TSI Instruments DUSTTRAK 854060 Bedienungsanleitung

DUSTTRAK™AEROSOL MONITOR

SOLAR POWER KIT

MODEL 854060

(FOR DUSTTRAK™ II AND DRX AEROSOL MONITOR

MODELS 8540 AND 8543)

OPERATION AND MAINTENANCE MANUAL

P/N 6008416, REVISION B

JUNE 2016

Part Number

6008416A / Revision B / June 2016

Address

TSI Incorporated / 500 Cardigan Road / Shoreview, MN 55126 / USA

Fax No.

(651) 490-3824

LIMITATION OF WARRANTY AND LIABILITY (effective February 2015)

(For country-specific terms and conditions outside of the USA, please visit www.tsi.com.)

Seller warrants the goods, excluding software sold hereunder, under normal use and

service as described in the operator's manual, shall be free from defects in workmanship

and material for twenty-four (24) months, or if less, the length of time specified in the

operator's manual, from the date of shipment to the customer. This warranty period is

inclusive of any statutory warranty. This limited warranty is subject to the following

exclusions and exceptions:

a. Hot-wire or hot-film sensors used with research anemometers, and certain other

components when indicated in specifications, are warranted for 90 days from the

date of shipment;

b. DustTrak internal pump for Models 8530 and 8533 is warranted for two (2) years or

4000 hours, whichever comes first;

c. DustTrak External pump for Models 8530EP and 8533EP is warranted for two (2)

years or 8760 hours, whichever comes first;

d. Environmental DustTrak pump for Models 8540 and 8543 is warranted for two (2)

years or 8760 hours, whichever comes first;

e. Parts repaired or replaced as a result of repair services are warranted to be free from

defects in workmanship and material, under normal use, for 90 days from the date of

shipment;

f. Seller does not provide any warranty on finished goods manufactured by others or on

any fuses, batteries or other consumable materials. Only the original manufacturer's

warranty applies;

g. This warranty does not cover calibration requirements, and seller warrants only that

the instrument or product is properly calibrated at the time of its manufacture.

Instruments returned for calibration are not covered by this warranty;

h. This warranty is VOID if the instrument is opened by anyone other than a factory

authorized service center with the one exception where requirements set forth in the

manual allow an operator to replace consumables or perform recommended

cleaning;

i. This warranty is VOID if the product has been misused, neglected, subjected to

accidental or intentional damage, or is not properly installed, maintained, or cleaned

according to the requirements of the manual. Unless specifically authorized in a

separate writing by Seller, Seller makes no warranty with respect to, and shall have

no liability in connection with, goods which are incorporated into other products or

equipment, or which are modified by any person other than Seller.

The foregoing is IN LIEU OF all other warranties and is subject to the LIMITATIONS

stated herein. NO OTHER EXPRESS OR IMPLIED WARRANTY OF FITNESS FOR

PARTICULAR PURPOSE OR MERCHANTABILITY IS MADE. WITH RESPECT TO

SELLER’S BREACH OF THE IMPLIED WARRANTY AGAINST INFRINGEMENT, SAID

WARRANTY IS LIMITED TO CLAIMS OF DIRECT INFRINGEMENT AND EXCLUDES

CLAIMS OF CONTRIBUTORY OR INDUCED INFRINGEMENTS. BUYER’S

EXCLUSIVE REMEDY SHALL BE THE RETURN OF THE PURCHASE PRICE

DISCOUNTED FOR REASONABLE WEAR AND TEAR OR AT SELLER’S OPTION

REPLACEMENT OF THE GOODS WITH NON-INFRINGING GOODS.

TO THE EXTENT PERMITTED BY LAW, THE EXCLUSIVE REMEDY OF THE USER OR

BUYER, AND THE LIMIT OF SELLER'S LIABILITY FOR ANY AND ALL LOSSES,

INJURIES, OR DAMAGES CONCERNING THE GOODS (INCLUDING CLAIMS BASED

ON CONTRACT, NEGLIGENCE, TORT, STRICT LIABILITY OR OTHERWISE) SHALL

BE THE RETURN OF GOODS TO SELLER AND THE REFUND OF THE PURCHASE

PRICE, OR, AT THE OPTION OF SELLER, THE REPAIR OR REPLACEMENT OF THE

GOODS. IN THE CASE OF SOFTWARE, SELLER WILL REPAIR OR REPLACE

DEFECTIVE SOFTWARE OR IF UNABLE TO DO SO, WILL REFUND THE PURCHASE

PRICE OF THE SOFTWARE. IN NO EVENT SHALL SELLER BE LIABLE FOR LOST

PROFITS, BUSINESS INTERRUPTION, OR ANY SPECIAL, INDIRECT,

CONSEQUENTIAL OR INCIDENTAL DAMAGES. SELLER SHALL NOT BE

RESPONSIBLE FOR INSTALLATION, DISMANTLING OR REINSTALLATION COSTS

OR CHARGES. No Action, regardless of form, may be brought against Seller more than

12 months after a cause of action has accrued. The goods returned under warranty to

Seller's factory shall be at Buyer's risk of loss, and will be returned, if at all, at Seller's risk

of loss.

Buyer and all users are deemed to have accepted this LIMITATION OF WARRANTY AND

LIABILITY, which contains the complete and exclusive limited warranty of Seller. This

LIMITATION OF WARRANTY AND LIABILITY may not be amended, modified or its terms

waived, except by writing signed by an Officer of Seller.

Service Policy

Knowing that inoperative or defective instruments are as detrimental to TSI as they are

to our customers, our service policy is designed to give prompt attention to any

problems. If any malfunction is discovered, please contact your nearest sales office or

representative, or call TSI's Customer Service department at (800) 874-2811 (USA) or

(001 651) 490-2811 (International) or visit www.tsi.com.

Trademarks

DustTrak™ and TrakPro™ are trademarks of TSI Incorporated. Netronix is a trademark

of Netronix Inc. Velcro is a registered trademark of Velcro Industries B.V.

Contents

Contents.............................................................................................. 1

Safety Information ............................................................................. 1

Description of Caution/Warning Symbols ................................................ 3

Caution and Warning Symbols................................................................ 3

Reusing and Recycling............................................................................ 4

Product Overview .............................................................................. 4

Setting Up ...........................................................................................4

Operation ..........................................................................................16

Overview ............................................................................................... 16

Specifications................................................................................... 17

2 DustTrak Aerosol Monitor Solar Power Kit Model 854060

Safety Information

W A R N I N G S

Use of components other than those specified by

TSI may impair the safety features provided by

the equipment.

The instrument has been design to be used with

batteries supplied by TSI. Do not use a substitute

Old batteries must be properly recycled in

accordance with the local environmental

regulations.

Do not use non-rechargeable batteries in this

instrument. Fire, explosions, or other hazards

may result.

If the solar power kit is used in a manner not

specified by the manufacturer, the protection

provided by the equipment may be impaired.

Do not connect the Solar Cells directly to the

854030 Environmental Enclosure as this may

result in damage. The Solar Cells must be

connected to the Solar Battery Enclosure Box so

they can be regulated by the Solar Charge

Controller.

C a u t i o n

The enclosure is designed to be water resistant

to rain or spray. It has a NEMA rating of 3R. It is

not designed to be waterproof when immersed.

Setting it in a pool of water will result in flooding

the inner compartment with water. This will

severely damage both your battery pack.

Do NOT set the Environmental Enclosure in

water!

Operation and Maintenance Manual 3

Description of Caution/Warning Symbols

Appropriate caution/warning statements are used throughout the

manual and on the instrument that require you to take cautionary

measures when working with the instrument.

Caution

C a u t i o n

Failure to follow the procedures prescribed in this

manual might result in irreparable equipment

damage. Important information about the operation

and maintenance of this instrument is included in

this manual.

Warning

W A R N I N G

Warning means that unsafe use of the instrument

could result in serious injury to you or cause

damage to the instrument. Follow the procedures

prescribed.

Caution and Warning Symbols

The following symbols may accompany cautions and warnings to

indicate the nature and consequences of hazards:

Warns that the instrument contains a laser and that

important information about its safe operation and

maintenance is included in the manual.

Warns that the instrument is susceptible to electro-

static discharge (ESD) and ESD protection should

be followed to avoid damage.

Indicates the connector is connected to earth

ground and cabinet ground.

4 DustTrak Aerosol Monitor Solar Power Kit Model 854060

Reusing and Recycling

As part of TSI Incorporated’s effort to have a minimal

negative impact on the communities in which its

products are manufactured and used:

Do not dispose of used batteries in the trash.

Follow local environmental requirements for

battery recycling.

If instrument becomes obsolete, return to TSI for

disassembly and recycling.

Product Overview

The solar power kit provides power to allow continuous monitoring of

Model 854030 Environmental Enclosure.

Setting Up

W A R N I N G

Refer to Solar charger manual for further installation

and operation instructions.

The setup of the Environmental Enclosure is an important part in

allowing reliable and accurate sampling of aerosols in a wide range of

conditions. TSI cannot ensure accurate measurements if any of the

components are set up incorrectly. Failure to follow these procedures

could result in damage to the enclosure or its components.

Note

Prior to using the Battery Pack for the first time, a full

recharge is recommended. Recharging Battery Pack(s)

immediately after use (within one hour maximum) is

critical to obtaining optimal recharge time, battery

health, and battery life.

Operation and Maintenance Manual 5

The full Solar Cell Power System is shown in Figure 1. The following

section details the setup of this system.

I m p o r t a n t

Make all Solar Cell Power System electrical connections

in the order outlined below. Damage to the system can

occur if connections are not made in this order.

Figure 1: Solar Cell Power System

1. Remove the Solar Battery from its packaging and place it in the

Solar Battery Enclosure box. Make sure that the battery positive

(+) terminal is on the left (the positive terminal is noted on the

battery with a RED marking). Remove the battery terminals using

an adjustable wrench and connect the ring terminal ended wires

from the solar charge controller to the battery terminals (see

Figure 2).

Note

There are two wires coming from the charge controller:

one is BLACK and is labeled (+); the other is WHITE and

is labeled (–).

The BLACK (+) wire should be connected to the battery

positive (+) terminal, which has a red marking on the top

of the battery.

The WHITE (–)wire should be connected to the battery

negative (–)terminal.

6 DustTrak Aerosol Monitor Solar Power Kit Model 854060

Figure 2: Install the Solar Battery and Connect to Controller

2. The next step is to attach the provided power cables with

waterproof connectors to each Solar Cell.

Remove the Solar Cell from its packaging and access the junction

box on the end of the panel. Remove the screws and sealing strip

from inside the box and set aside. Remove the center of one of

the access holes which is labeled ½”. Pass the power cable

through that access hole while attaching the individual pieces of

the cable strain relief, as shown in Figure 3.

Figure 3: Strain Relief and Power Cable through Access Hole

Andere Handbücher für DUSTTRAK 854060

Inhaltsverzeichnis

Andere TSI Instruments Solarpanel Handbücher

TSI Instruments

TSI Instruments 8145-SO Bedienungsanleitung

Beliebte Solarpanel Handbücher anderer Marken

Navitron

Navitron HFC-2 Bedienungsanleitung

AXITEC

AXITEC 60-CELL Bedienungsanleitung

thermital

thermital TSOL 20 N BLU Bedienungsanleitung

AZO Digital

AZO Digital MPPT-3000 Bedienungsanleitung

Clenergy

Clenergy PV-ezRack SolarTripod Bedienungsanleitung

Beretta

Beretta SCF-20N Bedienungsanleitung

moovo

moovo KSM001 Produkthandbuch

solarwatt

solarwatt EasyIn 60M Series Bedienungsanleitung

Solarland

Solarland Portable Series Handbuch

Ubiquiti

Ubiquiti sunMAX Bedienungsanleitung

Lippert

Lippert Furrion FSFP37MW-BL Bedienungsanleitung

Sonnenkraft

Sonnenkraft GK5-HP Bedienungsanleitung

REC

REC TwinPeak 2S Mono 72 Series Bedienungsanleitung

Sunforce

Sunforce 50039 Bedienungsanleitung

Flexsolar

Flexsolar C100 Leitfaden

Süd Solar

Süd Solar 03005 Bedienungsanleitung

Kodak

Kodak SP21 Bedienungsanleitung

Carmanah

Carmanah Go Power! Solar Flex GP-FLEX-30 Bedienungsanleitung