or modifications not expressly approved by the party responsible for

compliance could void the user's authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference in

a residential installation. This equipment generates, uses and can radiate radio frequency

energy and, if not installed and used in accordance with the instructions, may cause

harmful interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the interference by one or

more of the following measures:

-- Reorient or relocate the receiving antenna.

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

-- Consult the dealer or an experienced radio/TV technician for help.

XCS 12A, XCS 15A

INTRODUCTION

QUICK START

HOOKUP DIAGRAMS 5

INSTALLATION TIPS 6

WIRE CONNECTIONS

FREQUENCY RESPONSE DIAGRAM

PANEL DESCRIPTION

RIGGING

WARRANTY

TECHNICAL SPECIFICATIONS

XCS

Two speaker in stereo operation

Hookup Diagrams

LINE IN LINE IN

MAIN OUT L MAIN OUT R

MIXER

MAIN OUT LEFT

LINK TO

NEXT SPEAKER

LINE IN

MAIN OUT RIGHT

LINK

LINE IN

LINK TO

NEXT SPEAKER

LINE IN

LINK

Multiple speakers with the same stereo source

Technical Specifications

Model Active

System Type

Transducer Low

Transducer Driver

Horn Coverage H x V

Frequency Response

Crossover Frequency

Max SPL

AMP Power Output

Connector

External Controls

Digital Presets

Electronic Protections

Power Supply

Enclosure Construction

Mounting

Dimensions (HxWxD)

XCS 12A

Useonlywitha250V fuseUseonlywitha250VfuseUseonlywitha250V fuseUseonlywitha250V fuseUseonlywitha250V fuseUseonlywitha250VfuseUseonlywitha250V fuseUseonlywitha250Vfuse

Net Weight

2-Way Active Vented Speaker /Bi-Amp. With DSP processor

12" Woofer, 2"voice coil

1" Neodymium Driver, 1" Voice Coil

90 Hx60 V

50Hz-20KHz (-6dB)

1.6KHz - DSP Processor

125dB Max.

400W Continuous(LF-Class D 350W,HF-Class AB 50W ), 1600W Peak

Line/Mic With Combo &Link With XLR

Volume Control/Lin & Mic Switch/Preset Switch/Power on with

Green LED/ Clip Limiter with Red LED/ Ground Lift.

FLAT -MUSIC-USER

Thermal/Overload/Digital Limiter./Compressor

110-120V 50/60Hz or 220V-240V 50/60Hz Switchable

Plastic cabinet,Trapezoidal & Monitor Shape,Metal Grille,

Rubber Feet,3* Handle ( Top and sides)

36MM standard pole-mount

607*380*337mm

14.63 (kg)/ 32.25(Ibs)

Model Active

System Type

Transducer Low

Transducer Driver

Horn Coverage H x V

Frequency Response

Crossover Frequency

Max SPL

AMP Power Output

Connector

External Controls

Digital Presets

Electronic Protections

Power Supply

Enclosure Construction

Mounting

Dimensions (HxWxD)

XCS 15A

Net Weight

2-Way Active Vented Speaker /Bi-Amp. With DSP processor

15" Woofer, 2"voice coil

1" Compression Driver, 1" Voice Coil

90 Hx60 V

45Hz-20KHz (-6dB)

1.6KHz - DSP Processor

126dB Max.

400W Continuous(LF-Class D 350W,HF-Class AB 50W ), 1600W Peak

Line/Mic With Combo &Link With XLR

Volume Control/Lin & Mic Switch/Preset Switch/Power on with

Green LED/ Clip Limiter with Red LED/ Ground Lift.

FLAT -MUSIC-USER

Thermal/Overload/Digital Limiter./Compressor

110-120V 50/60Hz or 220V-240V 50/60Hz Switchable

Plastic cabinet,Trapezoidal & Monitor Shape,Metal Grille,

Rubber Feet,3* Handle ( Top and sides)

36MM standard pole-mount

625*386*366mm

14 (kg)/ 30.86(Ibs)

Enjoy the sound!

Installation Tips

1- Speakers should be placed in a position that allows for unobstructed sound projection. In many

instances is beneficial for speakers to be elevated on tripod stands to achieve maximum

dispersion and reach.

2- Use professional advice or service when hanging and installing speakers. Please take precautions

to secure them to prevent them from falling and hurting someone. Care should be taken as to

not damage the cabinet or its components. Please comply with all pertinent Regulations.

3- Use quality cables. Using quality cables will ensure the best possible sound.

4- For best results match the speakers to a good amplifier that matches the wattage and impedance

of your speakers. Proper amplification power results in good quality audio and longer

component life. Check out the power requirement for your cabinet.

5- Avoid pointing a microphone directly at an amplified speaker doing so, could cause feedback

possibly damaging speaker components and your hearing.

510

Quick Start

Make all initial connections with all the equipments powered off, and ensure that all the main

volume controls are turned completely down.

1). Connect one side of the signal cable at your audio mixer into output left / right (with Stereo-

Jack or XLR) and the other side of the cable into the line input Stereo-Jack) of your active

speaker cabinet.

2). Connect the power cord to mains.

3). Turn on your mixer first, then the active speaker cabinets.

4). Turn up the volume control of the active speaker cabinets.

5). Use PFL function to get the proper input level for the mixer, and adjust the main mix level

control to manipulate the output level.

6). After using, turn off your active speaker cabinets first, then the mixer.

Power Cord

Tripod

Mount

Left

Main Mix

Output

Signal Cable

Mixer

Power Cord

Tripod

Mount

Right

Output

Main Mix

Signal Cable

XCS 12A

XCS 15A

Rigging

Suspension Point

Eye bolt

The floor use is as a function of a monitor when the angle is 45

The XCS series speaker cabinet also provides the suspension points for installation.

(M10 1.5PH LENGTH: 30mm).

For further details, please refer to the right illustration(OPTIONAL FUNCTIONAL)

Panel Description

(1) BI-POLAR MAIN POWER SWITCH

(2) AC POWER SOCKET WITH MAIN FUSE

(3) LINE/MIC INPUT ON COMBO CONNECTOR

(4) LINK OUT ON XLR CONNECTOR

(5) GROUND SWITCH

(6) THE XCS12A / XCS15A IS SUPPLIED WITH 3 PRESETS, SELECT YOUR FAVORITE AMONG

FLAT-MUSIC-USER

FLAT preset is suited for live sound reinforcement making sound more enjoyable.

MUSIC preset is to equalize the mix for optimal music playback.

(7) FRONT LED SWITCH

(8) "INPUT SENSITIVITY" SWITCH FOR LINE & MIC

(9) POWER INDICATOR GREEN LED

(10) CLIP INDICATOR RED LED

(11) VOLUME CONTROL

(12) USB PLAYER ( )

(13) IP CONTROL (OPTIONAL)

USER preset is to change different EQ to match the voice that the user needs, it can be done

by connecting amplifier module to a PC via the LAN port or the USB port. (The factory preset

of User is the same as normal preset, it can be saved into the product after been modified).

OPTIONAL

AMP INTERFACE

XCS 12A / XCS 15A

Useonly with a 250V fuse

(1)(2)

(9)

(3) (4)

(10)(11)

(5)

(7)

(8)

(6)

(5)

(12)

(13)

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Topp Music Gear Lautsprechersystem Handbücher

Topp Music Gear

Topp Music Gear APEX 18SA Bedienungsanleitung

Topp Music Gear

Topp Music Gear TRANS-PORT Bedienungsanleitung

Topp Music Gear

Topp Music Gear X 8A Bedienungsanleitung

Topp Music Gear

Topp Music Gear Ready 12 Bedienungsanleitung

Topp Music Gear

Topp Music Gear KS8A Bedienungsanleitung

Topp Music Gear

Topp Music Gear Argo 8 Bedienungsanleitung

Topp Music Gear

Topp Music Gear TPS215NEO MKII Bedienungsanleitung

Topp Music Gear

Topp Music Gear ARGO 8A Bedienungsanleitung

Topp Music Gear

Topp Music Gear T-Array SAT28P Bedienungsanleitung

Beliebte Lautsprechersystem Handbücher anderer Marken

JVC

JVC CA-MXK5R Bedienungsanleitung

LG NB4532B Bedienungsanleitung

JVC

JVC CA-FSH100 Bedienungsanleitung

5Core

5Core Pro Series Bedienungsanleitung

EAW

EAW MQV1394e Bedienungsanleitung

Lynx

Lynx GXR-LA10A Bedienungsanleitung

iLive

iLive ITB066B Bedienungsanleitung

RDX

RDX QuickStation 4 Bedienungsanleitung

Electro-Voice

Electro-Voice S-122 Bedienungsanleitung

Sven

Sven SPS-619 GOLD Bedienungsanleitung

Pioneer

Pioneer CS-7070 Bedienungsanleitung

EAW

EAW UB82e Bedienungsanleitung

Sondpex

Sondpex Active Speaker System and Digital Music... Bedienungsanleitung

JVC

JVC NX-PN7 Bedienungsanleitung

Yamaha

Yamaha NX-A01 - Speaker Sys Bedienungsanleitung

SE Audiotechnik

SE Audiotechnik I-LINE Bedienungsanleitung

Gemini

Gemini WRX-843 Series Bedienungsanleitung

TCL

TCL 6100 Series Bedienungsanleitung