Preparations before use
●Check the air pressure
The specified air pressure for this air tool is 0.6 MPa. If the input air
pressure surpasses this specified level, it will cause damage on the unit
or individual parts.
●Remove the drain
When moisture or impurities like rust in the pipe get into the mechanism,
it may cause malfunction. Remove accumulated drain in the compressor
before use. To secure dry air supply, install an air filter in order to prevent
moisture and any impurities.
●Use an appropriate air hoses
Please refer to Specifications for choosing an air hose of the appropriate
size for the applied air supply. If the internal diameter of the air hose is
too small, sufficient power may not be obtained as air pressure cannot
increase efficiently. It also happens when the hose is too long.
●Install the plug
Use a spanner of No.17 to holdAir Inlet Bushing
and fasten the plug.
●Air coupling
When using the air coupling included in the package, purchase a
compatible connector. When connecting a hose directly to this product,
purchase a hose connection coupling. In both cases, check the size of
the connected hoses.
●Before the first operation after purchase
Attach the scraper before connecting the air hose to the unit. When this
air tool has been newly installed or the air hose has been replaced, blow
and clean the inside of the hose and piping. Then, idle the device for a
few seconds because lubricant within the mechanism has to be blasted
out with exhaust air.
