Mounting Options
Flush Mount
•The bottom of the vector compact has two holes for
flush mounting the unit to a flat surface .
6
Flush Mount Installation
•Create a drill template for the two mounting screws.
•Mark the hole centers onto the mounting surface using the drill template.
•Place the Vector Compact over the markings to ensure the planned hole
centers properly align.
•Use a nailset to mark the hole centers and drill the mounting holes to a
diameter of 6.5 mm (0.25”).
•Drill a 15 mm hole for the connector and pull the cable through the hole.
Connect to the Vector Compact and ensure that the connector locks with
a click.
•Place the Vector Compact over the mounting holes and insert the two M6
screws through the top. Secure the screws using washers and nuts,
preferably stainless steel (not supplied). Adjust the antenna using the
sight-line and tighten the screws.
Do not overtighten !
•Put the O-rings on each of the screw covers and place them over the
screw holes on the top of Vector Compact.
•
Warning: Overtightening the screws or connector may damage the unit!
Make sure that the vent hole is not covered !
Do not oversize the hole for
the connector to ensure
proper sealing
Drill the mounting holes to a
diameter of 6.5 mm (0.25”)
Recessed arrow located on the
bottom of the vector compact Vent hole
