RF IN/ANT IN
VIDEO INPUT
1. Connect the composite output VIDEO out
of VCR/Cable receiver to AV1 & AV2.
2. Connect audio outputs (L, R) of a DVD player to the
audio input AV1and AV2 respectively.
3. Press the PLAY button on the VCR.
VGA AUDIO IN
AV OUT USB
YPbPr
AV 1 IN AV 2 IN YpbPr
1. The Aerial cable / IF Signal Cable should not be bundled to
- Connect RG-6 Cable in IF IN socket on rear of TV.
- For good operation of the set, angle of Reflector should
not be disturbed.
- Dont Disturb any Reflector connection unless & until advised
by authorised service person.
IF IN
COMPONENT (YCbCr/YPbPr) DVD INPUT
1. Connect the component outputs (YCbCr / YPbPr) of
DVD player to the component (YPbPr) input of the TV.
2. Connect audio outputs (L,R) of a DVD player to the
audio input component.
3. Press the PLAY button on DVD player.
Note :
1. While using component Source we need to provide
audio input through AV Source (L,R).
RF Antenna
Reflector
Connect Antenna cable to the RF IN / ANT IN socket on rear of the
TV For good operation of the set, good signal is required.
In the Strong area with the strong signal an indoor Antenna
A) RF Antenna Connection
B) DTH Reflector Connection
2. Installation of the Reflector & LNBF cabling must be done by
by authorised service person.
the power cord.
You can connect Antenna,external equipm
could be used but otherwise an outdoor Antenna
Note : Selecting a Source
Press TV/AV key on front panel keypad or SOURCE key on remote. A source OSD
will appear to select the required source navigate by pressing up/down key or Source
key repeatedly. After selecting the required source press “OK” key to confirm source.
4
