Vertiv Liebert PSI PS2200RT3-120 Bedienungsanleitung

Liebert® PSI™

750/1000/1500/1920/3000VA, 60Hz,120VAC

User Manual

DISCONTINUED

Technical Support Site

If you encounter any installation or operational issues with your product, check the pertinent section of

this manual to see if the issue can be resolved by following outlined procedures. Visit

https://www.VertivCo.com/en-us/support/ for additional assistance.

DISCONTINUED

TABLE OF CONTENTS

Important Safety Instructions 1

Glossary of Symbols 5

1 Introduction 7

2 What’s Included 9

3 Installation 11

3.1 Preparation 11

3.2 Tower UPS Installation 11

3.3 Rack-Mount UPS Conversion and Installation 12

3.4 Orient Display for Installation 13

3.5 Charge Batteries and Perform Battery Startup 14

3.6 Connect Input Power and Load 14

3.7 Connect Network Surge protection 15

3.8 Connect Computer Interface Port 16

3.9 Set Up Liebert MultiLink software 16

3.10 EPO Switch 17

4 Controls and Indicators 19

4.1 Control Buttons 19

4.1.1 On/Alarm Silence/Manual Self-Diagnostic Test 19

4.1.2 Off Button 20

4.2 Status Indicators 20

4.2.1 Status Change Button 20

4.2.2 Load Level Indicator 20

4.2.3 Battery Level Indicator 21

4.2.4 UPS Status Indicators 21

5 Operational Modes 23

5.1 Normal Mode 23

5.2 Buck/Boost Mode 23

5.3 Battery Mode 23

5.4 Battery Recharge Operation 23

6 Communication 25

6.1 DB-9 Connector 25

6.2 Remote Shutdown Via the DB-9 Connector 25

6.2.1 Any Mode Shutdown Via Pins 5 & 6 25

6.2.2 Battery Mode Shutdown Via Pins 4 & 5 25

6.3 Network Surge Protection Connectors 26

6.4 UPS Communication 26

6.5 UPS Inverter/Transfer Voltage Configurations 26

7 Battery Maintenance 27

7.1 Battery Charging, Storage 27

7.2 Internal Battery Replacement Procedure 27

Vertiv | Liebert® PSI™ User Manual | i

DISCONTINUED

8 Specifications 29

Vertiv | Liebert® PSI™ User Manual | ii

DISCONTINUED

IMPORTANT SAFETY INSTRUCTIONS

SAVE THESE INSTRUCTIONS

This manual contains important instructions that should be followed during installation and maintenance

of the UPS.

•Intended for installation in a temperature-controlled, indoor area free of conductive

contaminants.

•Maximum ambient temperature 104°F (40°C).

Read this manual thoroughly before attempting to install or operate this UPS.

The equipment can be installed and operated by individuals without previous training.

CAUTION: To reduce the risk of fire, connect PS3000RT3-120 models only to a circuit provided

with 30 amperes maximum branch circuit overcurrent protection in accordance with the

National Electric Code, ANSI/NFPA 70. Other Liebert PSI models must be connected to a circuit

with 20 amperes maximum branch circuit overcurrent protection.

WARNING! Operate the UPS only from a properly grounded (earthed) 110-127VAC, 50Hz or

60Hz AC supply.

Some components are live, even when AC power is disconnected. For service, contact a

properly trained and qualified technician. Do not remove the cover; the UPS has no

user-serviceable parts inside except the internal battery pack.

WARNING! Although the UPS has been designed and manufactured to ensure personal safety,

improper use can result in electrical shock or fire. To ensure safety, observe the following rules:

Turn Off and unplug the UPS before cleaning it. Clean the UPS with a dry cloth. Do not use

liquid or aerosol cleaners.

Do not install or operate the UPS in or near water.

Never block or insert any objects into the ventilation holes or other openings of the UPS. Keep

all vents free of dust accumulation that could restrict air flow.

Do not place UPS power cord anywhere it might be damaged.

Vertiv | Liebert® PSI™ User Manual | 1

DISCONTINUED

Battery Handling Precautions

WARNING! Batteries should be replaced only by properly trained and qualified personnel

knowledgeable of batteries and required precautions.

A battery can present a risk of electrical shock and high short-circuit current. The following

precautions must be observed when working on batteries:

Remove watches, rings and other metal objects.

Use tools with insulated handles.

Do not dispose of the battery or batteries in a fire. The battery may explode.

Do not open or mutilate the battery or batteries. Released electrolyte is toxic. It may cause

injury to the skin and eyes.

When replacing the battery, use the same type of battery as is listed in Table 8-1.

Handle, transport and recycle batteries in accordance with local regulations.

CONDITIONS OF USE —The input supply outlet must be within 6 ft. (1.8m) of the UPS and be easily

accessed.

This UPS provides conditioned power to connected equipment. It is not intended for use with life-support

and other designated “critical” devices. Maximum load must not exceed that shown on the UPS rating

label. If uncertain, consult your local dealer, local Vertiv representative or Channel Support Applications.

When installing the UPS or making input and output connections, comply with all relevant safety codes

and standards (e.g., UL 1778).

Placing magnetic storage media on top of the UPS may result in data corruption.

ELECTROMAGNETIC COMPATIBILITY—The Liebert PSI complies with part 15 of the FCC Rules.

Operation is subject to the following two conditions:

•This device may not cause harmful interference, and

•This device must accept any interference received, including interference that may cause

undesired operation.

This equipment uses, generates and can radiate radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful interference with radio communications. However,

there is no guarantee that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, the user is encouraged to try to correct the

interference by one or more of the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the UPS and the receiver.

•Connect the UPS to an outlet on a circuit different from the one the receiver is connected to.

Vertiv | Liebert® PSI™ User Manual | 2

DISCONTINUED

NOTICE

Do not connect equipment that could overload the UPS or demand half-wave rectification from

the UPS, such as electric drills, vacuum cleaners, laserjet printers and hair dryers.

Vertiv | Liebert® PSI™ User Manual | 3

DISCONTINUED

Vertiv | Liebert® PSI™ User Manual | 4

This page intentionally left blank.

DISCONTINUED

GLOSSARY OF SYMBOLS

Risk of electrical shock

Indicates caution followed by important instructions

Indicates the unit contains a valve-regulated, lead-acid battery

Recycle

DC voltage

Equipment grounding conductor

Bonded to ground

AC voltage

ON/Alarm Silence/Manual Self-Diagnostic Test

OFF

Status Change Button

Vertiv | Liebert® PSI™ User Manual | 5

DISCONTINUED

Vertiv | Liebert® PSI™ User Manual | 6

This page intentionally left blank.

DISCONTINUED

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Vertiv UPS Handbücher

Vertiv

Vertiv Liebert MicroPOD Montage- und Wartungsanleitung

Vertiv

Vertiv Liebert EDGE Series Montage- und Wartungsanleitung

Vertiv

Vertiv LIEBERT PSI5 Series Bedienungsanleitung

Vertiv

Vertiv Liebert Montage- und Wartungsanleitung

Vertiv

Vertiv 10H92873 Bedienungsanleitung

Vertiv

Vertiv Liebert PSA5 Bedienungsanleitung

Vertiv

Vertiv Liebert GXT5-8000HVRT5UXLN Bedienungsanleitung

Vertiv

Vertiv Liebert GXT5 Bedienungsanleitung

Vertiv

Vertiv Liebert NXL 500kVA Bedienungsanleitung

Vertiv

Vertiv Liebert PSA4 Montage- und Wartungsanleitung

Vertiv

Vertiv NetSure NSFP200 Bedienungsanleitung

Vertiv

Vertiv Liebert GXT4 Series Bedienungsanleitung

Vertiv

Vertiv Liebert GXT5 Bedienungsanleitung

Vertiv

Vertiv Liebert CW Series Benutzerhandbuch

Vertiv

Vertiv Liebert PST4-660MT120 Montage- und Wartungsanleitung

Vertiv

Vertiv Liebert EXS 10kVA Bedienungsanleitung

Vertiv

Vertiv Liebert APM Bedienungsanleitung

Vertiv

Vertiv Liebert NXC 0060kTJ1AFN02000 Bedienungsanleitung

Vertiv

Vertiv LIEBERT EXS 208/220-V 30 KVA Bedienungsanleitung

Vertiv

Vertiv Liebert PST4-350MT120 Montage- und Wartungsanleitung

Vertiv

Vertiv Avocent HMXCC1-G2 Bedienungsanleitung

Vertiv

Vertiv Liebert ITA2 Bedienungsanleitung

Vertiv

Vertiv Liebert GXT5 Montage- und Wartungsanleitung

Vertiv

Vertiv Liebert GXT5-500LVRT2UXLN Montage- und Wartungsanleitung

Beliebte UPS Handbücher anderer Marken

Pylontech

Pylontech Victron & Pylontech US5000 Bedienungsanleitung

Tecnoware

Tecnoware EVO DSP PLUS MM 6.8 Bedienungsanleitung

Mecer

Mecer ME-1000-WTU Bedienungsanleitung

Mustek

Mustek PowerMust 530(B) Plus Installations- und Betriebshandbuch

Emerson

Emerson Liebert NXL series Bedienungsanleitung

MAKELSAN

MAKELSAN BOXER SERIES Bedienungsanleitung

Block

Block PC-0524-400-0 Bedienungsanleitung

CyberPower

CyberPower CP585LCD Bedienungsanleitung

Eaton

Eaton 3S Montageanleitung

CyberPower

CyberPower Office Tower Series UPS 1000 Bedienungsanleitung

CyberPower

CyberPower BM100 Bedienungsanleitung

Best Power

Best Power 610 Bedienungsanleitung

Best Power

Best Power Unity/I UT3K Bedienungsanleitung

Mustek

Mustek PowerMust 400 Offline Bedienungsanleitung

Xantrex

Xantrex Trace 512 UR-UPS Bedienungsanleitung

Forza

Forza SL-1501UL Bedienungsanleitung

LEGRAND

LEGRAND keor 310081 Bedienungsanleitung

ABB

ABB Conceptpower DPA 500 Bedienungsanleitung