TP-Link T1700G-28TQ Bedienungsanleitung

Installation Guide

Business Networking Solution

JetStream 24-Port Gigabit Stackable

Smart Switch with 4 10GE SFP+ Slots

T1700G-28TQ

Specifications are subject to change without notice. is a registered trademark

of TP-LINK TECHNOLOGIES CO., LTD. Other brands and product names are trademarks of their

respective holders.

No part of the specifications may be reproduced in any form or by any means or used to make

any derivative such as translation, transformation, or adaptation without permission from TP-LINK

http://www.tp-link.com

FCC STATEMENT

This equipment has been tested and found to comply with the limits for a Class A digital device,

pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference when the equipment is operated in a commercial environment. This

equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in

accordance with the instruction manual, may cause harmful interference to radio communications.

Operation of this equipment in a residential area is likely to cause harmful interference in which case

the user will be required to correct the interference at his own expense.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two

conditions:

1) This device may not cause harmful interference.

2) This device must accept any interference received, including interference that may cause

undesired operation.

Any changes or modifications not expressly approved by the party responsible for compliance could

void the user’s authority to operate the equipment.

CE Mark Warning

This is a Class A product. In a domestic environment, this product may cause radio interference, in

which case the user may be required to take adequate measures.

Safety Information

1) Avoid water and wet locations.

2) Don’t disassemble the product, or make repairs yourself. You run the risk of electric shock and

voiding the limited warranty. If you need service, please contact us.

Related Document

IIIContents

Contents

Chapter 1 Introduction ———————————— 01

1.1 Product Overview.....................................01

1.2 Appearance................................................... 01

Chapter 2 Installation ———————————— 04

2.1 Package Contents.....................................04

2.2 Safety Precautions....................................04

2.3 Installation Tools......................................06

2.4 Product Installation ..................................07

2.5 Stacking Using SFP+ Port .........................08

Chapter 3 Lightning Protection ———————— 10

3.1 Cabling Reasonably ..................................10

3.2 Connect to Ground ...................................12

3.3 Equipotential Bonding...............................13

3.4 Use Lightning Arrester ..............................14

Chapter 4 Connection ———————————— 16

4.1 Ethernet Port ...........................................16

4.2 SFP Port ..................................................16

4.3 Verify Installation .....................................16

4.4 Power On ................................................17

4.5 Initialization.............................................17

Chapter 5 Conguration ——————————— 18

5.1 Congure the Switch via GUI ....................18

5.2 Congure the Switch Using CLI .................19

Appendix A Troubleshooting—————————— 21

Appendix B Hardware Specications —————— 22

JetStream Gigabit Stackable Smart Switch

Introduction

Chapter 1 Introduction

1.1 Product Overview

TP-LINK Gigabit Smart Switch, designed for workgroups and departments, provides

wire-speed performance and abundant L2 management features. It provides a variety

of service features and multiple powerful functions with high security.

The EIA-standardized framework and smart configuration capacity can provide flexible

solutions for a variable scale of networks. QoS and IGMP snooping/filtering optimize

voice and video application. Link aggregation increases aggregated bandwidth,

optimizing the transport of business critical data. SNMP, RMON, WEB and CLI Log-in

bring abundant management policies. TP-LINK Gigabit Smart Switch integrates multiple

functions with excellent performance, and is friendly to manage, which can fully meet

the need of the users demanding higher networking performance.

T1700G-28TQ also supports stacking of up to 6 units, thus providing flexible scalability

and protective redundancy for your networks.

1.2 Appearance

■Front Panel

The front panel of T1700G-28TQ is shown as the following figure.

Reset

LEDs

10/100/1000Mbps RJ45 Port

SFP+ Port

Unit ID LED

Figure 1-1 Front Panel of T1700G-28TQ

LEDs

LED Status Indication

PWR

On The switch is powered on

Off The switch is powered off

Flashing Power supply is abnormal

SYS Flashing The switch is working normally

On/Off The switch is working abnormally

JetStream Gigabit Stackable Smart Switch

Introduction 02

LED Status Indication

Master On The switch works as master in the stack system, or

does not join any stack system

Off The switch works as stack member in the stack system

Link/Act

On There is a device connected to the corresponding port

but no activity

Flashing Data is being transmitted or received

Off No device is connected to the corresponding port

1000Mbps

On A 1000Mbps device is connected to the corresponding

port

Off A 10/100Mbps device or no device is connected to the

corresponding port

25-28

Green On A 10Gbps device is connected to the corresponding port,

but no activity

Flashing Data is being transmitted or received

Yellow On A 1000Mbps device is connected to the corresponding

port, but no activity

Flashing Data is being transmitted or received

Off No device is connected to the corresponding port

Unit ID LED

Designed to display the stack Unit ID of the switch. For the switch that does

not join any stack system, it displays its default Unit ID. To modify the default

unit number, please logon to the GUI of the switch and go to Stack→Stack

Management→Switch Config page and configure the New Unit ID. The new Unit

ID will take effect after you reboot the switch.

Reset

Press this button for 5 seconds or above to reset the software setting back to

factory default settings.

10/100/1000Mbps RJ45 Port

Designed to connect to the device with a bandwidth of 10Mbps, 100Mbps or

1000Mbps. Each has a corresponding Link/Act LED and a 1000Mbps LED.

SFP+ Port

Port 25-28, designed to install the 1Gbps SFP transceiver, 10Gbps SFP+ transceiver

or SFP+ cable.

Port Feature

Model 10/100/1000Mbps RJ45 Port SFP+ Port

T1700G-28TQ 24 4

JetStream Gigabit Stackable Smart Switch

Introduction

■Rear Panel

The rear panel of T1700G-28TQ features a Kensington security slot, a grounding

terminal and a power socket.

Grounding Terminal

Power Socket

Kensington Security Slot

Figure 1-2 Rear Panel

Kensington Security Slot

Secure the lock (not provided) into the security slot to prevent the device from being

stolen.

Grounding Terminal

The switch already comes with lightning protection mechanism. You can also ground

the switch through the PE (Protecting Earth) cable of AC cord or with Ground Cable.

For detailed information, please refer to Chapter 3 Lightning Protection.

Power Socket

Connect the female connector of the power cord here, and the male connector to

the AC (Alternating Current) power outlet. Please make sure the voltage of the

power supply meets the requirement of the input voltage.

Caution: Please use the provided power cord.

JetStream Gigabit Stackable Smart Switch

Installation 04

Chapter 2 Installation

2.1 Package Contents

Make sure that the package contains the following items. If any of the listed items is

damaged or missing, please contact your distributor.

One Resource CD

One Switch One Power Cord This Installation Guide

Two Mounting Brackets and the

Fittings

2.2 Safety Precautions

To avoid any device damage and bodily injury caused by improper use, please observe

the following rules.

■Safety Precautions

■Keep the power off during the installation.

■Wear an ESD-preventive wrist strap, and make sure that the wrist strap has a good

skin contact and is well grounded.

■Use only the power cord provided with the switch.

■Make sure that the supply voltage matches the specifications indicated on the rear

panel of the switch.

■Ensure the vent hole is well ventilated and unblocked.

■Do not open or remove the cover of the switch.

■Before cleaning the device, cut off the power supply. Do not clean it by the waterish

cloth, and never use any other liquid cleaning method.

JetStream Gigabit Stackable Smart Switch

Installation

■Site Requirements

Temperature/Humidity



ȭ

Please keep a proper temperature and humidity in the equipment room. Too high/low

humidity may lead to bad insulation, electricity leakage, mechanical property changes

and corrosions. Too high temperature may accelerate aging of the insulation materials

and can thus significantly shorten the service life of the device. For normal temperature

and humidity of the device, please check the following table.

Environment Temperature Humidity

Operating 0℃~ 40℃10% ~ 90%RH Non-condensing

Storage -40℃~ 70℃5% ~ 90%RH Non-condensing

Clearness

The dust accumulated on the switch can be absorbed by static electricity and result

in poor contact of metal contact points. Some measures have been taken for the

device to prevent static electricity, but too strong static electricity can cause deadly

damage to the electronic elements on the internal circuit board. To avoid the effect of

static electricity on the operation of the switch, please attach much importance to the

following items:

■Dust the device regularly, and keep the indoor air clean.

■Keep the device well grounded and ensure static electricity has been transferred.

Electromagnetic Interference

Electronic elements including capacitance and inductance on the device can be affected

by external interferences, such as conducted emission by capacitance coupling,

inductance coupling, and impedance coupling. To decrease the interferences, please

make sure to take the following measures:

■Use the power supply that can effectively filter interference from the power grid.

■Keep the device far from high-frequency, strong-current devices, such as radio

transmitting station.

■Use electromagnetic shielding when necessary.

Andere Handbücher für T1700G-28TQ

Inhaltsverzeichnis

Andere TP-Link Schalten Handbücher

TP-Link

TP-Link kasa smart KS200 Bedienungsanleitung

TP-Link

TP-Link TL-SG1008 Bedienungsanleitung

TP-Link

TP-Link Omada DS105G-M2 Bedienungsanleitung

TP-Link

TP-Link LiteWave LS1005 Bedienungsanleitung

TP-Link

TP-Link TL-SG105 Bedienungsanleitung

TP-Link

TP-Link TL-SF1048 Bedienungsanleitung

TP-Link

TP-Link Tapo S210 Bedienungsanleitung

TP-Link

TP-Link JetStream TL-SG3216 Bedienungsanleitung

TP-Link

TP-Link JetStream T1500-28TC Bedienungsanleitung

TP-Link

TP-Link TL-SG1005D Bedienungsanleitung

TP-Link

TP-Link TL-SL2210WEB Bedienungsanleitung

TP-Link

TP-Link HS200 Bedienungsanleitung

TP-Link

TP-Link TL-RP108GE Bedienungsanleitung

TP-Link

TP-Link TL-SG2452 Bedienungsanleitung

TP-Link

TP-Link TL-SF1005D Bedienungsanleitung

TP-Link

TP-Link JetStream TL-SG3216 Bedienungsanleitung

TP-Link

TP-Link TL-SG108E Bedienungsanleitung

TP-Link

TP-Link TL-SG1218MPE Bedienungsanleitung

TP-Link

TP-Link T2500-28TC Bedienungsanleitung

TP-Link

TP-Link TL-SX105 Bedienungsanleitung

TP-Link

TP-Link TL-SL2428 Bedienungsanleitung

TP-Link

TP-Link TL-SG105 Bedienungsanleitung

TP-Link

TP-Link JetStream TL-SG3424P Bedienungsanleitung

TP-Link

TP-Link KS220M Bedienungsanleitung

Beliebte Schalten Handbücher anderer Marken

URC

URC Total Control MFS-8 Bedienungsanleitung

Azbil

Azbil HPQ-D11 Bedienungsanleitung

Sony

Sony DFS-900M Bedienungsanleitung

SICK

SICK i17S Bedienungsanleitung

F&F

F&F SZR-277 Bedienungsanleitung

Shure

Shure UAMS/BK Bedienungsanleitung

Dräger

Dräger X-zone Switch Off Bedienungsanleitung

Asco

Asco Joucomatic 349 Series Bedienungsanleitung

BT Mini Hub Bedienungsanleitung

D-Link

D-Link DES-1226G Bedienungsanleitung

Johnson Controls

Johnson Controls FS80-C Bedienungsanleitung

Alcatel-Lucent

Alcatel-Lucent 7450 ESS-12 Bedienungsanleitung

MicroNet

MicroNet SP1200A Bedienungsanleitung

Ruijie

Ruijie RG-PF2920 Series Installations- und Betriebsanleitung

Altinex

Altinex DA1914SX Bedienungsanleitung

MiLAN

MiLAN MIL-SM2401M Bedienungsanleitung

RJM

RJM MASTERMIND PBC/6X Bedienungsanleitung

Atlas

Atlas MMK-KVM8 Bedienungsanleitung