TOWKING 103204 Bedienungsanleitung
FLOOR JACK
User Manual
Installation & Use instructions, Please read before beginning.
Adjustable Floor Jack (103204) Adjustable Floor Jack (103205)
Minimum Height: 19in Minimum Height: 56in
Maximum Height: 36in Maximum Height: 100in
Minimum Load Capacity: 16,000lbs Minimum Load Capacity: 20,000lbs
Maximum Load Capacity: 18,000lbs Maximum Load Capacity: 38,000lbs
Hazard Definitions
Please familiarize yourself with hazard notices found in this manual. A notice is an alert that there is a possibility of
property damage, injury or death if certain instructions are not followed.
WARNING! This notice indicates a specific hazard or unsafe practice that could result in severe personal
injury or death if the proper precautions are not taken
CAUTION! This notice indicates a potentially hazardous situation that may result in minor or moderate injury
if proper practices are not taken
NOTICE! This notice indicates that a specific hazard or unsafe practice will result in equipment or property
damage, but not personal injury
Warning
1. Make sure floor jack is centered under beam and is vertically.
2. Use the floor jack to the sagging floors, adjust the height of floor jack by turning the adjusting screw shaft with a
wrench as per actual need.
3. WARNING! Do not exceed load capacity
4. Adjustable floor jack should be used as additional support, not primary support
5. Determine safe allowable load by a licensed engineer when used in a lifting application.
Installation
1. Put one of steel plates on foot, and the flat side faced to foot (Fig. 1).
2. Put the Dia. 2.5in. bigger tube over the plate with the holes oriented at the top, or reverse for shorter height.
3. Insert the Dia. 2.25in. smaller tube inside the Dia. 2.5in. bigger tube with the holes oriented at the bottom (Fig. 2).
4. Install the outside and inside tube with the holes aligned by two 5/8'' bolts and nuts (Fig. 3).
PLEASE NOTE: If the assembly was installed too high firstly, it may prevent the installation of the adjusting nut and
screw shaft.
5. Place the adjusting screw and nut on the top of the smaller tube with the tapered side faced to the tube and rest
on (Fig. 4).
6. Put the other steel plate on the top of the adjusting screw with flat side faced up (Fig. 5).
7. Use an adjustable wrench to complete the adjustment that it needs.
8. Secure the steel plates with proper nails, screws or bolts.
CALIFORNIA PROPOSITION 65 WARNING
WARNING: This product contains chemicals known to the State of California to cause cancer and birth
defects or other reproductive harm.
Dieses Handbuch passt für folgende Modelle
1
Inhaltsverzeichnis
Andere TOWKING Jack Handbücher
Beliebte Jack Handbücher anderer Marken
VEVOR
VEVOR TJD-12000SP-F Bedienungsanleitung
ULTIMATE SPEED
ULTIMATE SPEED URW 2 A1 HYDRAULIC TROLLEY JACK Bedienungsanleitung
Stels
Stels 51131 Bedienungsanleitung
Bushranger
Bushranger RJX01 Bedienungsanleitung
Clarke
Clarke CTJ2500QLG Installations- und Betriebshandbuch
Valex
Valex 1650520 Bedienungsanleitung
