2
zGREEN FUNCTION:
If the battery is discharging under no load, will shut down automatically to keep the
span life of battery
zFULL-TIME SURGE PROTECTION:
The power coming from the wall outlet may damage your equipment by the bad quality
power, but full-time Surge protection intercepts deadly electrical spike and prevents
hardware damage.
zEMI/RFI FILTERING:
The power coming from the wall outlet may damage your equipment by
electromagnetic or radio frequency interference. UPS intercepts the interference by
inductor and capacitor and provides clean power.
zINDICATOR
POWER & CHARGE GREEN LIGHT ON
BACK UP GREEN LIGHT FLASHING
OVER LOAD RED LIGHT ON & AUDIBLE ALARM, DISPLAY BEFORE
UPS SHUTDOWN AUTOMATICALLY
CHECK BATT RED LIGHT ON WHEN BATT FAULT
SAFETY INSTRUCTIONS
CAUTIONS
1. UPS is built in potential high voltage. Do not remove the case by yourself to get hurt.
Contact us or reseller if you have any question.
2. Do not pill any liquid on the Unit or inside the Unit.
3. Avoid putting the UPS near high humidity environment or near liquid, such as water,
chemical solution…
4. Avoid putting the UPS where it will be exposed to direct sunlight or any heat
surroundings
5. Keeping the hot holes smoothly to release the heart in UPS.
6. Using grounding input power cable to connect UPS.
7. Do not use UPS on laser Printer because of the high start-up current.
8. Do not use the UPS outlets on house electric equipment, such as hair dryer,air
conditioner, and refrigerator…
REPLACEMENTAND MAINTENANCE OFTHE BATTERY
1. Checking the quantity and the model number before replacing the battery.
2. Do not replace the battery by yourself, please call the professional people to do it.
3. While you are processing the battery, keep away fire to avoid explosion.
4. Do not open or damage the case of the battery, because it contains toxic electrolyte
that could be harmful your skin or eyes.
5. There are high voltage and current with in the battery. Please place it out of children
reach.
3
6. Maintaining the Battery --- If you do not use the UPS for long period of time, please
recharge the battery over 12 hours every 3 months.
GETTING STARTED
Unpacking Your UPS
Unpacking the UPS to check if the product is damaged, if you find any damage, call the vendor.
Installing UPS
zMake sure theAC power voltage is identical with the voltage in the rear panel of the UPS
zPress ON/TEST switch, the Green light “ON”, that meansAC power goes into the UPS.
zConnect the power strip on the computer or other peripherals to the outlets on the UPS. Then turn
on the computer, and then unplug the I/P power cord on the UPS to test the operation of the UPS.
zTurning on the UPS to recharge for 8 hours before using it. That can recharge the battery. You can
also use it before you recharge completely, but the back up time will be shorter than the full
battery capacity.
zTo turn off the UPS, please press ON/TEST switch until the LED light is “OFF”.
zDo not use UPS on Laser because of the high start-up current.
THE DISPLAY PANEL
The Front Panel:
The Rear Panel:
POWER
GREEN LED
RED LED
RJ11 COMMUNICATION
PORT
RJ45 MODEM/NETWORK
PROTECTION
UPS PROTECTION
OUTLETS
