UMAX Technologies SuperMac E100 Bedienungsanleitung

Table of Contents

SuperMac E100

Extended Performance Card

User’s Guide

UMAX Computer Corporation

Headquarters and Sales

47470 Seabridge Drive

Fremont, California 94538 USA

Research and Development

4800 Great America Parkway, Suite 200

Santa Clara, California 95054 USA

SuperMac Information

www.supermac.com

P/N: 9011344-0001

Table of Contents

Trademarks and Copyright

of UMAX Computer Corporation. SuperMac is a registered trademark of Radius

Inc., used under license by UMAX Computer Corporation. Apple, AppleTalk,

Disk First Aid, PlainTalk, ProDOS, Macintosh, GeoPort, PowerTalk, Apple Desk-

top Bus, LocalTalk, LaserWriter, Personal LaserWriter 300, StyleWriter, Quick-

Draw, Finder and Power Macintosh, are trademarks of Apple Computer, Inc.

Mac and the MacOS logo are trademarks of Apple Computer, Inc., used under

license. PowerPC is a trademarks of International Business Machines, used

under license therefrom. AsantéFAST 10/100 is a trademark of of Asanté Tech-

nologies, Inc. used under license by UMAX computer Corporation. JackHammer

is a registered trademark of StreamLogic Corporation under licesnse by UMAX

Computer Corporation.

Mention of non-UMAX products or services is for informational purposes only

and constitutes neither an endorsement nor a recommendation. UMAX Com-

puter Corporation assumes no responsibility with regard to the selection, per-

formance or use of those products. All understandings, agreements, and

warranties, if any, take place between the vendors and the users. Product speci-

fications are subject to change without notice.

Restricted Rights Legend

Use, duplication, or disclosure by the Government is subject to

restrictions as set forth in subparagraph (c) (1) (ii) of the Rights in Technical

Data and Computer Software clause at DFARS 52.227-7013.

UMAX Computer Corporation

Headquarters and Sales

47470 Seabridge Drive

Fremont, California 94538 USA

Research and Development

4800 Great America Parkway, Suite 200

Santa Clara, California 95054 USA

Table of Contents

Introduction

Congratulations on your purchase of the SuperMac E100 Extended

Performance Card by UMAX Computer Corporation (referred to herein

as UMAX Computer). The SuperMac E100 combines high speed disk

and networking capabilities in a single PCI card. It dramatically

increases performance of most SCSI devices connected to it and con-

nects your SuperMac system to a high-speed 100Mbps network.

The E100 offers up to 40MByte per second transfer rates and enables

you to daisy-chain up to 16 devices. The E100 provides automatic ter-

mination with custom termination available through the control panel.

The 100MBit Ethernet feature offers instant migration from 10 to

100Mbps networking, auto-negotiation for 10Base-T or 100Base-TX

operation, and a performance gain of four or five times over ordinary

10Base-T when combined with NetDoubler software. The E100 card

improves network throughput by taking full advantage of network

bandwidth.

Registration

Please take a moment and fill out the warranty registration card which

is included with your SuperMac E100 Extended Performance Card.

This process enables us to learn more about you so that we can better

serve our customers. This reply card requires no postage if mailed

within the United States.

About This Guide

This manual will guide you through the installation and use of the

E100 hardware and software. This manual contains the following

chapters:

Chapter 1, Installing the E100, provides step-by-step instructions for

installing the E100 Extended Performance Card.

Chapter 2, Connecting Ultra SCSI, explains how to connect the Ultra SCSI

feature provided by your E100.

Chapter 3, Using the Ultra SCSI Software,describes how to use the con-

trol panel software for your E100.

Table of Contents

Chapter 4, Connecting to the Network, explains how to connect the 100

Mbit Ethernet provided by the E100 to the network and how to config-

ure it.

Chapter 5, Troubleshooting, offers tips and procedures for solving

potential difficulties when using the Ultra SCSI and 100 MBit Ethernet

features provided by the E100 card.

System Requirement

■A SuperMac S900 series or J700 series computer.

■16MB Ram minimum

■PCI “Slot A” must be available

■Mac OS System software version 7.5.3 or later

What’s In the Box

■E100 Extended Performance Card

■E100 Card software disk

■E100 User’s Guide

■Registration card

Contents

Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .v

Registration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .v

Chapter 1 — Installing the E100 . . . . . . . . . . . . . . . . . . . . . . . . . . . .1

Installing the Card . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1

Installing the E100 Software . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4

Chapter 2 — Connecting Ultra SCSI . . . . . . . . . . . . . . . . . . . . . . . . .7

Connecting Device Cables to the E100 Card . . . . . . . . . . . . . . . . . . . . . . . . . . . .7

Starting Up from a Drive Connected to the E100 . . . . . . . . . . . . . . . . . . . . . . . . .8

Chapter 3 — Using the E100 SCSI Software . . . . . . . . . . . . . . . . . .11

Software Termination . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .13

Chapter 4 — Connecting to the Network . . . . . . . . . . . . . . . . . . . .15

Connecting UTP Cable . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .15

Conﬁguring the E100 Card to the Network . . . . . . . . . . . . . . . . . . . . . . . . . . . . .15

Conﬁguring 10Mbps, 100Mbps, or Full Duplex Operation . . . . . . . . . . . . . . . .16

Conﬁguring the AppleTalk Control Panel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .17

Chapter 5 — Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . .19

Troubleshooting E100 SCSI . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .19

Troubleshooting 100MBit Ethernet . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .20

LED Indicators . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .20

Speciﬁcations . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .22

Appendix — Regulatory Compliance. . . . . . . . . . . . . . . . . . . . . . . .25

Table of Contents

Chapter 1

Installing the E100

The instructions in this section explain the procedures for installing

the E100 Card into a SuperMac S900 or J700 series machine. You can

have the card installed by a qualified service provider or you can per-

form the work yourself.

Installing the Card

1. Turn off your computer, but leave it plugged in to ensure that the

computer is properly grounded.

2. If you are installing the card in an S900, carefully turn the com-

puter on its right side (as you face the front of the computer).

3. Loosen the large thumbscrew on the back panel.

Loosen screw

Table of Contents

4. Press the “locking” tabs at the rear corners of the panel and slide

the it a few inches toward the rear of the computer. If the panel lid

appears tight, apply a strong downwards pressure (where the large

arrows indicate) as you slide the lid to the rear. Then lift t he

panel up and off the computer.

5. Remove the metal access port cover behind the enhanced PCI slot

marked Slot A. (The marking is on the motherboard.)

Remove the mounting screw at the top of the metal access port

cover, then lift off the cover plate and set it aside.

6. Position the E100 card over Slot A.

Slot A

Table of Contents

Make sure that the notch in the connector on the card aligns with

the connectors in Slot A.

7. Press the E100 card straight down into Slot A. Do not bend or

force the card: if you meet resistance, pull the card out and try

again.

8. Reinsert in the mounting screw.

9. Set the panel on the case so there is about a 1-inch gap to the front

panel.

Notch

Inserting E100 card

in S900 or J700

Table of Contents

10. While pressing down on the panel with one hand, slide the panel

toward the front with the other.

11. Tighten the thumb-screw on the back panel.

12. If you are installing the card in an S900, carefully return the

computer to its vertical position.

Installing the E100 Software

Your E100 card requires special software which is contained on the

CD-ROM included with your E100 card.

Before you install the E100 software, temporarily disable any virus

protection software.

To install the E100 software, follow these steps:

1. Place the CD disc that contains system software in the CD-ROM

drive’s tray with the label facing up, and close the tray.

2. Double-click the Install E100 Software to open the installer.

3. In the Welcome dialog box that appears, click OK.

4. Check that the disk named in the box is the one on which you want

to install the E100 software.

If not, click the Switch Disk button until the correct disk name

appears.

5. In the Installer dialog box, choose Easy Install.

Table of Contents

6. Click Install.

The following files are installed and placed in the appropriate

folders on your hard disk: the E100 SCSI (control panels folder)

and E100 Config and E100 Ethernet (extensions folder).

7. When you see a message reporting the installation was successful,

click Restart.

Inhaltsverzeichnis

Andere UMAX Technologies Computerhardware Handbücher

UMAX Technologies

UMAX Technologies U-Box N51 Pro Bedienungsanleitung

Beliebte Computerhardware Handbücher anderer Marken

EMC2

EMC2 VNX Series Betriebsanleitung

Panasonic

Panasonic DV0PM20105 Bedienungsanleitung

Mitsubishi Electric

Mitsubishi Electric Q81BD-J61BT11 Bedienungsanleitung

Gigabyte

Gigabyte B660M DS3H AX DDR4 Bedienungsanleitung

Raidon

Raidon iT2300 Bedienungsanleitung

National Instruments

National Instruments PXI-8186 Bedienungsanleitung

Hauppauge

Hauppauge WinTV-HVR-2250 Bedienungsanleitung

Kontron

Kontron CP6002 Bedienungsanleitung

Manhattan

Manhattan 702843 Bedienungsanleitung

Aphex

Aphex 230 Bedienungsanleitung

AMD

AMD Phenom II Betriebshandbuch

Intel

Intel NUC 12 Pro Bedienungsanleitung

dbx

dbx Zone Pro 1260 Bedienungsanleitung

Galaxy

Galaxy GHDX2-2430S-24F4D Bedienungsanleitung

Intel

Intel AXXRMFBU4 Bedienungsanleitung

Kontron

Kontron DIMM-PC/MD Bedienungsanleitung

ST X-NUCLEO-SAFEA1B Betriebsanleitung

STEINWAY LYNGDORF

STEINWAY LYNGDORF SP-1 Bedienungsanleitung