TRENDnet TPE-101I Bedienungsanleitung
TPE-101I
TPE-102S
Quick Installation Guide
Table of Contents
English ......................................................................................................
Technical Specifications ............................................
Troubleshooting ........................................................................................
................ ................
1
1
3
5
6
1. Before You Start
2. Hardware Installation ........................................................................
................................................................................
Table of Contents
Version 06.20.2007
Package Contents
1. Before You Start
English
1
Note: The TPE-101I and TPE-102S only support Power over Ethernet (PoE)
devices that follow the IEEE 802.3af standard
Note: The TPE-102S only supports non-PoE devices with an output power of
5V, 7.5V, 9V or 12V.
?
?Quick Installation Guide
TPE-101I/TPE-102S
?Power Cord (TPE-101I)
?Jumper Cable (TPE-102S)
Front Panel
TPE-101I
TPE-102S
Power
Lights green when the power cord is
connected into an outlet and the PoE
device is connected to the Injector.
POWER
Lights green when a PoE device is
connected to the splitter.
Application
English
2
Power over Ethernet Splitter
(TPE-102S)
Power + Data
(PoE)
5V/7.5V/9V/12V Power
Data
Power over Ethernet Injector
(TPE-101I)
Power + Data (PoE)
Power
Data
Power
5V/7.5V/9V/12V DC Power
Data
Power + Data
Non-PoE Device which uses
5V/7.5V/9V/12V Power Input
Power
Data
Power + Data
Data
Power
8-Port 10/100Mbps
Fast Ethernet Switch
(TE100-S8)
Power over Ethernet Injector
(TPE-101I)
PoE Device
8-Port 10/100Mbps
Fast Ethernet Switch
(TE100-S8)
Power
Jack
Power
Jack
Power + Data
(PoE)
5V/7.5V/9V/12V Power
Data
Power over Ethernet Splitter
(TPE-102S)
Power + Data (PoE)
Power
5V/7.5V/9V/12V Power
Data
Power + Data
Non-PoE Device which uses
5V/7.5V/9V/12V Power Input
5V/7.5V/9V/12V Power
Data
Power + Data
PoE Switch
(TPE-S44)
8-Port 10/100Mbps
Fast Ethernet Switch
(TE100-S8)
Data
5V/7.5V/9V/12V Power
Non-PoE Device which uses
5V/7.5V/9V/12V Power Input
Power over Ethernet Injector
(TPE-101I)
Power Power
Jack
Power over Ethernet Splitter
(TPE-102S)
Data
English
3
1. Connect the Power Cord to the
Injector. Then connect the Power
Cord to an outlet.
2. Hardware Installation
Using the TPE-101I with a PoE device
3. Connect a CAT-5 cable from a
PoE device (e.g. TEW-434APB) to
the TPE-101I's PoE Out port
2. Connect a CAT-5 cable from a
switch to the TPE-101I's Data In
port.
English
4
Using the TPE-102S with a non-PoE device
Note: Take note of the output power for your non-PoE device. The TPE-102S
only supports non-PoE devices with an output power of 5V, 7.5V, 9V or 12V.
Your installation is now complete.
Register Your Product
To ensure the highest level of customer service and support, please take a moment to
register your product Online at: www.trendnet.com/register
Thank you for choosing TRENDnet
1. Select the proper voltage (5V, 7.5V,
9V or 12V).
2. Connect an Ethernet cable from a
PoE switch to the PoE In port on
the TPE-102S.
3. Connect the Ethernet cable from
the Data-Out port on the
TPE-102S to the non-PoE device's
LAN port (e.g. TEW-450APB).
4. Connect the provided Jumper
cable to a non-PoE device (e.g.
TEW-450APB) and to the
TPE-102S.
5
Technical Specifications
IEEE 802.3 10BASE-T
IEEE 802.3u 100BASE-TX
IEEE 802.3af Power Over Ethernet (PoE)
POWER
LED Indicator
Applicable Standards
TPE-101I:
TPE-102S:
1 Data In, 1 PoE Out
1 Data Out, 1 PoE In
Speed 10/20Mbps for half/full-duplex
100/200Mbps for half/full-duplex
Dimensions
Operating Temperature
Storage Temperature
Humidity
Certificates
TPE-102S: DC OUT (5V, 7.5V, 9V, 12V)
TPE-101I: 15.5 Watts (max)
TPE-102S: 10 Watts (max)
0°C ~ 45°C (32°F ~ 104°F)
-40°C ~ 70°C (14°F ~ 158°F)
10 ~ 90%, non-condensing
FCC, CE
TPE-101I: 48V DC, 0.3A
TPE-102S: DC Output 5V , 7.5V, 9V, or 12V
Cable 10BASE-T: UTP/STP Cat. 3,4,5
100BASE-TX: UTP/STP Cat. 5, 5e, 6
Ethernet Pin Usage Data: 1, 2, 3, 6
Power: 4, 5 (V+), 7, 8 (V-)
TPE-101I: 115 x 57 x 35mm (4.5 x 2.2 x 1.4 in.)
TPE-102S: 80 x 54 x 24mm (3.2 x 2.13.35 x 0.9 in.)
Fixed Ports
Switches
Power
Power Consumption
Q1:
A1:
Q2:
A2:
Q3:
A3:
Q4:
A4:
Q5:
A5:
Why is the POWER LED off on the TPE-101I?
First, make sure the TPE-101I is connected into a power outlet. Second,
make sure that the PoE device is connected properly to the TPE-101I. Third, try
using another CAT-5 cable.
Why is the POWER LED off on the TPE-102S?
First, make sure that the TPE-102S is connected properly to the PoE switch or
TPE-101I (See 3.Hardware Installation). Second, try using another CAT-5 cable.
Will the TPE-101I work with any PoE device?
Any PoE device that follows the IEEE 802.3af standard will work with
TPE-101I.
Will the TPE-102S work with any non-PoE device?
Non-PoE devices such as access points will work with the TPE-102S only if
the non-PoE device operates at 5V, 7.5V, 9V or 12V.
I connected my non-PoE device into the TPE-102S, but my switch does not
recognize the device.
Power cycle the non-PoE device by either pulling out the power adapter
connector from the PoE injector or disconnecting the CAT 5 cable from the PoE
Out port. Reinsert the connection after 5-10 seconds have elapsed.
If you still encounter problems or have any questions regarding the PoE Injector/Splitter,
please contact TRENDnet's Technical Support Department.
6
Troubleshooting
Limited Warranty
- 5 Year Warranty
TRENDnet warrants its products against defects in material and workmanship, under
normal use and service, for the following lengths of time from the date of purchase.
TPE-101I/TPE-102S
If a product does not operate as warranted above during the applicable warranty period,
TRENDnet shall, at its option and expense, repair the defective product or deliver to
customer an equivalent product to replace the defective item. All products that are
replaced will become the property of TRENDnet. Replacement products may be new or
reconditioned.
TRENDnet shall not be responsible for any software, firmware, information, or memory
data of customer contained in, stored on, or integrated with any products returned to
TRENDnet pursuant to any warranty.
There are no user serviceable parts inside the product. Do not remove or attempt to
service the product through any unauthorized service center. This warranty is voided if
(i) the product has been modified or repaired by any unauthorized service center, (ii) the
product was subject to accident, abuse, or improper use (iii) the product was subject to
conditions more severe than those specified in the manual.
Warranty service may be obtained by contacting TRENDnet office within the applicable
warranty period for a Return Material Authorization (RMA) number, accompanied by a
copy of the dated proof of the purchase. Products returned to TRENDnet must be pre-
authorized by TRENDnet with RMA number marked on the outside of the package, and
sent prepaid, insured and packaged appropriately for safe shipment.
7
WARRANTIES EXCLUSIVE: IF THE TRENDNET PRODUCT DOES NOT OPERATE
AS WARRANTED ABOVE, THE CUSTOMER’S SOLE REMEDY SHALL BE, AT
TRENDNET’S OPTION, REPAIR OR REPLACEMENT. THE FOREGOING
WARRANTIES AND REMEDIES ARE EXCLUSIVE AND ARE IN LIEU OF ALL OTHER
WARRANTIES, EXPRESSED OR IMPLIED, EITHER IN FACT OR BY OPERATION OF
LAW, STATUTORY OR OTHERWISE, INCLUDING WARRANTIES OF
MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. TRENDNET
NEITHER ASSUMES NOR AUTHORIZES ANY OTHER PERSON TO ASSUME FOR IT
ANY OTHER LIABILITY IN CONNECTION WITH THE SALE, INSTALLATION,
MAINTENANCE OR USE OF TRENDNET’S PRODUCTS.
TRENDNET SHALL NOT BE LIABLE UNDER THIS WARRANTY IF ITS TESTING AND
EXAMINATION DISCLOSE THAT THE ALLEGED DEFECT IN THE PRODUCT DOES
NOT EXIST OR WAS CAUSED BY CUSTOMER’S OR ANY THIRD PERSON’S
MISUSE, NEGLECT, IMPROPER INSTALLATION OR TESTING, UNAUTHORIZED
ATTEMPTS TO REPAIR OR MODIFY, OR ANY OTHER CAUSE BEYOND THE
RANGE OF THE INTENDED USE, OR BY ACCIDENT, FIRE, LIGHTNING, OR OTHER
HAZARD.
LIMITATION OF LIABILITY: TO THE FULL EXTENT ALLOWED BY LAW TRENDNET
ALSO EXCLUDES FOR ITSELF AND ITS SUPPLIERS ANY LIABILITY, WHETHER
BASED IN CONTRACT OR TORT (INCLUDING NEGLIGENCE), FOR INCIDENTAL,
CONSEQUENTIAL, INDIRECT, SPECIAL, OR PUNITIVE DAMAGES OF ANY KIND,
OR FOR LOSS OF REVENUE OR PROFITS, LOSS OF BUSINESS, LOSS OF
INFORMATION OR DATE, OR OTHER FINANCIAL LOSS ARISING OUT OF OR IN
CONNECTION WITH THE SALE, INSTALLATION, MAINTENANCE, USE,
PERFORMANCE, FAILURE, OR INTERRUPTION OF THE POSSIBILITY OF SUCH
DAMAGES, AND LIMITS ITS LIABILITY TO REPAIR, REPLACEMENT, OR REFUND
OF THE PURCHASE PRICE PAID, AT TRENDNET’S OPTION. THIS DISCLAIMER OF
LIABILITY FOR DAMAGES WILL NOT BE AFFECTED IF ANY REMEDY PROVIDED
HEREIN SHALL FAIL OF ITS ESSENTIAL PURPOSE.
Governing Law: This Limited Warranty shall be governed by the laws of the state of
California.
Note: AC/DC Power Adapter, Cooling Fan, Cables and Power Supply carry a 1-Year
Warranty
8
Andere Handbücher für TPE-101I
4
Dieses Handbuch passt für folgende Modelle
2
Inhaltsverzeichnis
Andere TRENDnet Kabel und Steckverbinder Handbücher
TRENDnet
TRENDnet TU2-DU5 Bedienungsanleitung
TRENDnet
TRENDnet TU3-SA - Bedienungsanleitung
TRENDnet
TRENDnet TU-PS2 Bedienungsanleitung
TRENDnet
TRENDnet TC-RJ45 Handbuch
TRENDnet
TRENDnet TU2-PMLINK Bedienungsanleitung
TRENDnet
TRENDnet TPE-102S Bedienungsanleitung
TRENDnet
TRENDnet TU-P1284 Bedienungsanleitung
TRENDnet
TRENDnet TU2-PCLINK Bedienungsanleitung
TRENDnet
TRENDnet TC-1KC5EG - DATA SHEETS Bedienungsanleitung
TRENDnet
TRENDnet TK-C06 Bedienungsanleitung
TRENDnet
TRENDnet TU2-EX12 - Bedienungsanleitung
TRENDnet
TRENDnet TEW-ASAL1 Bedienungsanleitung
TRENDnet
TRENDnet TU2-EX5 Bedienungsanleitung
TRENDnet
TRENDnet TU2-PCLINK Bedienungsanleitung
TRENDnet
TRENDnet TU-S9 Bedienungsanleitung
TRENDnet
TRENDnet TC-XC5G Handbuch
TRENDnet
TRENDnet TK-CU06 Bedienungsanleitung
TRENDnet
TRENDnet TK-C15 - DATA SHEETS Handbuch
TRENDnet
TRENDnet TEW-8000F Bedienungsanleitung
TRENDnet
TRENDnet TEW-2000F Bedienungsanleitung
