Tripp Lite SmartPro SMX1200XLHG Bedienungsanleitung

Tripp Lite

1111 West 35th Street

Chicago, IL 60609 USA

Telephone: +(773) 869 1234

E-mail: [email protected]

Model #: SMX1200XLHG

SmartPro Medical Grade 1kVA 230V Line interactive Tower UPS, Extended-run, full isolation, USB and Serial

ports

Highlights

1000VA / 1kVA line interactive, extended run tower UPS

Maintains 230V nominal output over an input range of 155 to 274V

Professional features include serial port, IEC320 plug & outlets, built-in

isolation transformer

Input: IEC C14 inlet (230V 5A) / Output: 6 IEC C13 (230V)

Description

Tripp Lite's SMX1200XLHG offers medical-grade UPS protection with built-in line-interactive voltage regulation, expandable battery runtime and

intelligent monitoring with unattended shutdown capability. Tested to CE/IEC 60601-1 standard as medical electrical equipment. Built-in isolation

transformer with Faraday shield offers full line isolation and removes common mode noise while maintaining full AC surge suppression in all modes.

Includes high quality hospital-grade plug and outlets. Resistant to electrostatic discharge. 1000VA power handling capacity supports computers,

inter-networking equipment and other critical loads during commercial power failures. External battery connector allows configuration for up to

several hours of runtime during power failures by adding one or more external battery packs (BP36V15-2U limit 1 or BP36V42-3U multi-pack

compatible). Line interactive voltage regulation corrects brownouts as low as 155V and overvoltages as high as 274V back to normal 230V levels,

saving battery reserves for use only during complete power failures. Includes diagnostic LEDs and 2 built-in communications ports (1 USB, 1 DB9)

that work with included PowerAlert Software and cabling to provide automatic unattended shutdown of connected network and PC applications.

Applications

CE/IEC 60601-1 compliant UPS provides ultimate safety and reliability for patient point of care solutions, telemedicine, nurse's stations, wireless

communications systems, electronic prescribing applications, medical imaging and mission critical equipment. Not recommended for life support

applications

Package Includes

SMX1200XLHG Medical Grade Tower UPS System

PowerAlert Software and cabling

Warranty information

Instruction manual

Features

Ideal UPS protection for applications in medical patient-care areas where CE/IEC 60601-1 listed medical electrical equipment is required

Built-in isolation transformer with Faraday shield offers full isolation and removes common mode noise while maintaining full AC surge

suppression in all modes

Provides connected equipment with continuous power during short and long duration loss of commercial power

Expandable runtime is available with the addition of one or more external battery packs (BP36V15-2U limit 1 or BP36V42-3U multi-pack

compatible)

Line-interactive voltage regulation corrects brownouts and overvoltages from 155 to 274 volts back to usable 230V output levels, without

using battery power

Full line isolation prevents shock potential and operational problems in sensitive electronic equipment

Resistant to electrostatic discharge

Supports loads up to 1000VA/750W

27.5 min. half-load runtime (500VA/375W), 11 min. full load runtime (1000VA/750W)

6 protected outlets; 6-inch dongle with IEC C14 inlet

USB and DB9 communication ports

PowerAlert unattended shutdown software and complete cabling included

Complete surge protection, line isolation and EMI/RFI noise filtering

5 diagnostic LEDs indicate AC present, on battery, voltage correction, overload & battery low/replace

Battery replacement door and back panel grounding lug

Specifications

OUTPUT

Output Volt Amp

Capacity (VA)

1000

Output Watt Capacity

(watts)

750

Nominal Output

Voltage(s) Supported

230V

Frequency

compatibility

50/60 Hz (auto-selectable)

Output voltage

regulation (line mode)

-18%, +8%

Built-in UPS output

receptacles

6 C13 outlet(s)

INPUT

Rated input current (at

maximum load)

Nominal Input

Voltage(s) Supported

230V AC

UPS input connection

type

C14 inlet

UPS Input cord length

(ft.)

6 inch dongle, 16 gauge

UPS Input cord length

(m)

1.83

Recommended

Electrical Service

10A 230V

Voltage compatibility

(VAC)

230

BATTERY

Full load runtime

(minutes)

11 min. (750w)

Half load runtime

(minutes)

27.5 min. (375w)

Expandable battery

runtime

Supports extended runtime with optional BP36V15-2U (limit 1) and BP36V42-3U external battery pack (multi-pack

compatible)

External battery pack

compatibility

BP36V15-2U (limit 1); BP36V42-3U (multi-pack compatible)

DC system voltage

(VDC)

Battery recharge rate

(included batteries)

Less than 4.5 hours from 10% to 90%

Replacement battery

cartridge (internal

UPS battery

replacement)

RBC53

Battery Access Battery access door allows hot swap battery replacement without powering connected equipment off

Typical battery

lifespan

3-6 years, depending on usage

VOLTAGE REGULATION

Voltage regulation

description

Line interactive UPS offers 2 boost levels of brownout correction and a single level of overvoltage adjustment to

maintain usable, computer grade output without consuming battery power over an input voltage range of 155 to

274V AC.

Overvoltage correction Input voltages between 245 and 274V AC are reduced by 9%

Undervoltage

correction

Input voltages between 183 and 199 are boosted by 10%

Severe undervoltage

correction

Input voltages between 156 and 182 are boosted by 21%

Direct pass through Input voltages between 200 and 244V AC are passed through unchanged

LEDS ALARMS & SWITCHES

LED Indicators 5 LEDs indicate line power, battery power, overload, voltage regulation and battery low/replace status

Alarms 3 function audible alarm indicates power failure conditions (4 short beeps every 10 seconds), overload (continuous

short beeps) and low battery (continuous tone)

Switches Yes, includes 2 front panel mounted push-button switches for system enable, self-test and alarm cancel functions

SURGE / NOISE SUPPRESSION

UPS AC suppression

joule rating

340 joules

EMI / RFI AC noise

suppression

Yes

AC suppression

response time

Instantaneous

PHYSICAL

Installation form

factors supported with

included accessories

Tower

Installation form

factors supported with

optional accessories

Wallmount (UPSWM - tower mounting kit)

UPS / Power Module

dimensions in primary

form factor (height x

width x depth / inches)

12.7 x 7.5 x 9.1

UPS / Power Module

dimensions in primary

form factor (height x

width x depth / cm)

32.3 x 19 x 23.1

UPS / Power Module

weight (lbs)

45.5

UPS / Power Module

weight (kg)

20.7

UPS Shipping

dimensions (height x

width x depth / inches)

18.5 x 12.2 x 13.4

UPS Shipping

dimensions (height x

width x depth / cm)

47 x 31 x 34

Shipping weight (lbs) 48.8

Shipping weight (kg) 22

UPS housing material PVC

Cooling method UPS cooling via rear-exit fan

ENVIRONMENTAL

Operating

Temperature Range

+32 to +104 degrees Fahrenheit / 0 to +40 degrees Celsius

Storage Temperature

Range

+5 to +122 degrees Fahrenheit / -15 to +50 degrees Celsius

Relative Humidity 0 to 95%, non-condensing

AC mode BTU / hr.

(full load)

252.2

Battery mode BTU /

hr. (full load)

252.2

COMMUNICATIONS

Communications

interface

USB; DB9 Serial

Software and cabling

included

PowerAlert UPS monitoring software is included on CD-ROM for all common network and standalone operating

systems. Ships with 2 cables, 1-USB to USB & 1-DB9 to DB9

LINE / BATTERY TRANSFER

Transfer time 2-4 milliseconds

Low voltage transfer

to battery power

(setpoint)

155

High voltage transfer

to battery power

(setpoint)

274

SPECIAL FEATURES

Cold Start (startup in

battery mode during a

power failure)

Cold-start operation supported

Appearance Attractive gray tower UPS

CERTIFICATIONS

Certifications Tested to CE, IEC 60601-1 (Medical), Class B (Emissions)

WARRANTY

Product Warranty

Period (International)

2-year limited warranty

Product Warranty

Period (Mexico)

2-year limited warranty

Product Warranty

Period (Puerto Rico)

2-year limited warranty

Beliebte UPS Handbücher anderer Marken

Pylontech

Pylontech Victron & Pylontech US5000 Bedienungsanleitung

Tecnoware

Tecnoware EVO DSP PLUS MM 6.8 Bedienungsanleitung

Mustek

Mustek PowerMust 530(B) Plus Installations- und Betriebshandbuch

Emerson

Emerson Liebert NXL series Bedienungsanleitung

MAKELSAN

MAKELSAN BOXER SERIES Bedienungsanleitung

Block

Block PC-0524-400-0 Bedienungsanleitung

CyberPower

CyberPower CP585LCD Bedienungsanleitung

Eaton

Eaton 3S Montageanleitung

CyberPower

CyberPower Office Tower Series UPS 1000 Bedienungsanleitung

CyberPower

CyberPower BM100 Bedienungsanleitung

Best Power

Best Power 610 Bedienungsanleitung

Best Power

Best Power Unity/I UT3K Bedienungsanleitung

Mustek

Mustek PowerMust 400 Offline Bedienungsanleitung

Xantrex

Xantrex Trace 512 UR-UPS Bedienungsanleitung

Forza

Forza SL-1501UL Bedienungsanleitung

LEGRAND

LEGRAND keor 310081 Bedienungsanleitung

ABB

ABB Conceptpower DPA 500 Bedienungsanleitung

ZincFive

ZincFive BC Series Bedienungsanleitung