Uniden EXP900 Bedienungsanleitung

Important Safety Instructions

When using your telephone equipment, basic safety precautions

should always be followed to reduce the risk of fire, electrical

shock, and injury to persons, including the following:

1. Read and understand all instructions.

2. Follow all warnings and instructions marked on the product.

3. Unplug this product from the wall outlet before cleaning. Do not

use liquid cleaners or aerosol cleaners. Use a dry cloth for

cleaning.

4. Do not use this product near water; for example, near a sink or

in a wet area.

5. Do not place this product on an unstable cart, stand, or table.

The telephone may fall, causing serious damage to the unit.

6. To protect the product from overheating, do not block or cover

any slots or openings in the Base Unit. This product should

never be placed near or over a radiator or heat register. This

product should not be placed in a built-in installation unless

proper ventilation is provided.

7. This product should be operated only from the type of power

source indicated on the marking label.

8. Do not allow anything to rest on the power cord. Do not locate

this product where the cord will be damaged by persons walking

on it.

9. Do not overload wall outlets and extension cords, as this can

result in the risk of fire or electrical shock.

10. Never push objects of any kind into this product through the

Base Unit slots, as they may touch dangerous voltage points or

short out parts that could result in a risk of fire or electric shock.

Never spill liquid of any kind on the product.

11. To reduce the risk of electric shock, do not disassemble this

product. Contact qualified service personnel when some service

or repair work is required. Opening or removing covers may

expose you to dangerous voltages or other risks. Incorrect

reassembly can cause electric shock when the appliance is

subsequently used.

12. Unplug this product from the wall outlet and refer servicing to

qualified service personnel under the following conditions:

A. When the power supply cord is damaged or frayed.

B. If liquid has been spilled into the product.

C. If the product has been exposed to rain or water.

D. If the product does not operate normally when following

the operating instructions. Adjust only those controls

that are covered by the operating instructions. Improper

adjustment of other controls may result in damage and

will often require extensive work by a qualified

technician to restore the product to normal operation.

E. If the product has been dropped or the cabinet has

been damaged.

F. If the product exhibits a distinct change in performance.

13. Do not use the telephone to report a gas leak in the vicinity of

the leak. CAUTION

To reduce the risk of fire or injury to persons by the battery, read

and follow these instructions:

1. Use only the appropriate type and size Battery Pack specified

in this Operating Guide.

2. Do not dispose of the Battery Pack in a fire. The cell may

explode. Check the Lead Acid Battery Disposal information at

the beginning of this Guide for disposal instructions.

3. Do not open or mutilate the Battery Pack. Released electrolyte

is corrosive and may cause damage to the eyes or skin. It may

be toxic if swallowed.

4. Exercise care in handling the battery in order not to short out

the battery with conducting materials such as rings, bracelets,

and keys. The battery or conductor may overheat and cause

burns.

5. Charge the Battery Pack provided with or identified for use with

this product only in accordance with the instructions and

limitations specified in the instruction manual provided for this

product.

6. Observe proper polarity orientation between the Battery Pack

and battery charger.

SAVE THESE INSTRUCTIONS

Introduction

About the EXP900

The EXP900 is a 900 MHz Cordless Phone with voice scramble. It

is designed and engineered to exacting standards for reliability,

long life, and outstanding performance.

Features

•900 MHz operation •Tone/Pulse Dialing

•Redial and Flash •One-Way Page, Base Unit

to Handset

•10-Number Memory •AutoTalk

•AutoStandby •40 Channels

•Battery Saving Feature •Voice Scramble

•Handset Volume Control/

Ringer Volume Control •Headset Jack for hands

free convenience

•Wall mountable •Any Key Answer

•Hearing aid compatible •Extended range and clarity

•Belt clip •Visual LED indications

•Reversible Handset

Retainer •Automatic Digital Code

Security

The EXP900 features include

AutoTalk™

and

AutoStandby™.

AutoTalk™

allows you to answer a call by just removing the

Handset from the Base so you don’t have to waste time pushing

buttons or flipping switches.

AutoStandby™

allows you to hang up

by simply returning the Handset to the Base.

The

UltraClear Plus

true compander circuitry virtually eliminates

background noise. This innovative technology, together with 40

different channels, provides you with the best possible reception

during all your conversations.

The EXP900 phone protects your privacy by scrambling any call

you make or receive. The RF signal between the Handset and

Base Unit are changed, making it difficult or impossible for

someone to receive and understand your phone calls.

To protect you against misbilled calls which might result from your

phone being activated by other equipment, the EXP900 has

Random Code™

digital security which automatically selects one of

over 65,000 digital security codes for the Handset and Base Unit.

Also, the

AutoSecure™

feature electronically locks your phone

when the Handset is in the Base. To get the most from your

EXP900, please read this Operating Guide thoroughly.

What’s Included with Your EXP900

If any of these items are missing or damaged, contact your

place of purchase.

POWER

CHARGE

IN USE

PAGE

900MHz

EXP900 Base

TALK

REDIAL

ABC

DEF

JKL

MNO

TUV

WXY

OPER

PRS

GHI

MUTE VOL CH

RINGER

]

EXP900 Handset Belt Clip

Base Stand

Operating Guide

POWER

CHARGE

INUSE

PAGE

TAL K

ABC

DEF

JKL

MNO

TUV

WXY

OPER

PRS

GHI

MEM VOL CH

TONE

REDIAL

FLASH

BATTLOW

TALK

900MHz

Operating Guide AC Power Adapter

Lead-Acid Battery Short and Long

Telephone Cords

Installation

Installing Your EXP900

Selecting the Installation Location

Select a location for the EXP900 to avoid excessive heat or

humidity (as in a kitchen or bathroom). The Base Unit of your

EXP900 can be placed on a desk or tabletop near a standard 120V

AC outlet and telephone line jack, mounted on a standard AT&T or

GTE wall plate, or mounted directly on the wall. Keep the Base Unit

and Handset away from sources of electrical noise (motors,

fluorescent lighting, etc.). Be sure there is sufficient space to safely

extend the Base Unit antenna fully.

Connecting the Telephone Line

There are three types of phone outlets:

•Modular.

•4-prong jack.

•Hard-wired type.

Modular Jack

Plug the telephone line cord from the Base Unit into a standard

modular telephone jack.

Note:

If you do not have a modular jack, contact your local

telephone company for information on the installation of

these jacks.

4-Prong Jack

An adapter (not included) is required. The adapter plugs into the

4-prong jack and the telephone line cord plugs into the adapter.

Hard-wired Jack

A modular jack converter (not included) is required. You may need

to rewire when connecting the converter (making color-coded

connections).

Note: Your Uniden Cordless Telephone Dealer or a telephone

supply store can advise you on the proper adapter or

converter.

CAUTION:

•Never install telephone wiring during a lightning storm.

•Never install telephone jacks in wet locations unless the jack

is specifically designed for wet locations.

•Never touch uninsulated telephone wires or terminals unless

the telephone line has been disconnected at the network

interface.

•Use caution when installing or modifying telephone lines.

Setting the TONE/PULSE Switch

Place the switch in the TONE

position for tone dialing, or the

PULSE position for pulse

dialing.

Installing the Base Unit on a Desk or Tabletop

1. Install the Base Stand on the

base.

2. Plug the AC Power Cord (1)

and the Telephone Line Cord

(2) into the base.

3. Thread the AC Power Cord

through the clip on the base

stand, and place the Base Unit

on the desk or table top.

4. Raise the antenna on the Base

Unit.

5. Plug the other end of the Telephone Line Cord into the

telephone wall jack. Plug the AC Adapter into a standard 120V

AC wall outlet.

Note:

Use only the AC Adapter supplied with the EXP900.

6. Route the telephone and power cords where they will not

create a trip hazard, or where they could become chafed and

create a fire or other electrical hazards.

Mounting the Base Unit on a Wall

Setting the Handset Retainer

1. Remove the Handset Retainer on the Base Unit by sliding it

upward.

2. Flip the Retainer over so the tab is facing up, and slide the

Retainer back into the Base Unit.

Mounting on a Standard Wall Plate

The EXP900 is designed to be mounted on a standard AT&T or

GTE wall plate.

1. Plug the AC Power Cord (1)

and the Short Telephone Cord

(2) into the base.

2. Place the power cord in the left

molded channel on the bottom

of the Base Unit.

3. Plug the short telephone cord

into the phone and the GTE

Wall Plate jack. Place the Base

Unit on the two posts of the wall

plate and slide downward to

secure.

4. Raise the antenna on the Base

Unit.

5. Hang the Handset on the Base Unit.

6. Plug the AC Adapter into a standard 120V AC wall outlet.

Note:

Use only the AC Adapter supplied with the

EXP900.

7. Route the power cord where it will not create a trip hazard, or

where it could become chafed and create a fire or other

electrical hazards.

Inhaltsverzeichnis

Andere Uniden Schnurloses Telefon Handbücher

Uniden

Uniden XC 340 Bedienungsanleitung

Uniden

Uniden DCT5280 Bedienungsanleitung

Uniden

Uniden EXAI 8985 Bedienungsanleitung

Uniden

Uniden DX3555 Bedienungsanleitung

Uniden

Uniden XSR917/918 Bedienungsanleitung

Uniden

Uniden 6035 + 1 Bedienungsanleitung

Uniden

Uniden EXI 386 Series Bedienungsanleitung

Uniden

Uniden WDSS 5355 Series Bedienungsanleitung

Uniden

Uniden EX905 Bedienungsanleitung

Uniden

Uniden EXS9600 Bedienungsanleitung

Uniden

Uniden WDECT2315+2 Bedienungsanleitung

Uniden

Uniden DXAI388-2 Bedienungsanleitung

Uniden

Uniden XS 910 Bedienungsanleitung

Uniden

Uniden DECT1580 - DECT 1580 Cordless Phone Benutzerhandbuch

Uniden

Uniden D2380-3 Bedienungsanleitung

Uniden

Uniden DECT3080-3 - DECT Cordless Phone Bedienungsanleitung

Uniden

Uniden D1780-4BT Service-Handbuch

Uniden

Uniden XC3545 Bedienungsanleitung

Uniden

Uniden 2.4 Bedienungsanleitung

Uniden

Uniden EXS9005 Bedienungsanleitung

Uniden

Uniden DCX750 - DCX 750 Cordless Extension Handset Service-Handbuch

Uniden

Uniden EXAI2248 series Bedienungsanleitung

Uniden

Uniden DECT 1811 Bedienungsanleitung

Uniden

Uniden DWX207 - Cordless Extension Handset Service-Handbuch

Beliebte Schnurloses Telefon Handbücher anderer Marken

3Com

3Com NBX Bedienungsanleitung

Panasonic

Panasonic KX-TGK210HK Bedienungsanleitung

Panasonic

Panasonic KX-TCA181EX Bedienungsanleitung

BT FREESTYLE 3200 Bedienungsanleitung

AT&T

AT&T CL84102 Bedienungsanleitung

BREZZICNI

BREZZICNI CL-3622 Bedienungsanleitung

Panasonic

Panasonic KX-TG1831NZ Bedienungsanleitung

Panasonic

Panasonic KX-TG7301E Bedienungsanleitung

Furuno

Furuno FM-4721 Bedienungsanleitung

Sanyo

Sanyo CLT-J70 Bedienungsanleitung

Amplicomms

Amplicomms BigTel 201 Bedienungsanleitung

GE 26992 Bedienungsanleitung

AT&T

AT&T E1812B Bedienungsanleitung

Sanyo

Sanyo CLT-670 Bedienungsanleitung

GE 15432970 Bedienungsanleitung

Curtis

Curtis TC595 Bedienungsanleitung

Gigaset

Gigaset Gigaset 3000 Micro Bedienungsanleitung

Poly

Poly VVX D230 Einrichtungshandbuch