2
ServoPac GDPS – Power supply unit
WARNING
This is a general manual describing a series of power supplies having output capability suitable for powering
servo drives.
Instructions for storage, use after storage, commissioning as well as all technical details require the
MANDATORY reading of the manual before getting the drives operational.
Maintenance procedures should be attempted only by highly skilled technicians having good knowledge
of electronics and servo systems with variable speed (EN 60204-1 standard) and using proper test
equipment.
The conformity with the standards and the "CE" approval is only valid if the items are installed according to the
recommendations of the drive manuals. Connections are the user's responsibility if recommendations and
drawings requirements are not met.
TRANSTECHNIK does not assume any responsibility for any physical or material damage due to improper
handling or wrong descriptions of the ordered items.
Any intervention on the items, which is not specified in the manual, will immediately cancel the warranty.
TRANSTECHNIK reserves the right to change any information contained in this manual without notice.
©TRANSTECHNIK, May 2011. All rights reserved.
Issue : 2.2
CAUTION
Any contact with electrical parts, even after power down, may involve physical damage.
Wait for at least 10 minutes after power down before handling the devices (a residual voltage
of several hundreds of volts ma
remain durin
a few minutes
.
ESD INFORMATION (ElectroStatic Discharge)
TRANSTECHNIK drives are conceived to be best protected against electrostatic discharges.
However, some components are particularly sensitive and may be damaged if the drives are not
properly stored and handled.
STORAGE
- The devices must be stored in their original package.
- When taken out of their package, they must be stored positioned on one of their flat
metal surfaces and on a dissipating or electrostatically neutral support.
- Avoid any contact between the device connectors and material with electrostatic
potential (plastic film, polyester, carpet …).
HANDLING
- If no protection equipment is available (dissipating shoes or bracelets), the devices must
be handled via their metal housing.
- Never get in contact with the connectors.
ELIMINATION
In order to comply with the 2002/96/EC directive of the European Parliament and of the Council of
27 January 2003 on waste electrical and electronic equipment (WEEE), all TRANSTECHNIK
devices have got a sticker symbolizing a crossed-out wheel dustbin as shown in Appendix IV of
the 2002/96/EC Directive.
This symbol indicates that TRANSTECHNIK devices must be eliminated by selective disposal and
not with standard waste.
