UDI R/C U38S Bedienungsanleitung

U38S

OPERATION GUIDE

Drone Battery Li-Po Battery Disposal & Recycling

Wasted Lithium-Polymer batteries must not be placed with household

trash. Please contact local environmental or waste agency or the

supplier of your model or your nearest Li-Po battery recycling center.

Important

Notice

Our company's products are improving all the time, design and

specifications are subject to change without notice. All the information in

this manual has been carefully checked to ensure accuracy, if any

printing errors, our company reserve the final interpretation right.

▲This product is suitable for users over 14 years old.

▲Stay away from the rotating propeller

▲Read the “important statement and safety guidelines”carefully.

This product supports GPS positioning and is recommended for outdoor flight!

This wifi camera pinpoint is 5G, please confirm whether the phone is supported.

Note

Propeller A Front

Camera

Rear

Battery indicator

Switch

Front folding arm

Propeller B

Propeller A

Front folding arm

Rear folding arm Rear folding arm

Battery

Front

Rear

Tripod

visual system

Tripod

Front LED (Red) Front LED (Red)

Rear LED (Green)

TF Card slot

Ready before take off

Drone preparation

Unfolding Instruction

The installation method of battery

Connect the batteries of the drone to the charging line of the original plant, and then

connect to other USB charging outlets.

Battery indicator flashes when charged. When the charging

is completed, the battery indicator light is always on.

① Folding State

④ Open the tripod

③ Front folding

arms unfold

Push to the end

Pull out the battery

Battery power is low in the original factory, It must be fully charged before use.

Power adapter (not included)

Drone Battery

①

②

③

Press to unlock the lock

①

Press to unlock the lock

①

Battery charging

② Rear folding

arms unfold

▲Only use the original USB charging cable.

Installation of TF Card

Transmitter

Insert the TF card into the slot on the belly of the fuselage, and pay

attention to the metal contact surface orientation of the TF card.

Connect the transmitter with the charging line of the original plant, and then connect

other USB charging outlets.

When charging, the transmitter indicator flashes

circularly, and when charging is completed,

the indicator will be on for a long time.

Transmitter charging

Video

Left stick /

Trimmer (press down)

GPS switch

Right Stick

Power switch Return

Speed switch

Follow Mode Encircle Mode

Gimbal Rotary Button

Photo

Indicator light

Phone Holder

Battery power is low in the original factory, It must be fully charged before use.

* TF card is not included

Power adapter (not included)

①

②

③Input: 5V 2A

▲Only use the original USB charging cable.

The installation methods of mobile phone holder

The installation methods of mobile phone

①Pull up the clip on the mobile phone.

Straightening the antenna

②Place the phone in the upper and

lower clamps Between, the clamp

will automatically clamp the mobile

phone .

②

Notice:

Don't clip the

buttons on the

side of the

phone.

Put the phone clip

on the back of the

quasi-remote

controller and

push it to the end.

Installation

* Phone is

not included !

①

②

Disassemble

Press to unlock the lock

Pull up the clip on

the mobile phone

Flight Operations

Transmitter connect with Drone

Mobile phone connect with Drone

Frequency Pairing

①Turn on the power.

② Pull the left stick to the lowest position and

let go, the light goes off slowly. it indicates

the transmitter enters the frequency state.

③ The drone is placed on the horizontal ground, and long press the power button for 2

seconds to start the machine. After the navigation light is on for 2 seconds, the front

navigation light flashes and the rear navigation light goes out. At the same time, the

remote control emits a prompt sound of "di", indicating successful frequency alignment

and entering the horizontal calibration of compass.

Horizontal ground

Download and install APP: UDIGPS-PRO

This software is suitable for mobile phones in the

IOS 9.0 or later and Android 4.4 or later system.

For detailed operation, please check the system

“HELP” of APP.

Compass calibration

Level Correction Vertical correction

Tips: It’s a must to have the right compass adjustment first each time you start

the drone, or it can’t work normally.

Calibration (This action is used when flying abnormally)

Tips: When the drone doesn’t appear to use the trim correction flight status, or being

hit hard (or falling abnormally). Thus cause the difficulties in controlling. Now

frequency making and adjustment are needed again, drone should be placed on

horizontal ground.

After the frequency matching is successful, the drone automatically searches for

GPS signals. When the blue indicator light of the remote control changes from

flashing to long bright, it makes a sound of "di" at the same time, indicating that

the GPS connection is successful. (when the GPS signal is weak or flying

indoors, the flight height defaults to about 4 meters)

GPS Signal Search

Rotate the drone horizontally until the transmitter sound "di..." Level correction to complete.

When the front navigation light turns to long light and the rear navigation light flashes, enter

vertical correction. rotate the vehicle vertically until the transmitter sound "di...", vertical

correction over. The lights are spinning and flashing.

After the calibration of the compass, the right stick of

the transmitter is pushed to the lower right corner by

45°, and the transmitter emits sound "di", and the

drone light flashes and releases, indicating that the

gyroscope has been calibrated. (drone should be

placed on horizontal ground)

Take off Landing

Control stick operation

Left Stick Right Stick

Fly to the left

Fly to the right

Forward

Backward

Counterclockwise

turn

clockwise turn

Go Up

Go Down

Unlocking the drone

The drone can only take off when the motor is unlocked.

①On standby drone, motor rotation, drone Unlocked.

②When the drone is not take off, the motor stops

rotating and the drone is locked.

Push the left and right stick inward to the 45° angle

simultaneously.

After unlocking the motor, the left stick

slowly pushes up and the drone slowly

rises.

During the flight, the left stick slowly pull

down , and the drone slowly lands until

landing.

While flying, press the " " botton, the transmitter sounds

"di", the drone enters "following mode". Now it can be controlled

by the user.

OFF: Press the " " botton again.

The function is standard by the mobile phone APP signal, so it’s

a must to make the drone and APP connected normally, turn on

the mobile location service at the same time, otherwise this

function is invalid

Following Function

Note: follow the maximum range distance, within 1000m of the take-off point.

GPS ON / OFF

Note: this function is only used when the motor is locked.

Return

Notice: While returning, the control lever of the transmitter can not control the drone,

it must be waited for the drone to go back to the take-off point. And after the

direction of the drone is directed at the direction of taking off, in this way right

stick can control the drone.

During the flight, press the " " button, and the transmitter

will sound "di", and the drone will automatically return to the

take-off point. (during returning, the transmitter will

continuously sound "di". To stop homing, just press this

button again.)

GPS is on by default.

GPS OFF: Press the " "button ,the transmitter will sound

"di”and the blue indicator of the transmitter will go

off，it means GPS will be off.

GPS ON: Press the " " button and the blue indicator of

the transmitter will keep bright. It means GPS restart.

In flight, press the " " button, and the transmitter will make the sound of "di". Then it

goes to the function of encircling flight. The drone will fly to a default radius then it waits

for the direction controlled by the user. Adjust the speed and direction of the drone by

manipulating the right stick. It is the minimum radius of the default radius acquiescently, so

drone flies only in the sub range.

Encircling flight

Turn left, the drone flies clockwise;

Move further, the flying speed will

become faster.

Go downside to enlarge the radius

of encircling.

In the state of

encircling flying, the left

stick could only control

the height of the drone.

Go upward to narrow the radius of

encircling.

Turn right, the drone flies

counterclockwise; Move further,

the speed will become faster.

Speed mode switch

Low speed: suitable for beginners to practice without wind.

Medium speed: suitable for skilled operator operating in light breeze.

High speed: suitable for professional operation in outdoor wind resistance

Gimbal Adjustment

Roll Gimbal Rotary Button,

adjust Camera Angle.

Tilting -90° to 0°

Press "H/L" button, the transmitter will sound "di.di.di" to enter

high speed mode "H".

Press it again, the transmitter will sound "di" to enter low speed

mode "L".

Press it again, the transmitter will sound "di.di" to enter medium

speed mode "M".

Medium speed default

Inhaltsverzeichnis

Andere UDI R/C Drohne Handbücher

UDI R/C

UDI R/C U95 Bedienungsanleitung

UDI R/C

UDI R/C U37 Bedienungsanleitung

UDI R/C

UDI R/C U52G Bedienungsanleitung

UDI R/C

UDI R/C U39S Bedienungsanleitung

UDI R/C

UDI R/C VOYAGER U845Wifi Bedienungsanleitung

UDI R/C

UDI R/C Swan U42 Bedienungsanleitung

UDI R/C

UDI R/C U67 Bedienungsanleitung

UDI R/C

UDI R/C VOYAGER U845Wifi Bedienungsanleitung

UDI R/C

UDI R/C U818A WIFI Bedienungsanleitung

UDI R/C

UDI R/C Discovery2 Bedienungsanleitung

UDI R/C

UDI R/C U42W Bedienungsanleitung

UDI R/C

UDI R/C VOYAGER U845Wifi Bedienungsanleitung

UDI R/C

UDI R/C U89S Bedienungsanleitung

UDI R/C

UDI R/C Swan U42 Bedienungsanleitung

UDI R/C

UDI R/C U46S Bedienungsanleitung

UDI R/C

UDI R/C U64 Bedienungsanleitung

UDI R/C

UDI R/C U46W Bedienungsanleitung

UDI R/C

UDI R/C TIMY U846 Bedienungsanleitung

UDI R/C

UDI R/C VOYAGER U845Wifi Bedienungsanleitung

UDI R/C

UDI R/C UDIO22 Bedienungsanleitung

UDI R/C

UDI R/C U88S Bedienungsanleitung

UDI R/C

UDI R/C Neon U51 Bedienungsanleitung

UDI R/C

UDI R/C PEREGRINE Bedienungsanleitung

UDI R/C

UDI R/C U46S Bedienungsanleitung

Beliebte Drohne Handbücher anderer Marken

Ryze

Ryze Tello Bedienungsanleitung

PowerVision

PowerVision PowerRay Bedienungsanleitung

Force1

Force1 rogue F72 Bedienungsanleitung

Zerotech

Zerotech DOBBY Bedienungsanleitung

Protocol

Protocol VIDEODRONE AP Bedienungsanleitung

dji

dji Matrice M210 Bedienungsanleitung

MAKE

MAKE Terry Kilby Bedienungsanleitung

SYMA

SYMA X440 Bedienungsanleitung

RUKO

RUKO F11 Bedienungsanleitung

SYMA

SYMA X5UW(720P) Bedienungsanleitung

Dynali

Dynali 25 H Leitfaden

dji

dji PHANTOM 4 Bedienungsanleitung

Atlas

Atlas AtlasPRO Bedienungsanleitung

Twodots

Twodots TVVIN BOARD Bedienungsanleitung

GDU

GDU SAGA Bedienungsanleitung

Ares

Ares ETHOS QX 130 Bedienungsanleitung

Walkera

Walkera ZHUN Bedienungsanleitung

dji

dji WIND-4 Bedienungsanleitung