VEVOR SC-1 Bedienungsanleitung

Slushy Machine Manual

INTRODUCTION

Model: SC-1，SC-2，SC-3

Congratulations ! You are the owner of not only the finest slush machines but also the

most versatile of its kind.

Please read all sections of this manual thoroughly to familiarize yourself with all

aspects of the unit.

INSTALLATION

NOTE: Note This appliance is not intended for use by persons(including children)

with reduced physical, sensory or mental capabilities, or lack of experience and

knowledge, unless they have been given supervision or instruction concerning use of

the appliance by a person responsible for their safety.

Children should be supervised to ensure that they do not play with the appliance.

Type Y attachment

If the power supply cord is damaged , it must be replaced by the manufacturer or its

service agent or a similar qualified person in order to avoid an hazard.

1. Remove the corrugated container and packing materials and keep them for

possible future use .

CAUTION! When handling the machine never grip it by the tanks/bowls or

evaporator cylinders .The manufacturer and supplier will NOT be held

responsible for any damages which may occur through incorrect handling.

2. Inspect the uncreated unit for any possible damage

1) If any damage, please call the delivering carrier immediately.

2)If the power cord is damaged, it must be replaced by the manufacturer, service

agent or a qualified electrician in order to avoid any hazard.

3. Install the unit on a counter top that will support the combined weight of the

dispenser and product, bearing in mind what is stated in the preceding point 1,

CAUTION paragraph.

4. When installing the unit allow for adequate air space. Facing the unit from the

dispensing side, a minimum of 15 cm (6”) of free air space should be allowed at

the rear and on each side of the machine.

5. Ensure that the foot pieces are screwed tight into the base of the machine .

6. Clean and sanitize the unit according to the instructions in this manual . See the

“CLEANING” paragraph .

7. Fill the bowls(tanks) with mix to the maximum level mark .

Do not overfill .

All food touching parts are safe for your health. The machine can be used to chill

juice, coffee and make slush. After a business day, switch off the power and

remove the mixture. Keep the mix fresh over night by storing it in a fridge.

8. Before plugging the unit in check to see if the voltage is correct and the same as

indicated on the data plate. Plug the unit into a grounded, protected single phase

electrical supply according to the applicable electrical codes and the specifications

of your machine. When the unit has no plug, install a proper plug, in compliance

with electrical codes in your area suitable to bear at least 10 amp, 115 volt and

equipped with a ground. Should you prefer to connect the unit directly to the

mains system, connect the supply cord to the breaker, with a contact opening of at

least 3 mm.

Warning!! Failure to provide proper electrical ground could result in serious

electrical shock hazard.

9. Please do not operate the machine without mixture inside the bowl, no mix or

incorrect mix will cause damage to the machine.

DONT RUN WITH WATER ONLY, the water will freeze.

Note

The freezing time of slush depends according to the ambient temperature and the

initial product temperature.

Model

SC-1

SC-2

SC-3

Bowl (n)

Capacity (L)

1X12

2x12

3x12

Power Supply

110V/60Hz

Power(W)

500W

700W

900W

DESCRIPTION OF CONTROLS

1. Power switch

“|” position- ON: in the “|” position power is turned ON to all functions

“O” position- OFF: in the “O” position power is turned OFF to all functions

2. A,B,C switches will be used during operation, you can adjust the temperature of

the juice. The temperature is 3℃,5℃, 9℃, 11℃.It is factory set at 9 ℃.

3Refrigeration switch

Operation:

a. Set the power switch to ON position

b. Set the Refrigeration switch as follows:

Press :

1) Light ON : Slush mode, slushed ice will be produced.

When the light is ON ,the machine will start working ,there is a 6 second

countdown. The magnetic valve will now be open. A 300 second countdown will start

now. After 300 seconds, the compressor will start to refrigerate and will automatically

stop when the slush is ready. The fan motor and beater will continue to work .

ATTENTION

To obtain the best performance of slush ice, make sure the sugar content is over

13% or the contents will freeze up and cause damage to the machine.

2) Light ON: Juice mode, only produce cold beverage

When the Light is ON, the machine will start to work and stop when the

temperature reached the required setting.

3) A,B,C switches will be used during the chilling of the beverage. You can adjust the

juice temperature to 3℃,5℃,9℃,11℃.It is factory set at 9 ℃.

4.Separate Control Switch

A、B、C switch

You will find switches at the right side panel of the machine which controls each

bowl/tank separately.

1. Press A switch -Start or stop left bowl

2. Press B switch - Start or stop middle bowl

3. Press C switch - Start or stop right bowl

CLEANING

Cleaning and sanitizing of the dispenser is recommended to be performed daily.

This section is a guideline only and is subject to the requirements of the local

Health Authorities.

Disassembly

1. Disconnect the dispenser by unplugging it or switching off the breaker.

2. Remove the cover from the bowl.

3.Remove the bowl by lifting its faucet side up and off the fastening

hooks(fig.1)and side it out(fig.2)

figure 1 figure 2

4.Slide the outer spiral out (fig.3)and then the inner auger (fig.4)

5.Remove the bowl gasket from its seat(fig .5)

6.Dismantle the faucet assembly(fig .6)

7.Slide the drip tray out and empty it.

Cleaning

Clean all removed parts and evaporator cylinder using warm and mild nonabrasive

food-grade detergent. Sanitize according to “SANITIZING” instructions.

Assembly:

1.Slide the drip tray into place.

2. Lubricate the faucet piston, inside auger and outer spiral (see points A,B

and C of figure 7) only with the grease supplied by the manufacture or other

“food grade approved ”lubricant.

3. Assemble the faucet by reversing the disassembly steps(fig.6)

4.Fit bowl gasket around its seat (fig.8)

Figure 8

NOTE: The largest brim if the gasket faces the rear wall.

4.Insert the auger into the evaporator taking care to accompany it to the end so in

order to prevent it from hitting against the rear wall (fig.10).Install the outer spiral

by sliding it over the evaporator until its front notch engages with the exposed end

of the auger shaft(fig.9)

figure 10 figure 9

5.Push the bowl/tank towards the rear wall of

the unit until it fits snugly around the gasket.

The front fastening hooks must properly engage

(fig.11). Use fresh mix to remove any

remaining sanitizer from the bottom of the

bowls/tanks. Drain this solution and do not

rinse out the machine.

SANITIZING

Prepare a cleaning solution of sodium hypochlorite (1 spoon diluted with 2 liters

of water ).

Sanitize the bowl/tank, gasket and all parts that come in contact with beverage. Rinse

with clear water as recommend.

HELPFUL HINTS

Thickness Adjustment (fig.12)

Figure 12

Proper slush thickness is factory preset.

To change the thickness. (If needed). Use a standard screwdriver turn to the

adjustment screw located at the rear wall of each bowl/tank as follows:-towards the

right(clockwise) to obtain thinner product(the indicator F will go up in opening G)

-towards the left(counter clockwise)to obtain thicker product(the indicator F

figure 11

will go down in opening G)

Note

-To shorten slush recovery time and increase production, the bowl should be refilled

after the product level is lower than half of the evaporator cylinder.

-Before restarting the unit, ensure that no blocks of ice have formed, if so remove

them before switching on the unit.

Excessive Heating

The dispenser must be able to emit heat. If the heat seems excessive, please check that

no heating source is close to the unit and allow at least 15cm of free space all around

the dispenser.

MAINTENANCE

Cleaning all internal components and CONDENSER monthly, using a brush. Make

sure the condenser is dust free with no obstructions, at all times.

Note: Remove the plug from the wall socket before cleaning.

SPARE PARTS LIST

406

407

409

408

404

405

403

402

401

446 445 432435437 431433439 438 434436441 440442443444

424

425

427

426

428

429

430

423422421418 419 420

417

416

414 415413412411410

448

447

NR. SPARE PARTS LIST

401

Top Cover

402

Lining-Top Cover

403

Bowl/Tank

404

Draw Valve

405

Seal-Draw Valve

406

Spring

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere VEVOR Küchengerät Handbücher

VEVOR

VEVOR YD-302C-B-Z Bedienungsanleitung

VEVOR

VEVOR DH805 Bedienungsanleitung

VEVOR

VEVOR GB-GO16A-R Bedienungsanleitung

VEVOR

VEVOR SC-5XD Bedienungsanleitung

VEVOR

VEVOR YZQ-2L Bedienungsanleitung

VEVOR

VEVOR JYC-1100 Bedienungsanleitung

VEVOR

VEVOR NP08001SEC Bedienungsanleitung

VEVOR

VEVOR DM21-U Bedienungsanleitung

VEVOR

VEVOR MHTJJPZY01 Bedienungsanleitung

VEVOR

VEVOR MHTJJPZY02 Bedienungsanleitung

VEVOR

VEVOR CS-2-EU Bedienungsanleitung

VEVOR

VEVOR VS5164 Bedienungsanleitung

VEVOR

VEVOR EZL-EH-30S-E Bedienungsanleitung

VEVOR

VEVOR JS-75-GD-01 Bedienungsanleitung

VEVOR

VEVOR SP354003S Bedienungsanleitung

VEVOR

VEVOR F-8908 Bedienungsanleitung

VEVOR

VEVOR G-SKU1 Bedienungsanleitung

VEVOR

VEVOR QF-150 Bedienungsanleitung

VEVOR

VEVOR CZ-5 Bedienungsanleitung

VEVOR

VEVOR ZH-PT-21M Bedienungsanleitung

VEVOR

VEVOR C113 Bedienungsanleitung

VEVOR

VEVOR RSHPGZ20YC Bedienungsanleitung

VEVOR

VEVOR DT-318 Bedienungsanleitung

VEVOR

VEVOR DM11-U Bedienungsanleitung

Beliebte Küchengerät Handbücher anderer Marken

Tayama

Tayama TYG-35AF Bedienungsanleitung

AEG

AEG 43172V-MN Bedienungsanleitung

REBER

REBER Professional 40 Benutzerhandbuch

North American

North American BB12482G / TR-F-04-B-NCT-1 Bedienungsanleitung

Presto

Presto fountain popper Bedienungsanleitung

Westmark

Westmark 1035 2260 Bedienungsanleitung

Zanussi

Zanussi ZCG64396XA Bedienungsanleitung

HOFFEN

HOFFEN SM-9302M Bedienungsanleitung

Philips

Philips HD3133 Bedienungsanleitung

Ronco

Ronco Beef Jerky Bedienungsanleitung

Hendi

Hendi 470411 Bedienungsanleitung

Livoo

Livoo MEN386 Bedienungsanleitung

croydon

croydon WR-10313-700 Bedienungsanleitung

Chefman

Chefman RJ43-SQ Series Bedienungsanleitung

Vacmaster

Vacmaster VP680 Bedienungsanleitung

Jetmaster

Jetmaster 900HG Bedienungsanleitung

Küppersbusch

Küppersbusch EEH 610.0 Kurzanleitung zur Einrichtung

HURAKAN

HURAKAN HKN-F10 Bedienungsanleitung