Product Code: 1003
Page 5
Visit us at www.tqbbrands.com.au
4. OPERATION
1. Fill the parts washer only with a non-flammable parts cleaning fluid, to just below
the level of the parts shelf. DO NOT fill with flammable petroleum solvents such as
paraffin, thinners, etc.
2. Open the lid, switch the pump on and hold the part to be cleaned under the nozzle,
slowly rotate the component until clean. Use a brush to loosen stubborn grime.
3. When clean, leave to drain on the tray or in a small component container until dry.
4. Switch off the pump and close the lid and disconnect the power supply.
5. Remove gloves and goggles, store safely.
Note: Any spillages should be mopped up immediately, so as not to cause a safety
hazard.
Important:
1. The lid stay incorporates a "Quick Close" fire safety device in the form of a fusible
link, which closes the lid in the event of fire. The link is non-resetting and must be
replaced should it be activated.
2. Clean the pump filter regularly, by sliding it away from the pump housing and rinsing
it in clean parts cleaning fluid.
3. Do not allow the level of fluid in the parts washer to fall below the pump inlet, as
damage to the pump can result. (Minimum fluid capacity is 33 Litres)
5. STORAGE
This Parts Washer should always be stored in a dry location on a level surface. Disconnect
240V power supply and air supply and empty the parts cleaning fluid into a container.
6. MAINTENANCE
Disconnect power prior to any maintenance. Inspect the general condition of the Parts
Washer checking:
For loose hardware
Misalignment of binding or parts, cracked, bent, or broken parts, and
Any other condition that may affect the Parts Washers safe operation
Disconnect 240V power plug, remove flex hose from pump flow-out line
Remove cover of pump housing. Clean any foreign matter lodged around impeller
Re-assemble in reverse order
For heavy build-up of dirt and grime, our enamel paint finish can be cleaned with
spray wax. Lightly spray the wax on the surface, and gently wipe with a soft, dry
microfiber cloth.
Window cleaner and a soft cloth dampened with water can be used to clean the
finish on a regular basis.
7. SERVICE & REPAIR
Any Parts Washer found damaged in any way, or found to be worn or operates
abnormally should be removed from service until repaired by an authorised service agent.
Owners and/or operators should be aware that repair of this product may require
specialised equipment and knowledge. Only authorised parts, labels and decals shall be
used on this equipment. Annual inspection of the Parts Washer is recommended and can
be made by an authorised repair facility to ensure that your equipment is in optimum
condition and that the equipment has the correct decals and safety labels specified by the
manufacturer.
