Tudelu Closure Bedienungsanleitung
1
Installation Manual
SYSTEM:
Closure
2
3
TABLE OF CONTENTS
PRE-INSTALLATION CHECKLIST
BOXES CHECKLIST 4
TOOLS CHECKLIST 5
HOUSING UNIT:
INSIDE THE BOX 6
INSTALLATION 7
LASER CHECK 8
TUBE UNIT:
INSIDE THE BOX 9
INSTALLATION 10
REMOTE CONNECTION 11
WALL PANEL:
INSIDE THE BOX 12
INSTALLATION 14
SIDE GUIDE:
INSIDE THE BOX 16
INSTALLATION 17
BOTTOM HOUSING COVER 18
MOTOR LIMITS 19
4
Before getting started,
A. make sure you received each of the following boxes.
Housing Unit
Wall Panel
Tube and Bottom Bar
Side Guide
BOXES CHECKLIST
Boxes Checklist
5
TOOLS CHECKLIST
Tools Checklist
These are the tools you'll need to install your system.
Extension cord
Tape measure
Drill
Revit Gun Flat screwdriver
Ladder
laser
Stapler
Saw
With Aluminum Blade
Drill Bits
Leveler
Material ifter
6
HOUSING UNIT: INSIDE THE BOX
Motor bracket
Idler bracket
Unit connector Housing cover
Housing
(amount of units depends on the
legth of your specific system)
Housing unit: inside the box
7
END RESULT
Lift up one housing unit Lift motor bracket and side up to
end of housing unit
NOTE: start with the side closest to the room power
INSTRUCTIONS
Insert screws to top of motor
bracket and tighten into ciling
Insert unit connector in between
units
Repeat with second housing and
idler bracket
Insert screws on either side of unit
connector and tighten very well
HOUSING UNIT: INSTALLATION
Housing unit: installation
8
Use the laser to ensure the housing units is leveled
Double check both sides using a laser and a tape measurer
NOTE: it is extremely importan that all housing units are the same exact height.
Make sure there is no space between housing units
HOUSING UNIT: LASER CHECK
Housing unit: laser check
9
TUBE UNIT: INSIDE THE BOX
Motor End
Idler end
Kedar side
Tube unit: inside the box
10
Use material lift to raise tube housing system
INSTRUCTIONS
Insert motor end of tube into the
motor bracket
Insert pin to secure the tube
NOTE: make sure the wire is not
stuck in the pin
Insert idler end of tube into the idler
bracket
Secure the wire by sliding the
motor end of the tube all the way
into the motor bracket
NOTE: if you want the wire to hang or the side of the housing, bringin to the side now
, otherwise leave the wire in the back
Connect wire to the rooms
electricity
Insert pin to secure the tube
TUBE: INSTALLATION
Tube: installation
Inhaltsverzeichnis
Andere Tudelu Jalousie Handbücher
