8
FIGURE 4
FIGURE 5
H1
H2
P2
P2
H3
H1
H3
H2
P20
P20
H4
H5
P4
Step 4
Attach 2 pieces Lock / Latches P20 into the cut outs on Leg Top End Apron P2 with Bolts H1,Washers H2 and
Nuts H3, then tighten, but DO NOT over tighten..
PARTS REQUIRED:
2 pcs - P2 Leg Top End Apron
8 pcs - H1 4 x 22mm Phillips Head Bolt
8 pcs - H4 6 x 40mm Allen Head Bolt 8 pcs - H5 6.5 x 16mm Flat Washer 8 pcs - H3 M4 Nylock Nut
8 pcs - H2 4.5 x 10mm Flat Washer
2 pcs - P3 Right Leg 2 pcs - P4 Left Leg 4 pcs - P20 Lock / Latch
Note : Predrilled holes
Note : This cut out at top.
Note : This cut out at top
Step 5
Attach the Right leg P3 and Left Leg P4 to the
Leg Top End Apron P2 by inserting Bolts H4 with
washers H5 into the predrilled holes of the leg and
into the Barrel Nuts, then tighten,
but DO NOT over tighten.
NOTE: Study diagram closely for
correct assembly. Before assembly
check each Barrel Nut with a Bolt H4 to
insure correct alignment between Barrel
Nut and Bolt H4. Adjust Barrel Nut as
required using a screwdriver.
NOTE: Correct
location of
Corner Braces
Barrel Nut
inside
H4
H5
P3
Please install Lock/Latches P20 exactly
per the diagram for correct operation.
Heads of
Barrel Nuts
this backside
Heads of
Barrel Nuts
this backside
T1
T1
