Ubiquiti UniFi UC-CK Bedienungsanleitung
LED
Shutdown Button
Ethernet Port
Reset Button
White Factory defaults.
Flashing White Initializing.
Alternating White/Blue
Device is busy; do not touch or unplug it. This
usually indicates that a process such as a
firmware upgrade is taking place.
Blue Device is working properly.
Press the Shutdown button to initiate a graceful shutdown (all services will be shut
down and the CPU will remain active). After pressing the button, wait until the LED
goes off, and then unplug the Cloud Key.
This Gigabit Ethernet port is used to connect the power and should be connected to
the LAN and DHCP server. Power can be provided by an 802.3af PoE switch, such
as the UniFi PoE Switch.
The Reset Button serves two functions:
Create PDF in your applications with the Pdfcrowd HTML to PDF API PDFCROWD
USB Type C Power Port
microSD Slot
Restart Press and release the Reset button quickly.
Restore to Factory Default Settings Press and hold the Reset button for more than
five seconds.
Optional power source (5V, minimum 1A) if PoE is not available.
This slot is used to back up the Cloud Key configuration to the microSD card
(included).
Hardware Installation
1.
2.
Create PDF in your applications with the Pdfcrowd HTML to PDF API PDFCROWD
Software Installation
The UniFi Controller software is pre-installed on the UniFi Cloud Key. Use one of the
following methods to launch the software:
If you are using Chrome, go to the Chrome Instructions section (recommended).
If you are using a different web browser, go to the Instructions for Other Web
Browsers section.
Chrome Instructions
1. Ensure that your host system is on the same Layer-2 network as the UniFi Cloud
Key.
2. Launch the Chrome web browser and type https://unifi.ui.com in the address field.
Press enter (PC) or return (Mac).
Create PDF in your applications with the Pdfcrowd HTML to PDF API PDFCROWD
Inhaltsverzeichnis
Andere Ubiquiti Controller Handbücher
