Tyco Fire Product Star Pulsar ESFR-1 Bedienungsanleitung

Early Suppression Fast Response

Pendent Sprinklers,

Pulsar™ ESFR-1, K=14.0

GENERAL DESCRIPTION

The Star Pulsar ESFR-1 Sprinklers (Ref. Figure 1) are

“Early Suppression Fast Response Sprinklers” having a

nominal K-factor of 14.0. They are suppression mode

sprinklers, and their use is especially advantageous as a

means of eliminating the use of in-rack sprinklers, when

protecting high-piled storage.

The Pulsar ESFR-1 is primarily designed for use with stor-

age heights of most encapsulated or non-encapsulated

common materials including cartoned unexpanded plas-

tics of up to 35 ft. (10,7 m). In addition, the protection of

some storage arrangements of roll paper and rubber tires

can be considered as well.

Applications for the Pulsar ESFR-1 Sprinklers are expand-

ing beyond the current recognized installation standards.

For information regarding research fire tests which may

be acceptable to an Authority Having Jurisdiction (e.g.,

flammable liquids, aerosols, etc.), please contact the

Technical Services Department.

WARNINGS

The Pulsar ESFR-1 Sprinklers described herein must be

installed and maintained in compliance with this docu-

ment, as well as with the applicable standards of the Na-

tional Fire Protection Association, in addition to the stand-

ards of any other authorities having jurisdiction (e.g.,

Factory Mutual Research Corporation). Failure to do so

may impair the integrity of these devices.

The owner is responsible for maintaining their fire protec-

tion system and devices in proper operating condition.

The installing contractor or sprinkler manufacturer should

be contacted relative to any questions.

OPERATION

The fusible link (heat collector) assembly is comprised of

two link halves which are joined together by a thin layer

of solder. When the rated temperature is reached, the sol-

der melts and the two link halves separate, which then al-

lows the sprinkler to activate and flow water.

TECHNICAL DATA

Approvals

UL and ULC Listed. FM and LPC Approved.

(UL and ULC Listings, as well as FM Approvals, only ap-

ply to the service conditions indicated in the Design

Criteria section.)

VdS Approved; however, the use of the ESFR-1 is re-

quired to be agreed upon by the VdS for each application.

Maximum Working Pressure

175 psi (12,1 bar)

Pipe Thread Connection

3/4 inch NPT or ISO 7-R3/4

Discharge Coefficient

K = 14.0 GPM/psi1/2 (201,6 LPM/bar1/2)

Temperature Ratings

165°F/74°C or 214°F/101°C

Finish

Natural Brass

Physical Characteristics (Ref. Figure 1)

The Pulsar ESFR-1 utilizes a dezincification resistant

bronze alloy frame. The strut and hook are monel; and,

the button, deflector, and compression screw are bronze.

The gasketed spring plate consists of a beryllium nickel

disc spring that is sealed on both its inside and outside

edges with a Teflon



gasket, and the two halves of the fus-

ible link assembly are nickel.

Patents

U.S.A. Patent Number 4,580,729 and 4,901,799 are appli-

cable to the Pulsar ESFR-1.

SIN S8000



DuPont Registered Trademark

Customer Service/Sales: Tel: (800) 558-5236 • Fax: (414) 570-5010

Technical Services: Tel: (800) 381-9312 • Fax: (800) 791-5500 3-01

1-4.1.10

TYCO FIRE PRODUCTS

OBSOLETE

DESIGN CRITERIA

UL and ULC Listing Criteria

The Pulsar ESFR-1 (SIN S8000) Sprinklers are UL and

ULC Listed as “Early Suppression Fast Response Sprin-

klers” for installation per NFPA 13 or other applicable

NFPA standards up to a maximum ceiling height of 40 ft.

(12,2 m).

FM Approval Criteria

The Pulsar ESFR-1 (SIN S8000) Sprinklers are FM Ap-

proved as “Early Suppression Fast Response Sprinklers”

for installation per the applicable FM Loss Prevention

Data Sheets up to a maximum ceiling height of 45 ft.

(13,7 m).

INSTALLATION

The Pulsar ESFR-1 Pendent Sprinklers must only be in-

stalled in the pendent position. With pipe thread sealant

applied to the pipe threads, use only the W-Type 2

Sprinkler Wrench (Figure 2) for installation of the Pulsar

ESFR-1 by applying the wrench to the sprinkler wrench

flats only.

NOTE

A leak tight 3/4 inch NPT sprinkler joint should be ob-

tainedwithatorqueof10to20ft.lbs.(13,4to26,8Nm).

A maximum of 30 ft.lbs. (40,7 Nm) of torque is to be used

to install sprinklers. Higher levels of torque may distort

the sprinkler inlet with consequent leakage or impairment

of the sprinkler.

CARE AND MAINTENANCE

The Pulsar ESFR-1 must be maintained and serviced in

accordance with the following instructions:

NOTE

Before closing a fire protection system main control valve

for maintenance work on the fire protection system which

it controls, permission to shut down the affected fire pro-

tection systems must be obtained from the proper authori-

ties and all personnel who may be affected by this action

must be notified.

Sprinklers which are found to be leaking or exhibiting vis-

ible signs of corrosion must be replaced.

Automatic sprinklers must never be shipped or stored

where their temperature will exceed 100°F/38°C and they

must never be painted, plated, coated, or otherwise al-

tered after leaving the factory. Modified or over-heated

sprinklers must be replaced.

Care must be exercised to avoid damage - before, dur-

ing, and after installation. Sprinklers damaged by drop-

ping, striking, wrench twist/slippage, or the like, must be

replaced.

The owner is responsible for the inspection, testing, and

maintainance of their fire protection system and devices

in compliance with this document, as well as with the ap-

plicable standards of the National Fire Protection Associa-

tion (e.g., NFPA 25), in addition to the standards of any

other authorities having jurisdiction. The installing contrac-

tor or sprinkler manufacturer should be contacted relative

to any questions.

It is recommended that automatic sprinkler systems be in-

spected, tested, and maintained by a qualified Inspection

Service.

STAR SPRINKLER

Page 2 1-4.1.10

FIGURE 1

PULSAR ESFR-1 PENDENT SPRINKLER

1/2" (12.7 mm)

NOMINAL MAKE-IN

WRENCH FLAT

(BOTH SIDES)

3-9/16"

(90.5 mm)

TEMPERATURE

RATING

3/4" NPT

1-7/8" (47.6 mm)

FIGURE 2

W-TYPE 2

SPRINKLER

WRENCH

"FITTING SIDE"

FITTING

TOWARDS SPRINKLER

RECESS

WRENCH

OBSOLETE

LIMITED WARRANTY

Products manufactured by Tyco Fire Products are war-

ranted solely to the original Buyer for ten (10) years

against defects in material and workmanship when paid

for and properly installed and maintained under normal

use and service. This warranty will expire ten (10) years

from date of shipment by Tyco Fire Products. No warranty

is given for products or components manufactured by

companies not affiliated by ownership with Tyco Fire Prod-

ucts or for products and components which have been

subject to misuse, improper installation, corrosion, or

which have not been installed, maintained, modified or re-

paired in accordance with applicable Standards of the Na-

tional Fire Protection Association, and/or the standards of

any other Authorities Having Jurisdiction. Materials found

by Tyco Fire Products to be defective shall be either re-

paired or replaced, at Tyco Fire Products’ sole option.

Tyco Fire Poducts neither assumes, nor authorizes any

person to assume for it, any other obligation in connec-

tion with the sale of products or parts of products. Tyco

Fire Products shall not be responsible for sprinkler sys-

tem design errors or inaccurate or incomplete information

supplied by Buyer or Buyer’s representatives.

IN NO EVENT SHALL TYCO FIRE PRODUCTS BE LI-

ABLE, IN CONTRACT, TORT, STRICT LIABILITY OR UN-

DER ANY OTHER LEGAL THEORY, FOR INCIDENTAL,

INDIRECT, SPECIAL OR CONSEQUENTIAL DAMAGES,

INCLUDING BUT NOT LIMITED TO LABOR CHARGES,

REGARDLESS OF WHETHER TYCO FIRE PRODUCTS

WAS INFORMED ABOUT THE POSSIBILITY OF SUCH

DAMAGES, AND IN NO EVENT SHALL TYCO FIRE

PRODUCTS’ LIABILITY EXCEED AN AMOUNT EQUAL

TO THE SALES PRICE.

THE FOREGOING WARRANTY IS MADE IN LIEU OF

ANY AND ALL OTHER WARRANTIES EXPRESS OR IM-

PLIED, INCLUDING WARRANTIES OF MERCHANT-

ABILITY AND FITNESS FOR A PARTICULAR PUR-

POSE.

ORDERING PROCEDURE

Please Specify:

Pulsar ESFR-1 Pendent Sprinkler (#8000)

W-Type 2 Sprinkler Wrench (#8090)

Refer to Price List for for complete listing of Part Num-

bers with respect to temperature ratings, etc.

STAR SPRINKLER

1-4.1.10 Page 3

OBSOLETE

STAR SPRINKLER

Page 4 1-4.1.10

7071 S. 13th Street • Suite 103

Oak Creek, WI 53154

www.starsprinkler.com

PRINTED IN U.S.A. 3-01

OBSOLETE

Andere Tyco Fire Product Bewässerungssystem Handbücher

Tyco Fire Product

Tyco Fire Product CENTRAL ELO SW-20 Bedienungsanleitung

Tyco Fire Product

Tyco Fire Product D3 PROTECTOSPRAY Bedienungsanleitung

Tyco Fire Product

Tyco Fire Product Gem DS-1 Bedienungsanleitung

Tyco Fire Product

Tyco Fire Product CENTRAL K11 ECOH Bedienungsanleitung

Tyco Fire Product

Tyco Fire Product Gem F917 Bedienungsanleitung

Tyco Fire Product

Tyco Fire Product CENTRAL B Bedienungsanleitung

Tyco Fire Product

Tyco Fire Product CENTRAL RFII Series Bedienungsanleitung

Tyco Fire Product

Tyco Fire Product CENTRAL A Bedienungsanleitung

Tyco Fire Product

Tyco Fire Product Star E Bedienungsanleitung

Tyco Fire Product

Tyco Fire Product Gem DS-1 Series Bedienungsanleitung

Tyco Fire Product

Tyco Fire Product CENTRAL Attic BB1-17/32 Bedienungsanleitung

Tyco Fire Product

Tyco Fire Product RAPID RESPONSE LFII Series Bedienungsanleitung

Tyco Fire Product

Tyco Fire Product CENTRAL K17-231 Bedienungsanleitung

Tyco Fire Product

Tyco Fire Product SIN S3230 Bedienungsanleitung

Tyco Fire Product

Tyco Fire Product Star Galaxy SG-RES Bedienungsanleitung

Tyco Fire Product

Tyco Fire Product CENTRAL TY-B Bedienungsanleitung

Tyco Fire Product

Tyco Fire Product CENTRAL H Bedienungsanleitung

Tyco Fire Product

Tyco Fire Product Gem FR-1 Bedienungsanleitung

Tyco Fire Product

Tyco Fire Product CENTRAL A-1 Bedienungsanleitung

Tyco Fire Product

Tyco Fire Product CENTRAL BVR Bedienungsanleitung

Tyco Fire Product

Tyco Fire Product Star Galaxy SG-R Bedienungsanleitung

Tyco Fire Product

Tyco Fire Product CENTRAL CC1 Bedienungsanleitung

Tyco Fire Product

Tyco Fire Product Star StarMax S102 Bedienungsanleitung

Tyco Fire Product

Tyco Fire Product CENTRAL Optima Bedienungsanleitung

Beliebte Bewässerungssystem Handbücher anderer Marken

Hunter

Hunter Institutional Series Bedienungsanleitung

Cellfast

Cellfast 52-305 Bedienungsanleitung

Oral Care Technologies

Oral Care Technologies Hydro Floss Bedienungsanleitung

Reliable

Reliable F1-300 Bedienungsanleitung

Netafim

Netafim NETBEAT Bedienungsanleitung

Irrigation-Mart

Irrigation-Mart KIT-GK100-RV-B Bedienungsanleitung

Tyco

Tyco CC3 Bedienungsanleitung

Reliable

Reliable F4FR Bedienungsanleitung

OpenSprinkler

OpenSprinkler OSPi Bedienungsanleitung

EINHELL

EINHELL GE-WW 5537 E Bedienungsanleitung

Valley

Valley Bender160 Bedienungsanleitung

Reliable

Reliable F1FR42 Series Bedienungsanleitung

Reliable

Reliable F1FR-300 Bedienungsanleitung

Toro

Toro 730 Series Kurzanleitung

Eden

Eden 97063-EDAMZ Bedienungsanleitung

Tyco

Tyco TY-L Series Bedienungsanleitung

Johnson Controls

Johnson Controls tyco ESFR-17 Bedienungsanleitung

Victaulic

Victaulic VicFlex I-VICFLEX.AQC-U Bedienungsanleitung