Button Explanations
LED Status
Specications
Safety Notice
Smart Wi-Fi Dimmer Switch
Quick Start Guide
Before installing, servicing or removing the switch, read and
follow all safety precautions including the following:
• CAUTION – Risk of Electric Shock – More than one
disconnect switch may be required to de-energize the
equipment before servicing. A circuit breaker which
disconnects the Line and Neutral conductor simultaneously
is suitable. Ensure power is o at the circuit breaker before
removing or installing any switch. Use a non-contact voltage
tester to ensure the power is o.
• The Smart Switch must be installed and used in accordance
with the National Electric Code (NEC) or your local electrical
code. If you are unfamiliar with these codes and
requirements, or are uncomfortable performing the
installation, consult a qualied electrician.
• Do not install the Smart Switch with wet hands or when
standing on wet or damp surfaces.
• Install only in a suitable UL Listed outlet box (suitable
dimensions: H > 2.95 in./75 mm, W > 1.81 in./46 mm,
D > 2 in./51 mm).
• Tighten terminal screws to 13 lbf-in.
7106509177 REV1.0.0 ©2021 TP-Link
Rating: 120V~ 60Hz
Load: 300W Incandescent, 150W LED
Operation temperature: 0~40℃
Need some help?
?
Visit www.tp-link.com/support
for technical support, user guides, FAQs,
warranty & more
Starting up.Flashing red
Flashing amber
Flashing green
White
Breathing white
Solid red
Stay green for 30s
Solid amber
Flashing amber & green
Your phone is connected
to the switch.
Connecting to Wi-Fi.
Ready for setup.
The switch is being reset to
factory default settings.
Light fixture is off.
The switch will be auto off.
Disconnected from Wi-Fi.
Connected to Wi-Fi.
*Images may dier from your actual product.
Restart
Reset
Press and hold for about 5s to reset
your switch with configuration saved.
Press to restart your switch.
Decrease or increase the brightness.
Press and hold for about 10s to restore
your switch to factory default settings.
/
