Universal Electronics Potenza ST Bedienungsanleitung

Potenza ST

Universal Remote Control

Users Guide

PREPROGRAMMED FOR YOUR SET-TOP BOX

Nebula Potenza ST.fm Page 1 Monday, October 15, 2007 4:55 PM

www.urcsupport.com

INSTALLING BATTERIES

1. On the back of the remote control, push the

tab and lift off the battery cover.

2. Locate the two (2) enclosed AA batteries.

Match the + and - marks with those in the

battery case, then insert them.

3. Align the covers keys with the cases holes and

press the cover back into place. The tab should

click when the cover is locked.

NOTE: When batteries need replacement, the remote

control will cease to operate. Replace the

batteries and the unit will be restored to its

full functionality, complete with your favorite

settings.

PROGRAMMING DEVICE CONTROL

The Potenza ST Universal Remote Control is

preprogrammed to operate the set-top box provided by

your television service provider, an RCA TV, a Toshiba

DVD player, an RCA VCR, and a Pioneer audio receiver.

To control devices other than the default brands,

perform the following steps; otherwise skip this section.

4. Test the remote control by pressing any mode

key (e.g., TV). If the batteries are inserted

correctly, the LED (red light) will blink once.

Nebula Potenza ST.fm Page 9 Monday, October 15, 2007 4:55 PM

www.urcsupport.com

NOTES: For control of a Combo device (for example, a

TV/VCR combo), skip this section and per-

form the instructions on “Setting Up a Combo

Unit” on page 11. Also refer to “Device Table”

on page 8 to find out which devices can be

programmed onto each device key.

If you have another brand of set-top box you

would like to control, you’ll need to unlock the

STB ID Lock before changing the set-top box

code (see “Programming ID Lock” on

page 19).

1. Turn on a device and, if applicable, insert

video media, (e.g., cassette or disc).

NOTE: Please read steps 2 through 5 completely

before proceeding. Highlight or write down

the codes and device you wish to program

before moving on to step 2.

4. Use the “Manufacturer’s Codes” starting on

page 27) to locate the type of device and

brand name and then enter the first four-digit

code for your device. If performed correctly,

the selected mode key will blink twice.

NOTE: If the selected mode key emits a long blink,

the entry is invalid. Repeat steps 2 through 4

and try entering the same code again.

NOTE: If the device does not have a POWER key (e.g.,

DVD and VCR), press the(Play) key.

6. Repeat steps 1 through 5 for each device you

want the remote control to operate. For future

reference, write down each working device

code in the boxes on the following page.

VCR Code

2. On the remote control, press a device key once

(i.e., VCR, DVD, AUD, TV, or STB); it will blink

once.

3. Press and hold SETUP until the selected mode

key blinks twice, then release SETUP.

5. Aim the remote control at the device and

press POWER once. The device should turn

off. If it does not, repeat steps 2 through 4,

trying each code for your brand until you find

one that works. If it still does not respond, try

searching for the code (see “Searching for

Your Code” on page 12).

Nebula Potenza ST.fm Page 10 Monday, October 15, 2007 4:55 PM