Tucker GTR S Bedienungsanleitung
1
GTR S / ST AND GTR SS / ST
SIDE BURNER
ASSEMBLY, INSTALLATION AND OPERATING
INSTRUCTION MANUAL
IMPORTANT –PLEASE READ ALL INSTRUCTIONS BEFORE
YOU ASSEMBLE, INSTALL OR OPERATE THIS APPLIANCE.
2
IMPORTANT
Tucker side burners are approved for outdoor use only
Do not use indoors or in any enclosed area.
Always turn off gas supply when you finish using this
appliance.
Always use your barbecue and side burner on a level
surface.
Attend an operating side burner at all times as oil and fat
can be highly flammable.
Damage from fat and grease fires is not covered by
warranty.
Retain this manual for future reference
WARNINGFOR YOUR SAFETY
FOR YOUR SAFETY
If you smell gas:
1. Shut off gas to the appliance.
2. Extinguish any open flame.
3. Open the lid or hood.
4. If odour continues, immediately call your gas supplier or your fire
department.
Failure to follow these instructions may cause serious bodily
injury or damage to property.
Read all instructions carefully before assembly and usage of this
appliance.
Don’t store spare gas bottles, petrol, flammable vapours or liquids
in the vicinity of this appliance.
Do not store flammable liquids in, on or under the barbecue.
Always leak test /check hose connections after filling cylinders.
Check cylinder condition for rust and that the date stamp is
current as every gas cylinder in Australia must be pressure tested
every ten years.
Never disconnect the side burner whilst it is running.
Do not modify the side burner in any way.
Do not allow children to operate the appliance.
- 3 -
If a grease/fat fire should arise, turn off the gas supply
immediately until extinguished.
Always open the lid or hood before lighting.
Never check for leaks with a match or open flame.
Do not store or use gasoline or other flammable vapours and
liquids in the vicinity of this appliance.
Do not move the appliance during use.
Do not obstruct any ventilation of the barbecue, side burner or
gas cylinder.
Unsupervised children should not be near a barbecue or side
burner while cooking or during warm up or cool down.
When lighting, do not allow build up of unburned gas.
Never leave the burner on high for more than 10 minutes unless
you are cooking.
HAZARDOUS FIRE OR EXPLOSION MAY RESULT IF
INSTRUCTIONS ARE IGNORED!
It is the consumer’s responsibility to see that the side burner is properly
assembled, installed and taken care of. Failure to follow instructions in
this manual could result in bodily injury and /or property damage.
4
ASSEMBLY INSTRUCTIONS
1. Check that you have the correct gas type side burner. i.e. propane
gas or natural gas.
2. Remove all the packaging material, cable ties and plastic coatings
from the side burner.
3. Check you have all the correct components.
GTR S SIDE BURNER GTR SS SIDE BURNER
1 X Side Burner Body, 1 X Side burner Body
1 X Burner Top, 1 X Large Trivet Outer Ring
1 X Large Enamel Outer Ring, 1 X Small Trivet Inner Ring
1 X Small Enamel Inner Ring.
NOTE (GTR ST AND GTR SST ARE TROLLEY MOUNT OPTION SIDE
BURNERS)
ATTACHMENT OF GTR ST and GTR SST SIDE
BURNER TO A GTS OR GTR CABINET
1. Remove the 4 bolts holding
the right hand side shelf from
your existing stand.
2. Replace the shelf with the
side burner using the 4 bolts
3. Tighten the bolts back up.
- 5 -
INSTALLATION INSTRUCTIONS
This barbecue is designed and approved for outdoor use only.
Be mindful of the location of installation of the BBQ. It is better that the
prevailing wind blows into the front of the BBQ during cooking as strong winds
blowing into the back or across the back of the hood whilst cooking with the
hood closed can cause overheating of the BBQ. This is because the hot air
retained in the hood during cooking cannot be released naturally from the rear
vent of the hood in strong winds.
Do not use this appliance indoors or on marine craft.
This appliance shall only be used in an above ground, open-air situation with
natural ventilation, without stagnant areas where gas leakage and products of
combustion are rapidly dispersed by wind and natural convection.
Any enclosure in which the appliance is used shall comply with one of the
following:
An enclosure with walls on all sided, but at least one permanent
opening at ground level and no overhead cover.(figure 1)
Within a partial enclosure that includes an overhead enclosure and no
more than two walls.(figure 2)
Within a partial enclosure that includes an overhead cover and more
than two walls, the following shall apply.(figure 3,4 ,5)
(a.) At least 25% of the total wall area is completely open.
(b.) At least 30% of the remaining wall area is open and unrestricted.
In the case of balconies, at least 20% of the total of the side, back and
front wall areas shall be and remain open and unrestricted.
6
DIAGRAMMATICAL REPRESENTATIONS
OF OUTDOOR AREAS
The following figures are diagrammatical representations of outdoor areas. The
areas used in the figures below are examples –the same principles apply to any
other shaped area.
BOTH ENDS OPEN.
FIGURE F1 –OUTDOOR AREA –EXAMPLE 1
FIGURE F2 –OUTDOOR AREA –EXAMPLE 2
- 7 -
FIGURE F3 –OUTDOOR AREA –EXAMPLE 3
FIGURE 4 OUTDOOR AREA –EXAMPLE 4
Both ends open
Open side at
least 25% of
total wall area
30% or more in total
of the remaining wall
area is open and
unrestricted.
8
OPEN AT SIDE AT LEAST 25% OF TOTAL WALL AREA.
30% OR MORE IN TOTAL OF THE REMAINING WALL AREA IS OPEN AND
UNRESTRICTED
OPEN SIDE AT LEAST 25% OF TOTAL WALL AREA.
30% OR MORE IN TOTAL OF THE REMAINING WALL AREA IS OPEN AND
UNRESTRICTED.
FIGURE F5 –OUTDOOR AREA –EXAMPLE 5
Open side at
least 25% of
total wall area
30% or more in total
of the remaining
wall area is open
and unrestricted.
- 9 -
GTR S AND GTR SS need new sizes
360
470
50
Hole size on bench top to fit
bottom lip of the side burner:
Width
Depth
325mm
445mm
NOTE: The optional built in or intergrated side burner gas consumption is below.
TECHNICAL DATA
The nominal gas consumption of the GTR S and GTR SS Side Burner.
Model Gas type Injector Pressure Input AGA
GTR S Propane 1mm 2.8 kpa 12mj/hr
GTR S Natural 1.6mm 1 kpa 12mj/hr
GTR SS Propane 1.2mm 2.8 kpa 18mj/hr
GTR SS Natural 1.9mm 1kpa 18mj/hr
TUCKER GTR S and GTR SS SIDE BURNERS ARE MADE AND APPROVED TO
AUSTRALIAN STANDARDS A.G.A. APPROVAL 8236 G
For LP Gas connections, an approved 2.8 KPA regulator and hose assembly must
be used.
DIMENSIONS FOR BUILDING GTR S and GTR SS
SIDE BURNER INTO BRICKWORK
INTO BRICKWORK.
10
The appliance inlet is 3/8 S.A.E. male and is located at the front underneath the side
burner.
The minimum capacity propane cylinder for this side burner is 4 KG.
The intended use of this side burner is to be installed onto a Tucker GTS or GTR Trolley
or alternatively it may be set into brickwork or the like with the following clearances to
combustibles.
Minimum Top Clearance - Allow 800mm
Minimum Side Clearance - Allow 200mm
Minimum Rear Clearance - Allow 200mm
Be sensible about the location of your side burner.
The barbecue and side burner must be located on firm and level ground.
Do not locate the barbecue or side burner near combustible materials or surfaces,
either above or around the sides.
Do not obstruct any of the air ventilation openings, under or around the sides of the side
burner.
Connection of a side burner to a BBQ and or gas cylinder is as
follows.
For the attachment of a GTR ST or GTR SST Side Burner you will need to
disconnect the hose from the BBQ and re-connect it to the right hand side of the
side burner. Then connect the shorter hose supplied with the side burner to the left
hand side of the side burner and the other end to the BBQ inlet.
The hose connections must be connected firmly with a spanner.
Check that the hose is not kinked or under tension.
Apart from the connection point the hose must not be touching any part of the
barbecue or side burner where it may get hot and be damaged.
Dieses Handbuch passt für folgende Modelle
2
Inhaltsverzeichnis
