Truvox Multiwash MW 340 Handbuch

Andere Handbücher für Multiwash MW 340

1

Inhaltsverzeichnis

Andere Truvox Schrubber Handbücher

Truvox

Truvox Orbis Battery Bedienungsanleitung

Truvox

Truvox Orbis MotorScrubber 20 Bedienungsanleitung

Truvox

Truvox Orbis Battery Scrubber II Bedienungsanleitung

Truvox

Truvox Multiwash 240 Bedienungsanleitung

Beliebte Schrubber Handbücher anderer Marken

Olympus

Olympus M200H Bedienungsanleitung

Clarke

Clarke BEXT 100H Installations- und Betriebsanleitung

JOHNY VAC

JOHNY VAC JVC70BCT Bedienungsanleitung

RCm

RCm Elan Series Handbuch

Kärcher

Kärcher B 120 W Bedienungsanleitung

Numatic

Numatic TTB 4045/100 Bedienungsanleitung

U.S. Products

U.S. Products PEX 500-C-TICK Betriebsanleitung

Mclennan

Mclennan C510 Bedienungsanleitung

Tennant

Tennant T20 LPG Bedienungsanleitung

Columbus

Columbus ARA 66 BM 100 Bedienungsanleitung

Numatic

Numatic TTV 678G / 300T Bedienungsanleitung

American-Lincoln

American-Lincoln 505-945 Bedienungsanleitung

Floorpul

Floorpul ruby 48 blt Benutzerhandbuch

Onyx

Onyx RX-34 Bedienungsanleitung

Dustbane

Dustbane Hurricane 400 Bedienungsanleitung

Sana

Sana EUJ-702 Bedienungsanleitung

REMS

REMS Twist Bedienungsanleitung

Tennant

Tennant 7200 Bedienungsanleitung

INSTRUCTION GUIDE

TRUVOX MULTIWASH MW340

SETTING MACHINE UP FOR USE

2

Remove machine

from the trolley by

undoing the Velcro

strap and ..

Tilt the machine

away from the

trolley and at the

same time pull the

top of the trolley

away from the

machine.

Fill the solution tank

by bucket with warm

water.

Finally twist the

cable catches to

release the cable.

Check the cable

and plug for dam-

age before using.

Using the Machine

3

Ensure that the

selector switch

on the side of the

machine is in the

up

position.

To start the ma-

chine, press red

foot latch with your

foot and pull back

the handle towards

you, the machine

will now start.

Pull the white D

handle to activate

the pump and spray

water onto the floor

in front of the

machine

Release some

water onto the

floor and then

move the ma-

chine over the

area to scrub

and pick up the

dirt.

Stopping and cleaning the Machine

4

When ready to

stop, push the

handle sharply

back to the up-

right position.

This will stop the

machine

Unplug machine

from power supply.

Remove the

recovery tank and

place to one side

Turn the brush anti-

clockwise to expose

the dirt build up on

the drum.

Remove this dirt with

a cloth and now turn

to expose the entire

drum wiping with a

clean cloth to ensure

completely clean

Cleaning the Machine

5

Take the

Recovery tank to

a sluice sink and

empty out dirty

water

Rinse out the Re-

covery tank and

rinse the under

aside of the tank as

well.

Lift the front box with

the spray nozzle on,

with a clean damp

cloth wipe the dirt

from the under side.

Must be cleaned

after every use!

Very Important

Cleaning the Machine

6

Remove the brushes

by push the retaining

rods in one side and

then pulling them out

the other side.

With a damp cloth

clean the machine

Replace brushes

and replace the

rods, twisting the

brush helps in lo-

cating the rods.

Make suet that the

rod protrudes

equally each side

Replace the recov-

ery tank.

Rewind the cable.

Replace on trolley by

pushing machine up at

an angle and locating

the hooks on the trolley

under the machine,

lower machine down

onto trolley and fasten

Velcro strap.

© Copyright A+D Supplies 2016 A+D Supplies, Marsh House, Brunel Road, Newton Abbot, Devon, TQ12 4PB www.adswsupplies.com