TREX Deck Lighting Betriebsanleitung

Have Questions?

1–800–BUY–TREX

Note: Construction methods are always improving. Please ensure you

have the most up-to-date installation instructions by visiting: trex.com

TDL-1110

TREX® DECKLIGHTING™

Site Preparation and Planning

PARTS

TOOLS NEEDED

General Information

» ALWAYS consult local codes before beginning a project.

» A maximum of 60 lights can be powered by one 60W

transformer. If your project requires more than 60

lights, contact 1-800-BUY-TREX for transformer sizing.

» Straight runs over 100' (30.5 m) may require larger wire

such as 16 or 14 gauge.

» Use Trex Transformer only. Use of any other

transformer voids warranty.

Planning

Note: When designing your deck, plan locations of lights,

power supply, timer, and dimmer. These should be accessible

for service.

1. The dimmer remote will work

in a 30' (9 m) radius of the unit.

2. The dimmer must be installed

in a dry location. Keep dimmer

remote ID # in a safe place in

case a replacement remote is

needed.

3. The timer must be installed vertically

with the receptacle facing downwards

and not reaching ground level.

The timer must be in view of the sun

to use the dusk/dawn feature.

B C D

x2x2 x2x2 x2x2 x2x2x2x2

1/4"

(0.6 cm)

(2.5 cm)

Riser

Light

Deck Rail

Light

Post Cap

Light

Recessed

Deck Light

Note: It is recommended to install

wiring before decking and railing have been installed.

Do Not run wires between joists and deck boards.

Note: Avoid railing brackets and locations for

deck rail lights when running wires up posts.

GFCI

Outlet

Timer

Transformer

To Lights

Dimmer

(Optional)

Lighting and Wiring Overview

Have Questions?

1–800–BUY–TREX

Note: Construction methods are always improving. Please ensure you

have the most up-to-date installation instructions by visiting: trex.com

TDL-1110

TREX® DECKLIGHTING™

How to Install

Installing Wiring

Note: It is recommended to install wiring before decking

and railing have been installed.

» Use 18 gauge stranded outdoor wire (available from

Trex) to connect wires from each light.

1. Wiring must be run under

the decking structure and

behind stringers. DO NOT

run wires between deck

boards and joists. Staple to

frame with cable staples

at least 1/4" (0.6 cm)

wide. DO NOT crush wire

insulation with staple.

2. Wiring can be run under the deck and behind risers.

Staple to frame with cable staples at least 1/4" (0.6 cm)

wide. DO NOT crush wire insulation with staple.

3. Run wire up the outside of each post that will have either

a post cap light or a deck rail light. Avoid running wire

on the side of post where railing brackets or deck rail

lights will be installed. Leave a 6" (15.2 cm) loop at top to

make connections. Staple to frame and posts with cable

staples at least 1/4" (0.6 cm) wide. DO NOT crush wire

insulation with staple.

Note: After installing wiring, ﬁnish installing your Trex

decking and railing by following the Trex Installation Guide.

Making Connections

» Polarity must be maintained through wiring system.

Always attach the same side of the 18 gauge wire to the

red wires on the lights. The red wires are positive.

» The wire nuts supplied by Trex are gel-ﬁlled and

waterproof. These wire nuts can safely attach four wires.

1. Strip wires to 5/8" (1.6 cm). Align any frayed strands of

the conductors. Pre-twisting is unnecessary.

2. Place stripped wires together with insulation even.

Twist connector onto wires pushing ﬁrmly until hand-

tight. DO NOT over torque. Wipe sealant in and around

conductors and connector opening while tightening.

DO NOT reuse.

Timer Operation Instructions

1. Select the mode of operation:

» Dusk to Dawn

» 1 - 8 hours

» Always On

» Off

Program repeats daily

When power is ﬂowing to lights, green light above POWER is on.

Installing Post Cap Lights

Note: Install post cap lights after the railing system, post

sleeve skirt, and post sleeve have been installed.

1. Cut the wire loop at the top of the post. Strip the wire

ends. Make connections with the provided wire nuts.

See Making Connections above.

2. After verifying wiring is correct by turning lights on,

attach the cap to the top of the post with silicone caulk.

(15.2 cm)

Strip

5/8"

(1.6 cm)

(15.2 cm)

Have Questions?

1–800–BUY–TREX

Note: Construction methods are always improving. Please ensure you

have the most up-to-date installation instructions by visiting: trex.com TDL-1110

Installing Deck Rail Lights

Note: Install deck rail lights after the railing system, post

sleeve skirt, and post sleeve have been installed.

1. Mark desired height, centered on post sleeve for deck

rail light location.

2. Drill a 1" (2.5 cm) hole through post sleeve. Use care to

stop drill before cutting into post.

3. Fish wire from deck rail light through hole and up to top of

post. Cut wire loop at the top of the post. Strip the two wire

ends. Make connections with the provided wire nuts. See

Making Connections on page 2.

4. Push back housing and wires into hole. Align holes for

screws vertically

and attach ﬁxture base to post with

provided screws as indicated above.

5. Line up polycarbonate lens with ﬁxture housing. Twist

onto ﬁxture base.

Installing Riser Lights

Note: Install riser lights after stair and risers have

been installed.

1. Mark the locations for each light, generally 4" (10.2 cm)

above the tread. Consult local codes for lighting

requirements.

Note: If possible, avoid locations over stringers as holes will

be more difﬁcult to create.

2. Drill a 1" (2.5 cm) diameter hole at least 1" (2.5 cm) deep

into riser. If the riser material is thicker than 1" (2.5 cm), use

a 1/4" (0.6 cm) drill bit to create a passage for the wires.

3. Thread wires through hole.

4. Press light into hole,

ensuring lens is horizontal.

Make connections behind

the stairs with the provided

wire nuts. See Making

Connections on page 2.

Note: Do Not install Riser

Light or Deck Rail Light into top

or bottom rails or balusters.

TREX® DECKLIGHTING™

How to Install

Post

Sleeve

(15.2 cm)

(10.2 cm)

Have Questions?

1–800–BUY–TREX

Note: Construction methods are always improving. Please ensure you

have the most up-to-date installation instructions by visiting: trex.com TDL-1110

TREX® DECKLIGHTING™

How to Install

Installing Recessed Deck Lights

Note: Install recessed deck lights after installing decking.

1. Mark locations for lights in deck boards.

Note: If possible, avoid locations over joists as holes will be

more difﬁcult to create.

2. Drill a 1" (2.5 cm) diameter hole 3/4" (1.9 cm) deep

into deck board. Hole cannot go all the way through

deckboard or light will fall through. Ensure drill bit is

perpendicular to board. Drill a 1/4" (0.6 cm) diameter

hole in base of the ﬁrst hole through deck board.

3. Thread wires through hole. DO NOT pull LED into hole

by pulling on wires. This may damage wires or LED.

4. Press light into hole until

ﬂush with surface. Make

connections under deck

with the provided wire nuts.

See Making Connections

on page 2.

3/4" (1.9 cm)

Inhaltsverzeichnis

Andere TREX Gartenmöbel Handbücher

TREX

TREX Outdoor Furniture TXT1836 Bedienungsanleitung

TREX

TREX Outdoor Furniture TXNCT3772 Bedienungsanleitung

TREX

TREX Cape Cod TXADSGL Bedienungsanleitung

TREX

TREX Outdoor Furniture TXD201 Bedienungsanleitung

TREX

TREX Yacht Club Garden Arm TXB24 Bedienungsanleitung

TREX

TREX TXFDT37 Bedienungsanleitung

TREX

TREX Monterey Bay TXD202 Bedienungsanleitung

TREX

TREX Outdoor Furniture TXA15 Bedienungsanleitung

TREX

TREX Yacht Club TXB60 Bedienungsanleitung

TREX

TREX TXL1D81 Bedienungsanleitung

TREX

TREX TXCTF48R Bedienungsanleitung

TREX

TREX Rockport Club TXC71 Bedienungsanleitung

TREX

TREX TXD230 Bedienungsanleitung

TREX

TREX TXADGL Bedienungsanleitung

TREX

TREX TXR100 Bedienungsanleitung

TREX

TREX TXD201 Bedienungsanleitung

TREX

TREX Yacht Club TXB24 Bedienungsanleitung

TREX

TREX ADGL-1 Bedienungsanleitung

TREX

TREX TXD130 Bedienungsanleitung

TREX

TREX Outdoor Furniture TXC71 Bedienungsanleitung

TREX

TREX TX4511X Bedienungsanleitung

TREX

TREX Outdoor Furniture TXC47 Bedienungsanleitung

TREX

TREX EDGE 4601CX Bedienungsanleitung

TREX

TREX TXD230 Bedienungsanleitung

Beliebte Gartenmöbel Handbücher anderer Marken

Belleze

Belleze 014-HG-20074 Bedienungsanleitung

Hatteras Hammocks

Hatteras Hammocks DCA1-K-HH Bedienungsanleitung

Kozyard

Kozyard Morgan Aluminum Pergola Bedienungsanleitung

Lemeks

Lemeks Palmako PA120-5959 Installationshandbuch

OLT

OLT 24 Bedienungsanleitung

forest-style

forest-style HACIENDA 2354 Bedienungsanleitung

Courtyard Creations

Courtyard Creations RUS0188-WM Bedienungsanleitung

RPR

RPR OLLIE CHAIR Bedienungsanleitung

kingsley-bate

kingsley-bate MC-55 Bedienungsanleitung

Weltevree

Weltevree Carrier Bedienungsanleitung

Grange Fencing

Grange Fencing Elite Arch Bedienungsanleitung

Grosfillex

Grosfillex AUVENT YR14 Bedienungsanleitung

X-METAL

X-METAL EAGLE 33511 Bedienungsanleitung

Anova

Anova FBW6R Bedienungsanleitung

Outsunny

Outsunny 84A-090 Bedienungsanleitung

Ivy Terrace

Ivy Terrace IVTD212 Bedienungsanleitung

Breezesta

Breezesta FANBACK ADIRONDACK AD-0101 Bedienungsanleitung

hanit

hanit SUTTON 1 Bedienungsanleitung