Twinkly Pro TWPRO1000ETHP Bedienungsanleitung
USERGUIDE
TWPRO1000ETHP
REV 1.200402
Table of content
INTRODUCTION
PACKAGE CONTENT
INSTALLATION PROCESS
CONNECT LIGHTS STRINGS
POWERING UP THE CONTROLLER
CONNECT TO YOUR NETWORK
ETHERNET CABLE SETUP
MULTI-CONTROLLER SETUP
NETWORKING LAYOUT FOR MULTIPLE CONTROLLERS
APPLICATION SETUP
TROUBLESHOOTING
3
4
5
6
7
8
9
10
11
13
24
2
Introduction
Thank you for choosing Twinkly Pro for your lighting needs.
This manual will provide detailed instructions, guide you through the entire setup process, and assist
you with the recommended installation procedure for your device(s).
By reading this step-by-step guide you will:
- Avoid making common installation mistakes;
- Learn the technical and practical knowledge needed to operate and manage your device(s) properly;
- Minimize the need for Technical Support;
- Help create the best experience possible for you and your customers.
At the end of this manual, complete the ‘pre-ight’ checklist and be ready to decorate like a boss!
Sincerely,
THE TWINKLY PRO TEAM
3
Package
Content
1x Power Adapter
1x Ethernet Controller TWPRO1000ETHP
1x Ethernet Cable Gland
Equipment
Description
4CAT 5 Ethernet Cable
5Controller
6Light Strings
1AC/DC Power Adapter
2Ethernet Cable Gland
3Router
1
5
32
4
6
4
MODEL
TWPRO1000ETHP
Installation
Process
5
STEP 1
Connect
Lights Strings
NOTE
We recommend installing lights strings before
connecting them to the controller(s).
1 2
INSTALLATION PROCESS
6
STEP 2
Powering up the
Controller
Connect power cable to the controller Connect the power adapter to a power socket
If no CAT 5 cable is connected make
sure cap is closed tight to prevent
water inltration
1 2
3
INSTALLATION PROCESS
Your controller is now powered up.
DC CABLE
AC CABLE
AC CABLE
DC CABLE
7
STEP 3
Connect to your
Network Use Network Switch for installations requiring
more controllers
Connect to WAN port for installations to be controlled remotely and to have full access to all the Twinkly app features during
conguration and devices control.
TIP
NOTE
For multiple controller installations see page 12
for recommended networking method.
INSTALLATION PROCESS
Connect CAT 5 cable to an open port on router
(not WAN)
Connect the other end of CAT 5 cable to the
controller
1 2
3You are connected!
DC CABLE
ETH CABLE
8
STEP 4
Make IP65the
Ethernet Cable
INSTALLATION PROCESS
Materials and tools
needed
1
Use the crimping tool
to cut one end of the
ethernet cable
2
Cut the end of the
cable
3
Insert the ethernet
cable gland provided
with the Twinkly Pro
Kit
4
Remove the sheath
5
The wires are grouped
two-by-two
6
Unroll the groups of
wires till you have 8
single wires
7
Sort the wires in the
order indicated by the
graphic in the image
above
8
Flatten the wires - the
connector must have
the clip at the bottom
and the sheath must
touch the edge
9
Insert the connector
in the crimping tool
and crimp to hold the
wires in place
10
Insert the connector
in the ethernet cable
gland
11
The cable is ready to
be connected to the
controller
12
9
VERTIGO
Multi-controller
Setup
Twinkly App functions for
multi-controller installations:
- Grouping (*)
- Join
- Sync
- Scenes
- Mapping
* see page 25
for more details
4,000 BULB
INSTALLATION
INSTALLATION PROCESS
10
Inhaltsverzeichnis
Andere Twinkly Pro Controller Handbücher
