URC Total Control MRX-4SEN Bedienungsanleitung

Order Number : GETEC-C1-13-116 FCC Part 15 subpart C

Test Report Number : GETEC-E3-13-030 Page 1 / 1

EUT Type: Sensor Extender

FCC ID.: OZ5URCMRX4SEN

APPENDIX H

: USER’S MANUAL

MRX-4SEN

Sensor Extender

Owners Manual

Control, Inc.

The information in this manual is copyright protected. No part of this

manual may be copied or reproduced in any form without prior written

consent from Universal Remote Control, Inc.

UNIVERSAL REMOTE CONTROL, INC. SHALL NOT BE LIABLE FOR

OPERATIONAL, TECHNICAL OR EDITORIAL ERRORS/OMISSIONS MADE

IN THIS MANUAL.

The information in this manual may be subject to change without prior

notice.

Total Control is a registered trademark of Universal Remote Control, Inc.

All other brand or product names are trademarks or registered trademarks

of their respective companies or organizations.

500 Mamaroneck Avenue, Harrison, NY 10528

Phone: (914) 835-4484 Fax: (914) 835-4532

TABLE OFCONTENTS

Introduction 1

Features and Benefits 1

Parts Guide 1

Front, Rear, and Bottom Panel Descriptions

Network Installation 5

Specifications 6

USA Limited Warranty Statement 7

Federal Communication Commission

Interference Statement 9

Declaration of Conformity 10

MRX-4SEN SENSOR EXTENDER

Introduction

Thank you for purchasing the MRX-4SEN Sensor Extender. Expand

your MRX Advanced Network System Controller sensor coverage

beyond four ports by adding additional MRX-4SEN units throughout

the home or office.

Features and Benefits

•Expand Sensor Coverage

Add one or more MRX-4SEN throughout your home or office

to detect changes in a connected sensor, which may be used to

trigger system events.

• No Cables, No Mess, No Fuss

Connect a MRX-4SEN virtually anywhere in the home or office

without the mess of cables while communicating over URC’s

2.4GHz wireless connection.

• Compact Size

The small size of the MRX-4SEN allows it to easily fit behind

equipment or into places where a traditional base station would not.

Page 1

Parts Guide

The MRX-4SEN includes:

1 - MRX-4SEN Sensor Extender

1 - AC Power Adapter

4 - Mounting Screws

1 - Mounting Plate

1 - Owner’s Manual

Page 2

MRX-4SEN SENSOR EXTENDER

Front, Rear, and Bottom Panel Descriptions

Front Panel

The front panel consists of 3 indicator lights:

Power LED: The Power LED illuminates when the unit is powered.

Status LED: The Status LED color will vary depending upon its

connected state:

●Connected: Illuminates green

●Low Signal: Illuminates orange

●Not Connected: Not illuminated

Data LED: The Data LED flashes as the MRX-4SEN transmits data to

a MRX Advanced Network System Controller.

Page 3

Rear Panel

The rear panel consists of:

DC 12V Power: Plug in the included 12V DC 1A power supply.

Sensor Inputs: Connect the sensor’s 3.5mm plug to an available port.

The following URC sensors, with their respective model numbers, are

compatible with the MRX-4SEN:

● Voltage Sensor SEN-VOLT

●Video Sensor SEN-VID

●Contact Closure Sensor SEN-CCLS

●Light Sensor SEN-LITE

●Current Sensor (Magnetic Field) SEN-CMF

● Audio Sensor SEN-AUD

Mini-USB connector: For future firmware upgrade use!

MRX-4SEN SENSOR EXTENDER

Page 4

MRX-4SEN SENSOR EXTENDER

Bottom Panel

The bottom panel consists of:

MAC Address Sticker: The MAC Address (16 characters) identifies this

wireless device when connected to the network.

Serial Number Sticker: The serial number, located at the bottom of the

unit, uniquely identifies the product.

Test button: Press to test the signal strength between the MRX

Advanced Network System Controller and the MRX-4SEN. While

testing, the Status LED will update and display its current connection

setting. (Refer to page 2 for Status LED information.)

Reset button: Turns the unit OFF then ON again, and reconnects to

the URC 2.4GHz RF signal.

Page 5

Network Installation

WARNING!! Before proceeding, a Custom Professional is required

to install and configure your MRX-4SEN.

Connect the 3.5mm sensor plug to the rear of the MRX-4SEN. When

a change is sensor is detected, the MRX-4SEN sends a signal to the

MRX Advanced Network System Controller and triggers a series of

commands.

The example below showcases a voltage sensor connected to the

home’s front door and the MRX-4SEN. Whenever the door bell is

pressed, a signal is sent over URC’s RF 2.4GHz to the MRX

Advanced Network System Controller. The MRX unit, previously

programmed by the Custom Professional, will trigger a series of

commands or an event to gain your attention. A programmed

event, such as Watch Movie/TV, may pause the movie, mute the

audio and display the front door’s video camera.

MRX-4SEN SENSOR EXTENDER

Page 6

MRX-4SEN SENSOR EXTENDER

Specifications

Sensor : Four sensor supports Video, Current, Contact Closure,

Ambient Light, Audio, Voltage Sensing via URC sensors.

USB : Mini_USB for future firmware upgrade use.

RF Range(radio frequency) : 50 to 100 feet, depending upon the

environment

RF Frequency : 2.405 ~ 2.480 GHz

Weight : 2.98oz

Size : 3.74” X 2.7” X 1.1”

Power : 12V DC 1A

Andere Handbücher für Total Control MRX-4SEN

Inhaltsverzeichnis

Andere URC Extender Handbücher

URC

URC Z Extender TRF-UZ1 Bedienungsanleitung

URC

URC Total Control MRX-4SEN Bedienungsanleitung

URC

URC Total Control MRX-4SEN2 Bedienungsanleitung

URC

URC Total Control MRX-4SEN Bedienungsanleitung

URC

URC TRF-GE1 Bedienungsanleitung

URC

URC Z Extender TRF-UZ1 Bedienungsanleitung

URC

URC Total Control TRF-ZW1 Bedienungsanleitung

Beliebte Extender Handbücher anderer Marken

SY HDBT-60T Bedienungsanleitung

Appsys ProAudio

Appsys ProAudio ADX-16 Bedienungsanleitung

Atlona

Atlona RS232 Bedienungsanleitung

IDK

IDK OPF-TH1000-A Bedienungsanleitung

Enable-IT

Enable-IT 824WP Bedienungsanleitung

Worx

Worx Landroid RadioLink WA0864 Technisches Datenblatt

TP-Link

TP-Link TL-WA730RE Bedienungsanleitung

Camplex

Camplex CMX-HDMI-SFPL Bedienungsanleitung

SC&T

SC&T HE03-4K Bedienungsanleitung

Marmitek

Marmitek MegaView70 Bedienungsanleitung

Samsung

Samsung SCS-26UC4 Bedienungsanleitung

Foxun

Foxun SX-GES24 Bedienungsanleitung

MuxLab

MuxLab 500771 Bedienungsanleitung

foxunhd

foxunhd SX-AEX01 Bedienungsanleitung

TERK Technologies

TERK Technologies LFIRX2 Bedienungsanleitung

Devolo

Devolo Audio Extender Handbuch

Edimax

Edimax EW-7438RPn V2 Bedienungsanleitung

Shinybow USA

Shinybow USA SB-6335T5 Bedienungsanleitung