Page 2
!!
PLEASE READ THE F LL WING INSTRUCTI NS VERY CAREFULLY BEF RE USING THE PR DUCT. THE
MANUFACTURER WILL N T BE HELD RESP NSIBLE AND DECLINES ANY AND ALL LIABILITY F R DAMAGE
CAUSED T PERS NS R PR PERTY DUE T IMPR PER USE WITH REFERENCE T THE PRECAUTI NS
UTLINED IN THIS MANUAL.
""
! 5"/125mm spigot, for dwellings up to 200m2, max capacity 404m3/hr
*+44:/$1.+0&+%#5'45*#5%#3'/645$'5#-'0+0+045#..+0)5*+4231&6%5+013&'351
#71+&215'05+#..:.'5*#.+0,63:$15*51+045#..'3#0&64'3*+4+04536%5+10$'(1..18'&(13
+045#..#5+10
1. Do not use this product for any purpose other than that for which it was designed and as shown in this leaflet.
2. Remove all packaging and check that your fan has not been damaged in transit. If in doubt, contact your
supplier.
3. Do not leave packaging within the reach of children or unskilled people. Dispose of hazardous waste (poly
styrene, plastic, polypropylene, etc.) responsibly.
4. If the product is dropped or badly knocked, contact your supplier, dealer or manufacturer to ensure that it is
operating properly.
5. Using any electrical equipment requires compliance with basic safety rules:
- the product must not come into contact with liquid of any sort
- the product must not be operated by children or other unskilled people.
6. The product should only be connected to the mains electricity supply or electrical outlet if:
- your electrical voltage and frequency correspond to those shown on the rating label.
- the capacity of your electricity supply is sufficiently powerful to operate the product at its maximum power
If this is not the case, contact professionally qualified personnel.
7. Before carrying out any maintenance or cleaning operation, the product must be switched off and disconnect
ed from the main power supply..
8. If a fault, malfunction or anomaly of any type occurs, the product should be made inoperative (by turning off
the switch and by disconnecting it from the mains electricity supply) and qualified personnel contacted imme
diately. Always request original spare parts to carry out any repairs.
9. If the product needs to be removed, turn off the main network circuit-breaker and then disconnect the appli
ance from that network.
10. The unit should be installed in a safe location as far away as possible from children and/or unskilled people.
11. The electricity system to which the product is connected must comply with the current standards.
013&'351%1/2.:8+5*104536%5+10'4+)0#0#)'/'05')6.#5+10446((+%+'05#%%'44(134#('
/#+05'0#0%'133'/17#.(1..18+0)+045#..#5+10$'2317+&'&(135*+4231&6%5
*+44:/$1.+0&+%#5'45*#5%#3'/645$'5#-'051#71+&&#/#)+0):163231&6%5
8*'0(1..18+0)5*'4'+04536%5+104
1. This product is professionally manufactured and complies with the current standards regarding electrical
equipment
2. This product conforms with the EEC directive EMC 89/336 concerning the suppression of radio interference
and electromagnetic compatibility.
3. This product must not be used in an ambient temperature greater than 40 °C (104 °F).
4. Do not leave the product exposed to the weather (rain, sun, snow, etc.).
5. Possible product applications are indicated in this leaflet.
6. Do not place the unit or any part of it in water or liquids, except as indicated in the cleaning and maintenance
section.
7. When cleaning or performing routine maintenance, check the condition of the appliance.
8. To avoid the risk of fire, do not use the product in the presence of inflammable substances or vapours such
as alcohol, insecticides, gasoline, etc.
9. The air or fumes being extracted must be clean and free from greasy particles, soot, chemicals and
corrosive agents, inflammable or explosive mixes (if these substances are treated, conctact an authorised
dealer for information on a specific range of explosion-proof products).
10. The device must be installed by professionally qualified personnel.
