2
GENERAL INFORMATION
IMPORTANT SAFETY INFORMATION
This door controller has een designed to meet international safety standards ut, like
any electrical equipment, care must e taken if safety is to e assured. Read these safety
instructions efore installation and operation of the door controller. Retain this installation
guide for future use.
DO
DODO
DO insure that all the electrical connections (including power connections
and interconnections etween pieces of equipment) are properly made in
accordance with the manufacturers instructions. The equipment must e
The equipment must e The equipment must e
The equipment must e
earthed
earthedearthed
earthed.
DO
DODO
DO consult your dealer if you are in any dou t a out installation, operation
or safety of the equipment.
DO
DO DO
DO ensure that all Health and Safety regulations are met regarding every
aspect of your Access Control system.
DO
DODO
DO remem er that some equipment continues to operate after mains
power has een removed, ecause of an internal attery. In such cases a
qualified Service Engineer must disconnect the attery efore attempting
to service the equipment.
DO NOT
DO NOTDO NOT
DO NOT continue to operate the equipment if you are in any dou t a out it
working normally .
DO NOT
DO NOTDO NOT
DO NOT remove any cover fastenings unless you are qualified to do so.
Even then isolate from the power connection efore you start.
DO NOT
DO NOTDO NOT
DO NOT allow the equipment to e exposed to rain or moisture other than
permitted y the equipment's specification.
DO NOT
DO NOTDO NOT
DO NOT attempt to service any attery fitted to the equipment. If the
attery fitted to the circuit oard is faulty, return the complete circuit oard
to an approved Service Centre. Remova le atteries may e replaced y a
qualified Service Engineer.
WARNING To comply with international safety standards the a.c. supply must e routed
via an easily accessi le isolating device. This device must have a contact gap of at least
3mm (three millimetres) and should reak oth Live and Neutral conductors
simultaneously. If the Neutral conductor can e relia ly identified the device may e in the
Live conductor only.
POWER REQUIREMENT...
......
... The Door Controller requires a mains supply rated at 220 -
240V a.c./50VA 49Hz to 61Hz.
