U-Line H-2721 Bedienungsanleitung

PAGE 1 OF 3 0515 IH-2721

πH-2721

DELUXE

PALLET TRUCK

1-800-295-5510

uline.com

OPERATION

TECHNICAL DATA

WARNING! Operator must read and understand

instructions here and on truck prior to use.

On the handle of the pallet truck, you will find the

control lever which can be set in three positions.

(See Figure 1)

- LOWER=to lower the forks

- NEUTRAL=to move the load

- RAISE=to raise the forks

1. If the forks elevate while pumping in the NEUTRAL

position, turn the setting screw clockwise until

pumping the handle does not raise the forks and

the NEUTRAL position functions correctly.

2. If the forks descend while pumping in the NEUTRAL

position, turn the setting screw counterclockwise

until the forks do not lower.

3. If the forks do not descend when the control lever is in

the LOWER position, turn the setting screw clockwise

until raising the control lever lowers the forks. Then

check the NEUTRAL position as per step 1 and 2.

4. If the forks do not lift while pumping in the RAISE

position, turn the setting screw counterclockwise

until the forks elevate while pumping in the RAISED

position. Then check the NEUTRAL and LOWER

position as per steps 1, 2 and 3.

NOTE: When viewing the truck from the handle

side, the setting screw is located on the right

side of the pump above the right wheel. The

truck will lower faster or slower depending on

how far in or out the screw is adjusted.

Figure 1

MODEL H-2721

Capacity 8,000 lbs.

Max. Fork Height 7.5"

Min. Fork Height 3"

Fork Length 48"

Overall Fork Width 27"

Fork Wheel Diameter 3" Polyurethane

Steering Wheel Diameter 7" Polyurethane

Net Weight 201 lbs.

PAGE 2 OF 3 0515 IH-2721

OIL

Check the oil level every six months. The oil capacity is

about 0.3L. Restore the fluid level in the reservoir to 5mm

below the top; this must be done with the forks in the

lowered position.

Use the hydraulic oil ISO-VG32 or equivalent. Oil viscosity

should be 30cSt at 104°.

HOW TO EXPEL AIR FROM THE PUMP UNIT

Air may enter the unit over time or when the seals are

replaced. To expel the air, lift the control lever to the

LOWER position and move the handle up and down

several times.

DAILY CHECK AND MAINTENANCE

Daily checks of the pallet truck can limit wear and tear

on the unit. Pay special attention to the wheels, the

axles, the handle, the forks and lift and lower control.

LUBRICATION

Use motor oil or grease to lubricate all moveable parts.

MAINTENANCE

SAFETY

NOTE: For safe operation of the Deluxe Pallet

Truck, read all warning signs and instructions

here and on the pallet truck prior to use.

1. Do not operate the truck unless you are familiar with

it and have been trained and authorized to do so.

2. Do not use the truck on sloping ground.

3. Never place any part of your body in the lifting

mechanism or under the forks or load. Do not carry

passengers.

4. We advise that operators wear gloves and safety

shoes.

5. Do not handle unstable or loosely stacked loads.

6. Do not overload the truck.

7. Always center loads on the forks, not at the end of

the forks. (See Figure 2)

8. The capacity of the truck assumes an evenly

distributed load with the center of the load being at

the halfway point of the length of the forks.

9. Make sure the length of the forks matches the length

of the pallet load.

10. Lower the forks to lowest height when the truck is not

being used.

Figure 2

A B

PAGE 3 OF 3 0515 IH-2721

OPERATING ISSUE CAUSES RECOMMENDATIONS

The forks do not lift to maximum height. Not enough hydraulic oil. Add more oil.

The forks do not raise. Not enough hydraulic oil.

The oil has impurities.

Discharge valve is out of adjustment.

Air in the hydraulic oil.

Add more oil.

Change the oil.

Adjust the setting screw. (As noted in

Operation)

Expel the air. (As noted in Maintenance)

The forks do not descend. The rod and the cylinder are deformed

from a seriously unbalanced load.

A part has been broken or been deformed

from an unbalanced load.

The setting screw is not in the correct position.

Replace the rod or cylinder.

Repair or replace component.

Adjust the setting screw. (As noted in

Operation)

Leaks Seals worn out or damaged.

Some parts may be cracked or worn out.

Replace seals with new ones.

Check and replace with new ones.

The forks descend without being

lowered.

Impurities in the oil cause the discharge valve to fail

to close.

Air in the oil.

Seals worn or damaged.

Discharge valve is out of adjustment.

Change the oil.

Expel the air. (As noted in Maintenance)

Replace with new ones.

Adjust the setting screw. (As noted in

Operation)

TROUBLESHOOTING

NOTE: Do not attempt to repair the Deluxe Pallet Truck unless you are trained and authorized to do so.

πCHICAGO • ATLANTA • DALLAS • LOS ANGELES • MINNEAPOLIS • NYC/PHILA • SEATTLE • MEXICO • CANADA

1-800-295-5510

uline.com

Andere Handbücher für H-2721

Andere U-Line LKW Handbücher

U-Line

U-Line H-2708 Bedienungsanleitung

U-Line

U-Line H-2917 Bedienungsanleitung

U-Line

U-Line H-1480 Bedienungsanleitung

U-Line

U-Line H-1387 Bedienungsanleitung

U-Line

U-Line H-1826 Bedienungsanleitung

U-Line

U-Line Big Joe H-4709 Bedienungsanleitung

U-Line

U-Line H-1201 Bedienungsanleitung

U-Line

U-Line MAGLINER H-1054 Bedienungsanleitung

U-Line

U-Line Magliner H-1382 Bedienungsanleitung

U-Line

U-Line BT H-1003 Bedienungsanleitung

U-Line

U-Line H-6237 Bedienungsanleitung

U-Line

U-Line Big Joe H-4709 Bedienungsanleitung

U-Line

U-Line Magliner H-4938 Bedienungsanleitung

U-Line

U-Line H-4884 Bedienungsanleitung

U-Line

U-Line H-4937 Bedienungsanleitung

U-Line

U-Line H-5484 Bedienungsanleitung

U-Line

U-Line H-3200 Bedienungsanleitung

U-Line

U-Line H-2917 Bedienungsanleitung

U-Line

U-Line MAGLINER H-4938 Bedienungsanleitung

U-Line

U-Line H-1787 Bedienungsanleitung

U-Line

U-Line H-3029 Bedienungsanleitung

U-Line

U-Line H-8921 Bedienungsanleitung

U-Line

U-Line Magliner H-3376 Bedienungsanleitung

U-Line

U-Line H-7505 Bedienungsanleitung

Beliebte LKW Handbücher anderer Marken

Sealey

Sealey CST801 Bedienungsanleitung

RAM

RAM 1500 2019 Bedienungsanleitung

BT Ergomover 620 AC-TT Bedienungsanleitung

Still

Still EXU-16 Bedienungsanleitung

Lift-Rite

Lift-Rite Titan Series Handbuch

SAC

SAC TURBO-MAX 6046 Bedienungsanleitung

Noblelift

Noblelift PS E12BSL Handbuch

Noblelift

Noblelift PTE12N Handbuch

Noblelift

Noblelift PT20H Handbuch

Daewoo

Daewoo Novus M2SEF Bedienungsanleitung

jcb

jcb 506-23 Bedienungsanleitung

Tico

Tico Pro-Spotter Bedienungsanleitung

Dawson

Dawson Truck Mate Bedienungsanleitung

freightliner

freightliner Columbia Versionshinweis

Mack

Mack M359 Bedienungsanleitung

Super Products

Super Products Camel 1200 (Ejector Unloading) Bedienungsanleitung

Vestil

Vestil CARPET-D Bedienungsanleitung

STAXX

STAXX EPT15H Bedienungsanleitung