Notes:
⚫Each time you use the detector in a different area, you must adjust DISCRIMINATION. Each search location
presents new challenges.
⚫Each time after you adjust DISCRIMINATION, you have to press the RED button on the handle to return
the meter pointer to 0 position.
⚫You can identify what kind of metal is detected according to the setting of DISC.
Note:
No detector is 100 percent accurate. Various conditions influence the detection. The detector’s reaction
depends on a number of things: the angle at which the target rests in the ground, the depth of the
target ,the amount of iron in the target, the size of the target, the soil condition etc. The above
indication is only tested in the air. Result in the ground may be varied
FALSE SIGNALS
Because your detector is extremely sensitive, trash-induced signals and other sources of interference might
cause signals that seem confusing. The key to handling these types of signals is to dig for only those targets
that generate a strong, repeatable signal. As you sweep the search coil back and forth over the ground, learn
to recognize the difference between signals that occur at random and signals that are stable and repeatable.
To reduce false signals when searching very trashy ground, scan only a small area at a time using slow, short
overlapping sweeps.
PINPOINTING A TARGET
Accurately pinpointing a target makes digging it up easier.
Accurate pinpointing takes practice, and we suggest you practice finding and digging up small metal objects
on your own property before you search other locations.
Sometimes, targets are difficult to accurately locate due to the sweep direction. Try changing your sweep
direction to pinpoint a target.
Follow these steps to pinpoint a target.
1. When the detector detects a buried target, continue sweeping the search coil over the target in narrowing
side-to-side motion.
Make a visual note of the exact spot on the ground where the detector beeps.
2. Stop the search coil directly over this spot on the ground. Then move the search coil straight forward away
from you and straight back toward you a couple of times.
Make a visual note of the exact spot on the ground where the detector beeps.
3. Repeat Steps 1-2 at a right angle to the original search line, making an “X” pattern. The target should be
directly below the “X” at the point of the loudest response.
