VERDER CARBOLITE GERO PF 800 Handbuch

Installation, Operation and Maintenance Instructions

250 °C Peak Fan Convection Oven - PF Model: 800 Litres

No Controller

PF 800 + No Controller

MEN-PF800-005_NOCTRL (18-10-2021)

Contents

This manual is for guidance on the use of the Carbolite Gero product specified on the

front cover. This manual should be read thoroughly before unpacking and using the

furnace or oven. The model details and serial number are shown on the back of this

manual. Use the product for the purpose for which it is intended.

1.0 Symbols and Warnings 4

1.1 Switches and Lights 4

1.2 General Warnings 5

2.0 Installation 6

2.1 Unpacking and Handling 6

2.2 Siting and Setting Up 6

2.3 Electrical Connections 8

3.0 Temperature Controller 10

4.0 Operation 11

4.1 Operating Cycle 11

4.2 Over-Temperature Control (if fitted) 11

4.3 Vents 11

4.4 Temperature Uniformity 12

4.5 Explosive Vapours 12

4.6 Atmospheres 12

4.7 Interior Light (if fitted) 12

4.8 Solenoid Valve with Manual Switch (if fitted) 12

4.9 Variable Speed Fan (if fitted) 13

4.10 Exhaust Fan (if fitted) 13

4.11 Stoving and Curing (if fitted) 13

4.11.1 Pre-heater (if fitted) 13

4.12 Door Switch (if fitted) 14

5.0 Maintenance 15

5.1 General Maintenance 15

5.2 Maintenance Schedule 15

5.2.1 Cleaning 17

5.3 Calibration 17

5.4 After-Sales Service 17

5.5 Recommended Spare Parts and Spare Parts Kit 17

5.6 Power Adjustment 17

6.0 Repairs and Replacements 19

6.1 Safety Warning - Disconnection from Power Supply 19

6.2 Safety Warning - Refractory Fibre Insulation 19

6.3 Panel Removal 20

6.3.1 Side Panel 20

6.3.2 Internal Element Cover 20

6.4 Temperature Controller Replacement 21

6.5 Solid-State Relay Replacement 21

6.6 Thermocouple Replacement 21

6.7 Element Replacement 21

6.8 Fuse Replacement 22

7.0 Fault Analysis 23

A. Oven Does Not Heat Up 23

B. Oven Overheats 23

8.0 Wiring Diagrams 24

8.1 WV-33-00 24

8.2 WV-33-01 25

9.0 Fuses and Power Settings 27

9.1 Fuses 27

9.2 Power Settings 27

10.0 Specifications 28

10.1 Environment 28

1.0 Symbols and Warnings

1.1 Switches and Lights

Instrument switch: when the instrument switch is operated the

temperature control circuit is energised.

Door lock indicator: When this lamp is illuminated, the door is locked

and cannot be opened.

Interior light: when the interior light switch is operated the interior

light illuminates.

Solenoid valve (if fitted): see section 4.8 for full details

Variable speed fan (if fitted): see section 4.9 for full details

Exhaust fan (if fitted): see section 4.10 for full details

Stoving and curing (if fitted): see section 4.11 for full details

1.2 General Warnings

DANGER – Electric shock. Read any warning printed next to this

symbol.

WARNING: Risk of fatal injury.

DANGER – Hot surface. Read any warning printed next to this

symbol.

WARNING: All surfaces of a product may be hot.

DANGER – Read any warning printed next to this symbol.

Caution – Double Pole/Neutral Fusing

2.0 Installation

2.1 Unpacking and Handling

Remove the shelves and runners from the packaging before attempting to move the

equipment.

When unpacking and handling the product, always lift it by its base. Do not use the

door or any other projecting cover or component to support the equipment when

moving it. Use two or more people to carry the product where possible.

Carefully remove any packing material from inside and around the product before use.

Avoid damaging the surrounding insulation when removing packing materials.

Locate the shelves and runners as required.

2.2 Siting and Setting Up

Place the product on a level surface in a well ventilated area.

Site away from other sources of heat and on a non-flammable surface that is resistant

to accidental spillage or hot materials.

The surface on which the equipment is mounted should be stable and not subject to

movement or vibrations.

The height of the mounting surface is important to avoid operator strain when loading

and unloading samples.

Unless otherwise stated elsewhere in this manual, ensure that there is at least 150

mm of free space around the back and sides of the product. Clear space is required

above the product to dissipate heat.

Ensure that the product is placed in such a way that it can be quickly switched off or

disconnected from the electrical supply.

Some models have protruding fan motor housings: these housings must be in an area

of good ventilation.

Under no circumstances should any objects be placed on top of the

product. Always ensure that any vents on the top of the product are clear

of any obstruction. Always ensure all cooling vents and cooling fans (if

fitted) are clear of any obstruction.

The ends of the runners should be inserted into the vertical

columns of holes simultaneously at the front and the back. The

bar should then be rotated through 90° in a downwards

direction to secure it in place. The shelves slide onto the

runners such that the spurs on the lower side of the shelf are

under the bar at the back; this prevents the shelf from tilting

forwards when partially withdrawn.

Do NOT use the oven floor as a shelf.

Key

A Runner

B Shelf

C Spur

2.3 Electrical Connections

Connection by a qualified electrician is recommended.

All models covered by this manual may be ordered for single phase A.C. supply, which

may be Live to Neutral non-reversible, Live to Neutral reversible or Live to Live.

Check the product rating label before connection. The supply voltage should agree with

the voltage on the label and the supply capacity should be sufficient for the current on

the label.

The supply should be fused at the next size equal to, or higher than the current on the

label. This manual contains a table of the most common fuse ratings.

When the mains cable is factory fitted, internal fuses are also fitted. It is essential that

the operator ensures that the product is correctly fused.

Products with a factory fitted supply cable are designed to be wired directly to an

isolator or fitted with a line plug.

Products without a factory fitted supply cable require a permanent connection to a

fused and isolated supply. The product's electrical access panel should be temporarily

removed, and connections made to the internal terminals.

When connecting the product to the power supply, the plug or isolating switch should

be accessible, easy to remove, and within reach of the operator.

The supply MUST incorporate an earth (ground).

Supply Terminal Label Cable Colour

Supply Types

Live - Neutral Reversible or Live-

Live

1-phase L1 Brown to live

to either power

conductor

(For USA 200-240V,

connect L1)

N / L2 Blue to neutral

to the other power

conductor

(For USA 200-240V,

connect L2)

PE Green/ Yellow to earth

(ground) to earth (ground)

Electrical Connection Details:

2- or

3-phase L1 Black to phase 1

L2 Black to phase 2

L3 Black to phase 3 (except 2-phase)

N Light Blue to neutral (except delta)

PE Green/ Yellow to earth (ground)

3.0 Temperature Controller

If this product is fitted with a temperature controller, instructions are provided

separately.

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere VERDER Ofen Handbücher

VERDER

VERDER CARBOLITE GERO MFS1 ISO Handbuch

VERDER

VERDER CARBOLITE GERO CR/130 Handbuch

VERDER

VERDER Carbolite Gero PN 200 Handbuch

VERDER

VERDER CARBOLITE GERO LGP 4/730 Handbuch

VERDER

VERDER CARBOLITE GERO LGP 4/2160 Handbuch

VERDER

VERDER CARBOLITE GERO TLD 28 Handbuch

VERDER

VERDER CARBOLITE GERO LGP 2/500 Handbuch

VERDER

VERDER CARBOLITE GERO HTCR 5/95 Handbuch

VERDER

VERDER CARBOLITE GERO HTCR 6/220 Handbuch

VERDER

VERDER CARBOLITE GERO PF 30 Handbuch

VERDER

VERDER CARBOLITE GERO LGP 7/1750 Handbuch

VERDER

VERDER CARBOLITE GERO LGP 2/1000 Handbuch

VERDER

VERDER CARBOLITE GERO LGP 4/3370 Handbuch

VERDER

VERDER CARBOLITE GERO LGP 6/1000 Handbuch

VERDER

VERDER CARBOLITE GERO LGP 2/2160 Handbuch

VERDER

VERDER CARBOLITE GERO CR/220 Handbuch

VERDER

VERDER CARBOLITE GERO LGP 6/730 Handbuch

VERDER

VERDER CARBOLITE GERO PF 400 Handbuch

VERDER

VERDER CARBOLITE GERO LGP 4/1500 Handbuch

VERDER

VERDER Carbolite Gero LGP 6/1500 Handbuch

VERDER

VERDER CARBOLITE GERO PF 200 Handbuch

VERDER

VERDER CARBOLITE GERO LHT 4/30 Handbuch

VERDER

VERDER CARBOLITE GERO HTCR 4/95 Handbuch

VERDER

VERDER CARBOLITE GERO LGP 4/500 Handbuch

Beliebte Ofen Handbücher anderer Marken

Bosch

Bosch HVA531NS0 Bedienungsanleitung

Electrolux

Electrolux EOF6P46X Bedienungsanleitung

NEFF

NEFF B44S32 5GB Series Bedienungsanleitung

Combi

Combi BLODGETT BC142GDS Bedienungsanleitung

AEG

AEG COMPETENCE 311704300 Bedienungsanleitung

Rational

Rational SCC WE 61G Bedienungsanleitung

Smeg

Smeg DOSPA38X Installations- und Betriebshandbuch

Electrolux

Electrolux air-o-convect 20 GN 2/1 Bedienungsanleitung

Miele

Miele HR 1954-2 Bedienungsanleitung

KHIND

KHIND OT50 Bedienungsanleitung

Henny Penny

Henny Penny Smoker Box Bedienungsanleitung

Lang

Lang ECOD-AP Bedienungsanleitung

AEG

AEG BEK455310M Bedienungsanleitung

Frigidaire

Frigidaire FNGE90JGR Bedienungsanleitung

Hotpoint

Hotpoint FE9 S831 JSH IX Bedienungsanleitung

GE Advantium SCB2000 Bedienungsanleitung

AEG

AEG DE401301DM Bedienungsanleitung

DeLonghi

DeLonghi XA660 Handbuch