CONTENTS
1) Cordless Saw
2) Battery
3) Charger
4) Instruction manual
•Do not expose the battery to extreme conditions such as high temperature or shock. Otherwise, it will
cause personal injury due to the leakage of the electrolytic solution.
•Before charging, check that the surface of the battery is clean and dry.
•The battery of this product is not fully charged on delivery. Therefore, before the first use, it must be
charged.
•Do not charge the battery for long periods of time. Do not completely drain the battery.
•Always keep in mind applicable safety instructions and protection requirements and environmental
legilsation.
•Check that the switch is in the off position.
•Connect the charger to the corresponding connector for the battery pack.
•Make sure the power is consistent with the rated values on the charger and adapter.
•When the red light is on the charger, it indicates that the battery is charging, and the green light
indicates that the charge is completed. The average charge time is 2 hours.
•When charging is complete, disconnect the battery pack from the power source.
•Ensure the battery it is recharged at least once every three months.
Operating Instructions
•Please wear suitable clothing and work gloves when using this equipment.
•Before each use, make sure the belt is running normally.
•Start/off switch and safety switch must be in working order.
•If the switch is damaged, stop using the device.
•Make sure the voltage of the power supply is consistent with the voltage on the rating label.
•The risk of injury can be reduced by wearing PPE and ensuring that the devices are functioning properly.
•In order to save the use of electric batteries and ensure the best service life do not cut wet and dry
branches over 60mm diameter and 20mm.
•When stopping operation, turn off the power switch and disconnect the battery box.
•When the device is running, keep your other hand at least 15cm away from the cutting area of the blade,
and kept well away from the blade.
•Do not force this equipment to cut bigger branches, otherwise the blade may deform or get stuck.
•In cold or humid weather, to protect the battery pack, put it under waterproof clothing, do not use this
equipment in the rain.
•We recommend that after daily use, battery pack should be disconnected, and the power switch (8)
turned off. The saw should be stored in the matching tool box.
•If the user feels the electricity is not strong enough or the cutting is not smooth enough, check if the
charge is exhausted or the blade is dull.
