Instructions 操作说明
LED Fresnel Spotlight with Electric zoom If the product has gone through a large
temperature difference (for example, after transportation), do not start the product
immediately
The product will be damaged due to thermal expansion and contraction. Please wait until
the device reaches normal room temperature before starting the product.
Pay attention to shocks. Avoid strong collisions during product installation.
Please do not lift the entire product by the lamp cap, because the mechanical properties of
the equipment may be damaged.
When choosing an installation location, make sure that the product is not exposed to
excessive heat, humidity or dust. Please do not put any wires on the ground, otherwise
there may be danger of electric shock.
Before installing the product, make sure that the installation point is safe.
Please fasten the product with a safety rope and check if all the screws are correct when
installing
Make sure that the lens is in good condition. When the lens is damaged or scratched,
please replace the lens.
It is recommended that technicians familiar with this product operate this product.
Non-technical personnel are forbidden to operate this equipment, because many losses
are the result of non-professional operation.
Please keep the packing materials properly in case you need to carry out the second
transportation.
If there is no guidance from the manufacturer or distributor, please do not modify the
product without authorization.
Any equipment failure caused by the operation and use of this equipment not in
accordance with the provisions of the manual is not covered by the warranty. And any
accidents caused by short circuit, injury, electric shock, ultraviolet rays, lamp explosion,
etc. caused by this are not covered by the warranty.
4. Product hanging and installation
Note: For more safety, please hang and install this product away from aisles, seating
areas, or areas within reach of people.
Before hanging the product, make sure that the installation point can bear 10 times the
weight of the product.
The product installation must have double protection devices, such as safety ropes.
When hanging, removing or repairing this product, it is forbidden to stand under the
installation point
本产品是 LED 电动调焦聚光灯。
假如产品在经过 较大的温度差后（例如，运输后），则不要马上启动产品
因为热涨冷缩会损坏到产品。请等到设备达到正常室温后再启动产品。
注意防震。产品安装过程中避免强烈碰撞。
请不要通过灯头举起整个产品，因数这样设备的机械性可能会受损。
选择安装地点时请确保产品未暴露在过热、太湿或多灰尘的地方。请不要把任何电线置于地
